Audiovox LCM56 User Manual
LCM56
Headrest 5.6" LCD Monitor
Owner’s Manual
EXPLANATION OF GRAPHIC SYMBOLS
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO
NOT REMOVE COVER (OR BACK) NO SERVICEABLE PARTS
INSIDE REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL
The lightning flash with the arrowhead within a triangle is
intended to alert tell the user that parts inside the product
are
The exclamation point within a triangle is intended to alert
the user that important operating and servicing instructions
W ARNING:
TO PREVENT FIRE OR ELECTRIC SHOCK HAZARD, DO NOT
OPEN
CAUTION:
1. This product is designed to operate with a 12 volt, negative ground
battery system.
2. Disconnect the ground wire from the battery terminal before connecting the electrical system. Refer to the electrical connection diagram to
avoid wrong connection of the electrical system.
Always use authorized service center for service assistance.
3. Do not operate the monitor at temperatures below 32°F (0°C) or above
104°F (40°C).
4. Keep the monitor clean and dry.
5. Never attempt your own repairs. This unit should be installed and repaired by qualified technicians or service personnel..
6. Do not drop the monitor or expose to strong impacts.
7. Do not expose to direct sunlight for extended periods of time.
8. Use proper insulation material to prevent short-circuiting of the supply
system.
2
IMPORTANT
An LCD panel and/or video monitor may be installed in a motor vehicle
and visible to the driver if the LCD panel or video monitor is used for
vehicle information, system control, rear or side observation or navigation. If the LCD panel or video monitor is used for television reception,
video or DVD play, the LCD panel or video monitor must be installed so
that these features will only function then the vehicle is in ‘park’ or when
the vehicle’s parking brake is applied.
An LCD panel or video monitor used for television reception, video or
DVD play that operates when the vehicle is in gear or when the parking
brake is not applied, must be installed to the rear of the driver’s seat
where it will not be visible, directly or indirectly, to the operator of the
motor vehicle.
A. Precaution:
1. Before installation, verify that it will not damage electrical wires, fuel
lines, brake lines, hoses, exhaust systemcomponents or any other
items that will impair the operation of the vehicle.
2. Ensure the cable has already been pulled through the supporting
pipe before installing the base into the headrest. Ensure there is no
foreign material trapped inside the enclosure before installing the
monitor into the base.
3. Tighten all screws/bolts/nuts securely for installation.
4. To avoid electrical hazards, do not disassemble the cabinet of the
monitor.
5. Use only the supplied DIN cable. Disconnect the cable from the
signal source before disconnecting it from the monitor, after turning
off the whole system.
6. Do not use gasoline, thinners or other thinning liquids to clean the
unit. Remove dust and stains with a damp cloth.
3
B. Installation:
Front View
Top View
1.Installation will vary from vehicle to vehicle, as headrests in vehicles
are not standard.
2. This unit is intended for installation by professional installers.
3. The kit consists of the screen assembly, a clam shell housing, a trim
ring, 1 key to remove the screen from the housing, and a wiring
harness.
4
Loading...