Audiovox IM-300, IM-200 User Manual

DIN MOUNTING (EXAMPLE:VOLKSWAGON) SEE FIG. 1

1. Verify opening is within following dimensions: A. Height 52mm- 53mm (23/64" -23/32")

B. Width 182mm -184mm (75/32" -71/4")

2. If opening is less, carefull file to exact size required (DO NOT OVER FILE).

3. Remove din sleeve from radio and place into opening.

4. Bend tabs outward to lock sleeve into dash.

rFjG:1l .~ ~ --USE EITHER BUSHING I rlu. I I 11;r'.../ OR PERFORATED STRAP

@ TO SUPPORT REAR OF RADIO

.1 \LJ

5. Pre-wire radio. Slide radio into din sleeve until it locks into place. Note: Use either rear bushing

or perforated strap to secure rear of radio.

RADIO REMOVAL (IF NECESSARY)

1. Unsnap trimring on face of radio.

2. Insert removal tool in slotted holes on sides of radio until bottomed. Spread tools outward slightly

and pull radio toward you. Remove tools and slide radio fully out.

) ~

BEND TABS

OUTWARD

..".J

DASH PANEL

.;J-

DIN SLEEVE

~ADIO REMOV ~ """' ~

/ ~(

-~~

:.,.( APPLY SLIGHT

REMOVAL TOOL

QUICKIE BOL T /'

l ~~

'"""

TRIMRING

~ ~' (J(~ ~~ ~II ~lY A (;AO7

1..., j ~

~@~ I;/

TRIMBEZEL (INSTALLED ON RADIO)

FACTORY STYLE INSTALLATION (EXAMPLE:TOYOTA) SEE FIG.2:

1. Remove factory radio dash panel to expose sub-dash.

2. Remove radio bracket assembly from sub-dash.

3. Remove and discard radio dummy panel attached to factory radio bracket assembly.

4. Install radio Into bracket assembly using special

screws included with radio (see fig. 2) CAUTION: Do not use longer screws or damage to Internal parts of radio may occur

5. Re-Install radio / bracket assembly after wiring radio.

6. Replace dash panel.

RADIO REMOVAL (IF NECESSARY)

1. Reverse installation procedure.

SHORT SCREWS {INCL. w/RADIO)

FACTORYBRACKET/POCKETASSEMBLY

IM100/IM200/IM300RADIO

./'t.

"""'

..".,..

...

NOTE: IN SOME CASES IT WILL BE NECESSARY TO BREAK OFF

"" " THE SMALL PLASTIC TABS ON MAP

~ POCKET IF THEY PREVENT FLUSH

:--

tJ/

FITTING OF RADIO

..-/ )1

~I;