Electrical Parts List ............................................................................................................................................ 5
Voltage Chart ................................................................................................................................................... 11
IC Block Diagrams & IC Pins Description ........................................................................................................ 13
Many electrical and mechanical parts in this chassis have special safety characteristics.
These safety characteristics often pass unnoticed and the protection afforded by them cannot
necessarily be obtained by using replacement components rated for higher voltage, wattage, etc.
Replacement parts that have these special safety characteristics are identified in this manual
and its supplements; electrical components having such features are identified by
schematic diagram and the parts list.
Before replacing any of these components, read the parts list in this manual carefully.
The use of substitute replacement parts that do not have the same safety characteristics as
specified in the parts list may create shock, fire or other hazards.
in the
+
SPECIFICATIONS
15 mW + 15 mW at 16
to 32
Design and specifications are subject to change without notice.
General
Compact disc digital audio system
• Digital filter two-time oversampling
• Three-spot optical pick up
Output (at 1kHz 0dB Level) Line output (stereo minijack)
Output level 0.4V(Rms) at 47K at 1kHz
Headphones/earphone (stereo minijack)
Ω
Power requirements2 size AA (LR6 or SUM-3) alkaline batteries, or DC IN 6V,
450mA power adaptor
Polarity of plug
DimensionsApprox. 128 x 31 x 137 mm (w/h/d)
WeightApprox. 205g (not incl.batterries)
Operating voltage:
U.S.A., Canada:Middle East and Australia:UK and Germany:
120V AC ± 5% 60Hz240V AC ± 5% 50Hz230V AC ± 5% 50Hz
Chile:Singapore, Malaysia & Thailand:Japan:
230V AC ± 5% 50Hz200-240V AC ± 5% 50Hz100V AC ± 5% 50/60Hz
Ω
Ω
3
4
: AC - DC Adaptor
GENERAL TEST CONDITION
PERFROMANCE SPECIFICATIONS
LINE OUT
Frequency Response (1kHz, 0dB)
PLAYABILITY TESTING
5. Eccentricity(A. Bex TDC-732)µm
150
0.6
0.6650.5
TEST ITEMS
EARPHONE OUTPUT
TEST ITEMS
TEST ITEMS
LIMIT
Power Supply
Lineout Load: 47Kohm
Headphone Output: 16ohm or 32ohm
Reference Output: 5mW
Input Signal Source: CBS SONY YED7 (PTD-001) SONY
1. 10% THD Output Power (1kHz, 0dB) (16 or 32ohm)mW-15
*2. Signal to Noise Ratio (1kHz)dB7670
*3. Channel Separation (1kHz, 0dB)dB5545
*4. Total Harmonic Distortion 1kHz%0.31
5. Bass Boost Measured Signal is 0dB at 100Hz,dB8+3-2
Where Output Power is 5mW & Down by 20dB at 32ohm LoadingdB
6. Frequency response (1kHz, 0dB) 100HzdB±1±3
10kHzdB±1±3
20kHzdB±3±6
100V: 6V DC 60Hz Battery:3V (AA x 2)
120V: 6V DC 60Hz
230V: 6V DC 50Hz
UNIT NOMINAL LIMIT
*with External A Filter
UNIT NOMINAL LIMIT
1. Output (1kHz, 0dB) 47kohmVrms0.60.5
*2. Signal to Noise Ratio (1kHz, 0dB)dB8276
*3. Channel Separation 1kHzdB7060
*4. Harmonic Distortion 1kHz%0.20.3
5. Dynamic RangedB7670
6. De-emphasis 16kHz Signal with Emphasis Recording (-9.04dB as 0dB)dB0±1
5kHz Sgnal with Emphasis Recording (-4.53dB as 0dB)
7. Channel Balance (1kHz, 0dB)dB0.51
8.
10kHzdB±1±3
1. Interruption(PHILIPS SBC-444A)mm
2. Black Dot(PHILIPS SBC-444A)mm
3. Finger Print(A. Bex TCD-725)µm
4. Vertical(A. Bex TDC-731A)mm
100HzdB±1±3
20kHzdB±3±6
UNIT
5
240,241,310(EMK212F105ZG-T) (MCH213F105ZP)
ELECTRICAL PARTS LIST
Ref. No.DescriptionMfr's Part No. Qty.
MAIN BOARDPCB CDM52-01-01 122x199x0.8mm/2 (FR4)033-0CDM52-1001
DOUBEL-SIDED
CONTROL BOARDPCB CDM52C-01-02 125x176x1.0mm/12 (94HB)033-CDM52C-1001