Audiovox LCM0701TV User Manual
LCM0701TV
POWER
CHANNEL
SENSOR
Headphone
ON OFF AUTO
Owner’s Manual
SCREEN
MODE
VOLUME
Headphone
S
SELECT
TV
AUTO
PRO
Aux
VideoAudio LAudio R
V1
V2
Important Notice
It is unlawful in most jurisdictions for a person to drive a motor vehicle which is equipped with a
television viewer or screen that is located in the motor vehicle at any point forward of the back of the
driver’s seat, or that is visible, directly or indirectly, to the driver while operating the vehicle. In the
interest of safety, the LCM0701TV should never be installed where it will be visible, directly or indirectly,
by the operator of the motor vehicle.
Please note that the state of Rhode Island forbids the installation of such a device in a motor vehicle.
Television Reception
This entertainment system is designed primarily for viewing pre-recorded movies or playing video
games. Television reception in a moving vehicle will be limited and in some areas will not be possible
due to weak and variable signal strength. Television viewing in a stationary vehicle will result in an
improvement, but may still be marginal due to strength. The quality of the picture will not be consistent
with home TV reception. Reception may be affected by the weather and distance from the TV station. A
weak signal may cause the picture to roll, be snowy, or cause some color loss.
Congratulations on your purchase of the Flexvision LCM0701TV drop down TV/Video monitor. The
LCM0701TV has been designed to give you and your family many years of video entertainment in the
mobile environment. Please read the directions that follow to familiarize yourself with the product and to
ensure that you obtain the best results from your equipment. Please note: Installation options vary, see
the individual owner’s manuals for each component in your system to obtain a full understanding of
each component’s operation.
Safety Precaution
For safety reasons, when changing video tapes it is recommended that the vehicle is not in motion, and
that you do not allow children to unfasten seat belts to change tapes or make adjustments to the system.
System adjustments can be accomplished using the remote control unit, while seat belts remain
fastened. Enjoy your Flexvision entertainment system but remember- safety of all passengers remains
the number one priority.
FEATURES
• 7” TFT (Thin Film Transistor) Active Matrix LCD (Liquid Crystal Display) Monitor
• OSD (On Screen Display) for control of Picture Quality and Functions
• Screen Mode 16:9 or 4:3
• Full Function Remote Control
• Television Tuner
• Plug in RF Transmitter for wireless RF Headphones
• Remote Sensor eye
• Four Audio / Video Sources
• Headphone / Speaker Amplifier
• Two Headphone Jacks for Wired Headphones
• Built-In Dome lights
• Back-lit Controls for Low Light Operation
FRONT PANEL FEATURE
POWER
CHANNEL
Headphone
ON OFF AUTO
5
6
3
7
11
12
4
2
Figure 1
1
8
10
9
SCREEN
MODE
VOLUME
S
SELECT
AUTO
PRO
TV
V1
V2
SENSOR
Aux
Headphone
VideoAudio LAudio R
FRONT PANEL FEATURES – See Figure 1
1. Power Button- (Bright red when system is ON, dim when system is OFF)
2. Screen Mode- Used to select screen 16:9 or 4:3.
3. Channel Up/Down- Changes the TV channel
4. Volume Up/Down- Controls volume to headphone jacks and external speakers if connected.
5. Auto Pro Switch- Auto Program used to program local channels into TV memory. Press when
vehicle is in a new location.
6. Source Select- Used to select one of the three A/V sources. The fourth source is plugged into the
RCA jacks on the rear of the unit. V2 must be selected once something is plugged into the external
jacks it over rides the previous source on V2.
7. Sensor Eye- Allows the remote control to operate the LCM0701TV’s OSD system (On Screen
Display), volume to wired headphone jacks (and optional external speakers), and for control of Video
Cassette Player and other accessories.
8.
8. Three Position Dome Light-
• Auto- Will automatically switch on the dome lights in conjunction with the vehicle’s interior
illumination. For the automatic position, shift the switch to the right.
• OFF- The dome lights will be off in the middle position.
• ON- The switch must be in the left position for the dome lights to turn on.
9. Dome Lights- Provide additional interior illumination
10. Screen Release- Slides in the direction of the arrow to release the drop down screen.
11. Headphones Jacks- Allows plug-in of two wired headphones with 1/8” stereo plug.
12. Auxillary A/V Stereo Input- Allows plug-in of Camcorder, game, portable DVD player or other A/V
source with RCA type output connectors. V2 must be selected. Plugging into this input over rides
the previous source on V2.
REMOTE CONTROL OPERATION
BATTERY INSTALLATION
Before attempting to operate your Remote Control, install the batteries as described below.
1) Turn the remote control face down. Press down on the ridged area of the battery cover, and slide it
off.
2) Install two “AAA” batteries as shown. Make sure that proper polarity (+ or -) is observed.
3) Slide the cover back until it clicks into position.
The remote control will operate the LCM0701TV, Flexvision Televisions and Video Cassette Players. It
is not a universal remote control and will not control equipment from other manufacturers.
If a universal remote control is used with the LCM0701TV, choose the remote control encoding scheme
for Action Televisions when programming the remote.
Loading...