Audiovox K-9 User Manual

ASA Electronics TV/VCP Floor Console

Model K-9 With out Harness and Antenna

12 Volt DC powered remote controlled 9” television AVT-975
12 Volt DC powered remote controlled VHS Video Cassette Player AVP-7000

Installation Instructions

Audiovox Specialized Applications, LLC

23319 Cooper Drive

Elkhart IN 46514

1 [phone]

www.audiovox.com

Page 1 of 10

P/N 8007132

REV. B BJ

This manual contains specific instructions on how to install this automotive TV/VCP
floor console. Please read this manual thoroughly before installing the console into
the vehicle.

**WARNING**

In order to maintain a safe mounting system, this console MUST be secured to
the floor of the vehicle according to the instructions contained in this manual.
Failure to do so may result in the console breaking loose in the event of an
accident.
It is unlawful in most jurisdictions for a person to drive a motor vehicle which
is equipped with a television viewer or screen that is located in the motor
vehicle at any point forward of the back of the driver’s seat, or that is visible,
directly or indirectly, to the driver while operating the vehicle. This product
should only be installed to the rear of the driver’s seat where it will not be
visible, directly or indirectly, to the operator of the motor vehicle.

Required tools for installation:

Electric drill
¼” steel drill bit
1/8” steel drill bit
Phillips screwdriver
Socket wrench set with deep-well, 7/16” socket
Box end wrench, size 7/16”
Soldering Iron

Two people are required for installation.

0892105 Bracket Kit 1

8007101 Bracket, Mounting 4
8007105 Screw, Hex #8x3/4 self drilling 20
8007106 Washer, 3/16” 20
8007110 Strap, Open, Nylon 1
8007111 Strap, Loop, Nylon 1
8007125 Bolt, ¼”x1 ½”, Hex 4
8007126 Washer, Fender 5/16” 4
8007128 Nut, Nylon Insert ¼” 4
8007132 Installation Manual 1

P/N 8007132

Page 2 of 10

Rev. B

There are six (6) steps to install the K-9 TV/VCP floor console:

Step # 1 Remove face of the console
Step # 2 Install brackets and the straps
Step # 3 Install console to the floor of the vehicle
Step # 4 Install VCP
Step # 5 Install TV
Step # 6 Replace console face

STEP #1 REMOVE THE FACE OF THE CONSOLE

⇒ Remove 4 Phillips screws securing face of console to body of console.
⇒ Set screws and face aside. Take care that screws do not get lost.

1) Disassemble shroud.

P/N 8007132

Page 3 of 10

Rev. B