Audiovox MMD11, 128-8290 User Manual

MMD11

11" OVERHEAD LCD

MONITOR WITH

DVD PLAYER

OPERATION

MANUAL

128-8290

Important Notice

Installation of overhead products requires careful planning and preparation. Be extremely careful when working on a vehicle with side curtain air bags. Do not route

wires near any portion of the side curtain air bag assemblies. This includes any anchor points in A, B, C or D pillars of the vehicle. Routing wires in these areas or running wires by the side curtain air bags can prevent the side curtain air bag from fully deploying which can result in personal injury to vehicle occupants. If you have any questions regarding wire routing in a vehicle, please contact Audiovox Technical Support at 1-800-225-6074.

When connecting power and ground in a mobile video installation ensure that the ACC wire is fused at the point where it is connected to the vehicle ACC wiring. Failure to do so can result in damage to the vehicle if a short circuit develops between the vehicle connection point and the mobile video product.

An LCD panel and/or video monitor may be installed in a motor vehicle and visible to the driver if the LCD panel or video monitor is used for vehicle information, system control, rear or side observation or navigation. If the LCD panel or video monitor is used for television reception, video or DVD play, the LCD panel or video monitor must be installed so that these features will only function when the vehicle is in “park” or when the vehicle's parking brake is applied.

An LCD panel or video monitor used for television reception, video or DVD play that operates when the vehicle is in gear or when the parking brake is not applied must be installed to the rear of the driver's seat where it will not be visible, directly or indirectly, to the operator of the motor vehicle.

Licensed under one or more of the following patents, Patent NOS. 5,775,762 and 5,927,784

Warnings

u Do not use any solvents or cleaning materials when cleaning the video monitor. u Do not use any abrasive cleaners, they may scratch the screen. u Use only a lightly dampened lint free cloth to wipe the screen if it is dirty. u Lock the LCD screen in the fully closed position when not in use. u Before putting on headphones always adjust the volume setting to the lowest position. u Remember to leave the dome light switch in the off or auto positions when the vehicle is unattended, as the dome lights, if left

on, can drain the vehicle’s battery.

u Do not put pressure on the screen.

Congratulations

Congratulations on your purchase of the Jensen MMD11 DVD Player with Drop-Down Video / Monitor. The MMD11 has been designed to give you and your family many years of video entertainment in the mobile environment. Please read the directions that follow to familiarize yourself with the product to ensure that you obtain the best results from your equipment. Please note: Installation options vary, see the individual owner’s manuals for each component in your system to obtain a full understanding of each component’s operation.

Safety Precaution

For safety reasons, when changing video media it is recommended that the vehicle is not in motion, and that you do not allow children to unfasten seat-belts to change video media or make any adjustments to the system. System adjustments can be accomplished using the remote control, while seat-belts remain fastened. Enjoy your Audiovox entertainment system but remember the safety of all passengers remains the number one priority.

FEATURES

• 11" TFT (Thin Film Transistor) Active Matrix LCD (Liquid Crystal Display) Monitor

• Built-in DVD Player

• Multi-Lingual OSD (On Screen Display) for Control of

Picture Quality and Functions

• Infrared Transmitter for use with IR Wireless Headphones

• Three Audio / Video Source Inputs (DVD, AUX,AV1)

• Dome Lights with Built-in Three Way Switch

• Built-in 16 Channel Frequency Wireless FM Modulator

• Last Position Memory for DVD

• Screen Mode Selection (16:9, 4:3)

• Full Function Remote Control

• Backlit Controls

• AV Output

CONTROLS AND INDICATORS DIAGRAM (FRONT VIEW)

12345678

1. EJECT () Button

This Button is used for ejecting discs from the disc compartment when the source is DVD and the unit is powered up.

2. STOP (n) Button

This button is used to stop playback.

3. Source Select

Use to select one of the three sources: DVD, AUX,AV1.

4. Picture Select (+)

To increase the level of selected picture controls.

5. Picture Select Button

Allows the user to enter the picture adjustment mode.

6. Picture Select (–)

To decrease the level of selected picture controls.

7. FMM Source Select Switch

Used to select the frequency in sequence rotation: FM OFF, CH1 88.1MHz, CH2 88.3MHz, CH3 88.5MHz, CH4 88.7MHz, CH5 88.9MHz, CH6 89.1MHz, CH7 89.3MHz, CH8 89.5MHz, CH9 89.7MHz, CH10 89.9MHz, CH11 90.1MHz, CH12 90.3MHz, CH13 90.5MHz, CH14 90.7MHz, CH15 90.9MHz, CH16 91.1Mhz.

8. PLAY (u) Button

This button is used to start playback of a disc.

CONTROL FUNCTION DESCRIPTION (FRONT VIEW)

9. POWER ( ) Button

Used to turn the system on/off.

10. Dome Lights

Provide additional interior illumination.

11. Infrared Transmitter and Sensor

Transmits audio to optional wireless headphones. Also allows

the remote control to operate the MMD11 and to control other

accessories in the system.

12. Three Position Dome Light Switch

ON – Turns on the dome lights. OFF – The dome lights will not turn on in this position. AUTO – Automatically switches on the dome lights in

conjunction with the vehicle's interior illumination.

13. Ventilation Openings

CONTROL FUNCTION DESCRIPTION (SIDE VIEW & BACK VIEW)

Side View

1. DVD Disc insertion Slot

For loading and removing discs. Unit must be in a powered on state to load disc when disc is inserted. Insert disc with label side facing up.

14. LCD Cut Off Switch

Used to turn off the LCD panel monitor when in the closed position.

15. LCD Panel

16. Screen Release

Press to release the screen.

Back View

1 2 3

1. Auxiliary Video Input

2. Auxiliary Audio Left Input

3. Auxiliary Audio Right Input

REMOTE CONTROL OPERATION

Battery Installation

Before attempting to operate your Remote Control, install the batteries as described below.

1) Turn the Remote Control face down. Using your finger, slide the battery cover off in the direction of the arrow.

2) Install Two “AAA” batteries. Make sure that proper polarity (+ or -) is observed.

3) Align the cover tabs with the remote control and slide the cover until it locks.

The remote control will operate the MMD11. It is not a universal remote control and will not control equipment from other manufacturers.

MAIN FUNCTION DESCRIPTION

POWER

10 11

12 13

19 20

21 22

1 2

3 4

MONITOR SELECT

SOURCE

AUTO

MEMORY

SKIP/

ERASE/

WRITE

CHANNEL

FMM

SELECT

ON/OFF

RETURN DISPLAY

SUBTITLE

TVM2DVD

1 2

NIGHT

ON/OFF

REPEAT

DAY/

584

IRT

EJECT

VOLUME

PIX

MUTE

SETUP

ZOOMAUDIO

A-B

33 32

31 30

Function control is available on the unit and the remote control.

Function not available in this model.

POWER Button*

Press this button to turn the unit ON and OFF.

MONITOR SELECT M1 Button – M2 Button –

TV Mode Select Button**

Switches certain function keys on the remote control for TV functions.

DVD Mode Select Button

Switches certain function keys on the remote control for DVD functions.

SOURCE Button*

Each time the button is pressed, the audio / video source will change in the following sequence: DVD > AUX > AV1.

AUTO MEMORY Button (AUTO PROGRAM Button)**

When the AUTO MEMORY button is pressed, all channels are searched and channels that are detected with signals of sufficient levels are automatically stored in memory.

SKIP / SEARCH Button**

This button selects between SKIP and SEARCH mode. In "SKIP mode" the TV tuner will tune and stop on channels that are programmed into memory when the CHANNEL UP / DOWN buttons are used. When the SKIP mode is disable, the TV will stop on all active channels.

Sets the remote control code to allow control of the unit set to M1 mode only. Invalid function for this model

ERASE / WRITE Button**

While tuned to a channel, pressing this button will alternately store or erase the channel from memory.

FMM ON / OFF Button*

Turns the wireless FM Modulator on or off.

10.

CHANNEL SELECT Button*

Selects the wireless FM Modulator Frequency (CH1 88.1MHz, CH2 88.3MHz, CH3 88.5MHz, CH4 88.7MHz, CH5 88.9MHz, CH6 89.1MHz, CH7 89.3MHz, CH8 89.5MHz, CH9 89.7MHz, CH10 89.9MHz, CH11 90.1MHz, CH12 90.3MHz, CH13 90.5MHz, CH14 90.7MHz, CH15 90.9MHz, CH16 91.1MHz)

RETURN Button

11.

Press Return Once : Go to disc menu. Press Return Twice : Go to movies playback.

DISPLAY

12.

Press to display current disc information while the disc is playing. Press cursor (pq) buttons to select the Title or Chapter. For Title/Chapter selection use the numeric buttons to enter the desired Title Chapter selection.

13.

CURSOR / CHANNEL UP DOWN (pqtu) **

Use these buttons to navigate the menu selections on the screen. Use the CHp to increase the channel number and use CHq to decrease the channel number. **

14.

OK Button (ENTER)

Used to implement a selected setting or menu option.

15.

MENU Button

Allows the user to access the DVD menu (DVD MODE).

16.

REPEAT Button

Allows the user to repeat a selected title, chapter, or track.

AUDIO Button

17.

Press to display and select the available AUDIO languages in DVD mode. Each time you press the button, the language changes.

Note: The languages for audio vary from disc to disc.

18.

SUBTITLE Button

Press to display and select the available subtitle language in DVD mode. Each time you press the button, the subtitle language changes.

Note: The type and number of languages for subtitle vary from disc to disc.

19.

STOP (<) Button*

Press to stop playback.

20.

PREVIOUS (9) Button

Press to return to the previous chapter or track.

21.

SCAN BACKWARD (7) Button

Press to search in a backward direction. Press repeatedly to change the search speed from 2, 4, 8, and 16 times the normal speed.

PAUSE (II) Button

22.

Allows the user to pause the playback. Pressing pause again or pressing the Play Button will resume normal playback.

23.

PLAY Button*

Press to activate the play mode when a disc is loaded in the disc compartment.

SCAN FORWARD (8) Button

24.

Press to search in a forward direction. Press repeatedly to change the search speed from 2, 4, 8, and 16 times the normal speed.

25.

NEXT (:) Button

Press to skip to the next chapter or track.

+ 19 hidden pages