Audiovox D1988 User Manual

D1988

PORTABLE 9" LCD MONITOR AND

DVD PLAYER WITH BUILT-IN BATTERY

An LCD panel and/or video monitor may be installed in a motor vehicle and visible to the driver if the LCD panel or video monitor is used for vehicle information, system control, rear or side observation or navigation. If the LCD panel or video monitor is used for television reception, video or DVD play , the LCD panel or video monitor must be installed so that these features will only function when the vehicle is in “park” or when the vehicle’s parking brake is applied.

An LCD panel or video monitor used for television reception, video or DVD play that operates when the vehicle is in gear or when the parking brake is not applied must be installed to the rear of the driver’s seat where it will not be visible, directly or indirectly, to the operator of the motor vehicle.

Notice:

This Product incorporates copyright protection technology that is protected by method claims of certain U.S. Patents and other intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be authorized by Macrovision Corporation, and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision Corporation. Reverse engineering or disassembly is prohibited.

Content

A. Introduction ............................................................................ 4

B. Cautions and Warnings ........................................................ 4

C. Contents ............................................................................... 6

D. Powering and installation ..................................................... 6

E. Controls, Indicators, and Connectors ................................... 7

F. Loading and Playing a Disc .................................................. 8

G. Basic Operation...................................................................... 9

H. Menu .................................................................... 10

I. Display ................................................................................... 10

J. Playing Audio CDS................................................................ 13

K. Playing MP3 Discs .......................................................... 17

L. Connecting to other Electronic Equipment.......................... 19

M. Playing JPEG Files........................................................... . 20

N. Setup .................................................................................... 21

O. Specifications ...................................................................... 29

P . Rechargeable Built-in Battery use........................................ 29

Q. Troubleshooting ................................................................. 31

A. Introduction

Thank you for choosing the D1988 portable DVD player. The main features include a 9" wide Screen (16:9 Aspect Ratio) Liquid Crystal Display (LCD) monitor and a DVD player. The unit also contains a 3 in 1 card reader and a USB port. The unit is designed for use with SD/MMC, MS memory cards and USB memory devices. The unit applies the latest state of the art electronics and is designed for use in hotels, offices or your home. The unit is constructed to provide years of reliable, trouble-free service and is compact so that you can take it with you anywhere and is designed for quick and easy installation. Please read the entire instruction manual supplied with this product prior to using. The documentation will assist you in using the system properly to obtain the best equipment performance. Please save this manual for later use.

B. Cautions and Warnings

1. Placement

To prevent fire or electric shock, do not expose this unit to rain or moisture. Keep the unit away from strong magnets, heat sources, direct sunlight, excessive dust. If the unit is brought directly from a cold to a warm location, moisture may condense inside the unit. When you move the unit from a cold to a warm location, wait for about one hour before operating the unit, or remove the disc and leave the unit turned on until the moisture evaporates.

2. Installation

Ensure that the 9” portable DVD player is used in accordance with the instructions and illustrations provided in this manual.

3. Caution

Do not push objects of any kind into the unit through openings; do not spill or spray liquid of any kind on or in the unit (this may result in a fire or electric shock). Do not place anything heavy on the unit. To ensure proper ventilation and proper operation, never cover

or block the slots and openings with a cloth or other material. Keep the unit away from an open flame such as fire, candle etc. It is hazardous to replace the battery with one that is not designed for the DVD player. Replacement batteries must be the same model in order to prevent damage to the DVD player or the battery. In order to protect the environment, please dispose the battery properly. Do not use the unit in temperatures higher than 95 degrees Fahrenheit or 35 degrees Celsius. The AC power cord supplies power to the unit. The cord must be kept in good condition to prevent personal injury or property damage.

4.Disassembly

Do not attempt to disassemble the unit’s case. There is a risk of electric shock and/or exposure to Laser Radiation. Contact qualified service personnel if your system needs repair.

5. Cleaning Unit

When cleaning, make sure the system is unplugged from the power source. Do not use liquid cleaners or aerosol cleaners. Use a cloth lightly dampened with water for cleaning the exterior of the system only .

6. Disc

Do not use irregularly shaped discs such as heart or star-shaped discs as they may cause the unit to malfunction. Do not stick paper, tape or glue on the disc. Do not expose the disc to direct sunlight or heat sources. Do not touch the surface of disc. Handle the disc by its edge. Clean the disc by wiping the disc from the center out with a clean cloth. Remove the disc from the unit and store it in its case after playing. Some playback operations of discs may be intentionally fixed by software producers. Since this unit plays discs according to the disc contents the software producers designed, some playback features may not be available. Also refer to the instructions supplied with the discs.

C. Contents

1. 1 x 9’’ LCD Monitor and DVD Player

2. 1 x Remote Control with battery (CR2025)

3. 1 x Audio/Video Adapter Cable

4. 1 x AC to DC Adapter

5. 1 x DC Power Adapter

6. 1 x Instruction Manual

D. Powering and installation

1. Powering the system indoors (Refer to Figure 1) Plug one end of the AC to DC adapter into the DC input jack on the left side of the main unit, then plug the other end into the 100~240V AC power receptacle.

2. Powering the system in a car

Plug one end of the DC Power adapter into the DC input jack on

the unit, then plug the other end into the vehicle power outlet.

Figure 1

3. Built-in Battery

Plug one end of the AC to DC adapter into the DC jack on the side of the player, then plug the other end into the 100~240V AC power outlet. Make sure the player is in the “Power Off” mode. Once fully charged, the LED indicator will turn off. Once the indicator is off, remove the AC to DC adapter wall plug.

NOTE: Your new battery must be charged a minimum of 8 hours be-

fore the first usage. Each full recharge takes approximately five hours and one full charge can provide power to the player for approximately 2 hours.

E. Controls, Indicators, and Connectors

1. Unit View (Refer to Figure 2)

5 6

O F F    

   O N

11 12

13 14

Figure 2

1) SD/MMC/MS Card Slot

2) Power LED

3) Remote Control Sensor

4) Cover Open Switch

5) DC 9V Input JackPower

6) AV Jack

7) AV In/Out Switch

8) USB Port

9) ON/OFF Switch

* Connecting to headphone jack number 1 will disable the internal speakers

10) LCD Panel Shut Off Switch

11) Wide Button

12) Previous/Next/Pause/Stop/Play Button

13) Menu Button

14) Up/Down/Left/Right/OK Button

15) Charge Indicator

16) Headphone Jack 1*

17) Headphone Jack 2

18) Volume Up/Down Control

19) Brightness Up/Down Control

16 17

18 19

2. Remote Control (Refer to Figure 3)

1) Setup Button

2) Up Button

3) Skip - Button

4) Enter Button

5) Reverse/Left Keypad

6) Down Button

7) Numeric Buttons

8) Display Button

9) Zoom Button

10) DVD/SD-USB Button

11) Skip + Button

12) A-B Repeat Button

13) Forward/Right Keypad

14) 1/All Repeat Button

15) Stop Button

16) Menu Button

17) Subtitle Button

18) Audio Button

19) Play/Pause Button

Figure 3

F. Loading and Playing a Disc

a. After connecting power to the unit, power on the DVD player with

the power switch. The power indicator will light.

b. Open the disc tray by sliding the OPEN switch in the direction of

the arrow. Place a disc in the tray with label side facing up.

c. Close the tray by pressing the area marked “PRESS” . The unit will

load the disc and start playing.

d. Rotate BRIGHTNESS and VOLUME to adjust the LCD’s bright-

ness and the DVD player’s volume.

e. To stop playing a disc, press STOP. f. To turn off the DVD player, slide the POWER ON/OFF switch to

OFF.

G. Basic Operation

POWER OPEN P AUSE STOP

PLA Y Skip + NEXT

Skip - PREVIOUS

FORWARD

REVERSE

LEFT/RIGHT/UP/DOWN

ENTER NUMBERS MENU REPEAT A-B

DISPLA Y

SUBTITLE

AUDIO SETUP

WIDE

Turn the unit on/off Remove/load the disc Press to pause play and again to re-start play . Press once to stop and restart at the stop point Press twice to stop and restart at the beginning of the disk Start Play/Execute item or setting Go to the next chapter, track or scene during play back Go back to the previous chapter, track or scene during play back Scan forward at 2, 4, 8,16 or 32 times speed Scan backward at 2, 4, 8, 16 or 32 times speed Used for Menu Navigation Execute item or confirm setting Select item or setting Display the root menu of the disc Repeat playing title, chapter, or track Repeat a specific portion from point A to point B of the disc Display information (title, chapter, track, time, etc.). Select the subtitle language and turn it on/off Select the audio language Display the setup menu to select and set items, and exit the setup menu. On the DVD player only: change between wide screen and 4:3 picture aspect ratio.

H. MENU

A DVD is divided into sections called titles and chapters. When you play a DVD, a root menu of the disc will appear on the screen of your TV or Monitor. The contents of the menu vary from disc to disc. Press ‘MENU’ during playback to display the menu. Some DVDs only allow you to select disc playback options using the DVD root menu.

I. DISPLAY (Display contents vary from disc to disc.)

1. PLAYING TIME AND REMAINING TIME

a. During playback press the ‘DISPLAY’ button to display the cur-

rent Title Number (1), the total Number of Titles (2), the current Chapter Number (3), the total Number of Chapters (4), and the elapsed playing Time for the title (5). The heading will disappear automatically after 3 seconds if no buttons are pressed.

Title, Chapter Number and Time Screen Display

b. Press ‘DISPLA Y’ again to display the Remaining T ime of the title.

The heading will disappear automatically in 3 seconds.

Title Remaining Time Screen Display

c. Press ‘DISPLA Y’ a third time to display the Elapsed Time for the

chapter. The heading will disappear automatically in 3 seconds.

Chapter Elapsed Time Screen Display

d. Press ‘DISPLA Y’ a fourth time to display the Remaining T ime for

the chapter. The heading will disappear automatically in 3 seconds.

Chapter Remaining Time Screen Display

e. Press ‘DISPLAY’ a fifth time to exit, ‘DISPLAY OFF’ will be dis-

played and will disappear automatically in 3 seconds.

+ 23 hidden pages