Audiovox HR7008APKG, HR7008A User Manual

HR7008APKG

Two Custom Vehicle Headrests

with 7” LCD Monitors Touch Screen Control

and Built-in

DVD Player for Rear Entertainment

AUX AUX

OPERATION

MANUAL

128-8466

IMPORTANT

An LCD panel and/or video monitor may be installed in a motor vehicle and visible to the driver if the LCD panel or video monitor is used for vehicle information, system control, rear or side observation or navigation. If the LCD panel or video monitor is used for television reception, video or DVD play, the LCD panel or video monitor must be installed so that these features will only function when the vehicle is in “park” or when the vehicle’s parking brake is applied.

An LCD panel or video monitor used for television reception, video or DVD play that operates when the vehicle is in gear or when the parking is not applied must be installed to the rear of the driver’s seat where it will not be visible, directly or indirectly, to be operator of the motor vehicle.

Licensed under one or more of the following patents: Patent NOS. 7,245,274 and 6,899,365

HR7008APKG

The HR7008APKG contains two vehicle specific head-rests. Each has a 7” Monitor with touch screen control and built-in DVD Player. This system allows the users to either watch individual DVD’s or watch the same DVD on both monitors. Both users can also share each others program. The full function remote control can operate either unit by selecting M1 or M2 on the remote.

Quick Start Guide

1. Turn on the M1 monitor, to gain access to the DVD slot push at the top center of the screen frame, the screen will tilt forward.

2. Insert a DVD, CD or MP3 disc into the slot, disc label toward driver. Push down gently on the disc until the player pulls the disc in.

3. Use the touch screen to access the DVD mode.

4. Tilt the monitor to a comfortable viewing position (the headrest itself can be tilted forward to help achieve a comfortable viewing position).

5. Each wireless headphone has a CH A/CH B switch. Turn the volume down to its lowest setting before putting them on your head. When sitting in front of the M1 screen, use the CH A switch setting. When sitting in front of the M2 screen, use the CH B switch setting. Set the headphone to the proper channel and press the Power On/Off switch. The power indicator will light up red.

6. When the DVD menu appears, select the menu item using the cursor keys and touch the OK or play button.

7. If audio playback through the vehicle radio is preferred, use the FM transmitter On/Off button on the remote control. Set the vehicle radio to the channel selected on the M1 monitor. If interference with a local radio station occurs, set the FM modulator to one of the other 15 radio frequencies using the CHANNEL SELECT button on the remote control.

8. Turn on the M2 Monitor using the power button on the front of the screen or remote control.

9. Tilt the screen to a comfortable viewing position (the headrest itself can be tilted forward to help achieve a comfortable viewing

position).

10. Touch the screen and touch on M1 or use remote control to press SOURCE button to view program from M1 or select from the other

available sources DVD, MEMORY CARD, USB, AV, AUX and MEDIA for M2 Monitor.

NOTE: To operate the M1 screen, press M1 on the remote control.

To operate the M2 screen, press M2 on the remote control.

HR7008APKG SYSTEM OVERVIEW

1) The HR7008APKG SYSTEM is a versatile headrest system. The headrests are referred to as M1 and M2 in this manual.

2) The M1 Monitor is comprised of a 7" Touch Screen TFT LCD monitor with built-in DVD player that allows the user to select from several sources (DVD,

SD, USB, M2, AV, AUX, MEDIA and GAME Source). The M1 monitor has a built-in infrared audio transmitter channel (CH A) for use with the twochannel wireless headphones (CH A) NOTE: When the DVD menu appears on the screen, touch the desired DVD menu selection to start the DVD playing. Refer to page for 6 operation.

3) The M2 monitor is comprised of a 7" Touch Screen TFT LCD monitor with built-in DVD player that allows the user to select from several sources (DVD,

SD, USB, M1, AV, AUX and MEDIA Source). The M2 monitor has a built-in infrared audio transmitter channel (CH B) for use with the two-channel wireless headphones (CH B). NOTE: When the DVD menu appears on the screen, touch the desired DVD menu selection to start the DVD playing. Refer to page for 6 operation.

4) The monitors will display all of the functions with the comprehensive Graphical User Interface (GUI) and can be accessed using the touch screen.

5) The two-channel wireless headphone sets have an A-B switch that allow the users to select the audio from either the M1 (CH A) or the

M2 (CH B).

6) When using the IR remote control, the M1 Monitor will only respond to the remote control unit when the Monitor Select (M1) button on remote control is

pressed. The M2 Monitor only respond to the Remote Control unit when the Monitor Select (M2) button on remote control is pressed.

7) Optional wired headphones allow the user to listen to audio from the system.

8) The M1 and M2 Monitor will accept an audio / video input through the 1/8” jack located on the front of the unit. The audio / video device could be a video

game system, video camera or other input device.

HR7008A M1/HR7008A

AUX

WIRED HEADPHONE

TOUCH SCREEN GRAPHICAL USER INTERFACE (GUI)

AUX

USB

9) Press and release the screen at the top of the screen to release the screen for disc insertion. The headrest itself can be tilted forward to help achieve a comfortable viewing position. Pressing it again will lock the screen back in the closed position.

PULL UP

10) Insert/Eject disc and SD Card

Insert/Eject Disc

Insert/Eject

SD Card

WIRED HEADPHONE

19 Degrees

PUSH IN

AUX

USB JACK

Inner Ring

Hook

Shaft Angle

Closed Position

19 degrees

HR7008APKG Touch Screen

The touch screen of the HR7008APKG allows the user to start DVD play by touching PLAY MOVIE or any of the DVD menu features on the LCD screen.

Some DVD’s will not allow this function. One method is to use the remote control instead of the touch screen. The other method is to touch any of four corners of the screen to pop up the DVD menu navigation screen (below)

Use the up/down/left/right icons to select an item from the DVD menu. Use the Enter to start DVD play.

CONTROLS AND INDICATORS DIAGRAM

Control Function Description for M1 and M2 Monitor

M1/M2 Panel Control

1. DVD disc insertion slot.

2. EJECT Button -Press this button to eject the disc.

3. SD Card Reader

4. MENU/POWER Button with Power Indicator LED.

5. Wired Headphone Jack

6. IR Transmitter LEDS.

7. USB Port

8. AUX Jack

9. IR Sensor

10. Graphical User Interface (GUI) Touch Screen

AUX

Touch Screen For HR7008AM1/M2

Main Page

Turn on the unit by pressing the power button located on The lower left of the unit. I) Touch the panel then touch the Home icon to display the Main Menu. The Main Menu can also be accessed by pressing the MENU button on the unit’s front panel. ii) The Main Menu screens for M1 and M2 contains the following icons:

Main Menu

DVD

MEMORY

CARD

Main Menu

USB

MEMORY CARD

Insert Memory Card / SD Card into SD CARD slot. Touch the Main Menu MEMORY CARD icon to set unit’ source to SD.

USB

Insert the USB to the USB Slot. Touch the Main Menu USB icon to set the unit’s source to USB.

Touch the Main Menu M2 icon on the M1 unit to link the M1 unit to the M2 unit. The M1 unit will now receive its AV from M2.

Touch the Main Menu M1 icon on the M2 unit to link the M2 unit to the M1 unit. The M2 unit will now receive its AV from M1.

M1 Unit

MEDIA

GAMEAUX

DVD, MEMORY CARD, USB, M2, AV, AUX, MEDIA, GAME, PIX,

PIX

SCREEN

OFF

MUTE

FMM

SCREEN OFF, MUTE, FMM.

Main Menu

M2 Unit

DVD

MEMORY

CARD

USB

DVD, MEMORY CARD, USB,M1, AV, AUX, MEDIA, PIX, SCREEN OFF, MUTE

SCREEN

PIX

OFF

MEDIA

MUTE

GAMEAUX

FMM

DVD

Touch the Main Menu DVD icon to set the source to DVD. Then insert the DVD into slot with label face toward driver. Gently push down on the disc and the disc will load automatically.

Touch the Main Menu A/V icon to route external audio and video supplied to the system’s AV IN RCA connectors. NOTE: May not be available on all installations. Contact your dealer for more information.

AUX

Touch the Main Menu AUX icon to route external audio and video supplied to the unit via the cable adapter.

MEDIA

Touch the Main Menu MEDIA icon to select the MEDIA display.

GAME

Touch the Main Menu GAME icon on (for M1 only). The GAME selection is controlled by wireless game controller.

PIX

Touch the Main Menu PIX icon to gain access to the display’s picture controls. The controls available are BRIGHTNESS, CONTRAST, COLOR, TINT and RESET.

Adjustment of each control is made by touching + (increase) or

- (decrease), then touch (enter) to exit.

PIX

COLOR 16

The on screen DVD menu of most DVD’s can be used to select a DVD menu feature such as “Play Movie”, “Scene Select”, etc. by touching the menu item on the touch screen. For example, touching “Play Movie” in the below screen will start movie play.

Play Movie

•

Scene Select

•

Extras

Audio

•

COLOR 16

ETC

•

NOTE: A small number of DVD discs will not function like this. In

that event use the remote control to start the movie or select the different DVD options.

MUTE

Touch the Main Menu MUTE icon to toggle the unit’s audio between on and off.

SCREEN OFF

Touch the Main Menu SCREEN OFF icon and the screen will shut off. Touch the screen again to turn it back on. The screen will turn back on after cycling power.

FMM

Touch the Main Menu FM MODULATOR icon (For M1 only) to gain access to the FM Modulator controls

To turn on FM Modulator touch +or - icon, then select the FM modulator transmission frequency by touching - (decrease) or + (increase) [88.1MHz ~ 91.1MHz]. Touch (enter) to exit. Set the vehicle radio to the selected frequency to listen to the movie over the vehicle sound system.

OFF

FMM 88.1 MHZ

To turn off the FM Modulator function, touch OFF icon. Then touch (enter) to exit.

+ 19 hidden pages