Audiovox D1888 User Manual
D1888
8” LCD MONITOR, DVD PLAYER
WITH BUILT-IN BATTERY
Notice:
This Product incorporates copyright protection technology that is
protected by method claims of certain U.S. Patents and other
intellectual property rights owned by Macrovision Corporation and
other rights owners. Use of this copyright protection technology must
be authorized by Macrovision Corporation, and is intended for home
and other limited viewing uses only unless otherwise authorized by
Macrovision Corporation. Reverse engineering or disassembly is pro-
hibited.
Notice:
An LCD panel and/or video monitor may be installed in a motor
vehicle and visible to the driver if the LCD panel or video monitor is
used for vehicle information, system control, rear or side observation
or navigation. If the LCD panel or video monitor is used for television
reception, video or DVD play, the LCD panel or video monitor must
be installed so that these features will only function when the vehicle
is in “park” or when the vehicle’s parking brake is applied.
An LCD panel or video monitor used for television reception, video or
DVD play that operates when the vehicle is in gear or when the
parking brake is not applied must be installed to the rear of the driver’s
seat where it will not be visible, directly or indirectly , to the operator of
the motor vehicle.
2
A. Introduction
Thank you for selecting the D1888 portable DVD player. The main
features include a 8" Screen (16:9 Aspect Ratio) Liquid Crystal
Display (LCD) monitor and a DVD player. The unit applies the latest
state of the art electronics and is designed for use in hotels, offices
home or vehicle. The unit is constructed to provide years of reliable,
trouble-free service, and is compact so that you can take it with you
anywhere and is designed for quick and easy use. Please read the
entire instruction manual supplied with this product prior to
operation. The documentation will assist you in installing the system
properly to obtain the best equipment performance. Please save this
manuals for later use.
B. Cautions and Warnings
1. Placement
To prevent fire or electric shock, do not expose this appliance to
rain or moisture. Keep the unit away from strong magnets, heat
sources, direct sunlight, excessive dust. If the unit is brought
directly from a cold to a warm location, moisture may condense
inside the unit. When you move it from a cold to a warm location, wait for about one hour before operating the unit, or remove
the disc and leave the unit turned on until the moisture evaporates.
2. Installation
Ensure that the D1888 is used in accordance with the
instructions and illustrations provided in this manual.
3. Objects and Liquids
Do not push objects of any kind into the unit through openings; do
not spill or spray liquid of any kind on or in the system (this may
result in a fire or electric shock). Do not place anything heavy on
the unit. To ensure proper ventilation and proper operation, never
cover or block the slots and openings with a cloth or other
material. Keep the unit away from an open flame such as fire,
candle etc. Replace the battery only with the same or equivalent
type to prevent damage to the unit. In order to protect the environment please dispose of the battery properly . Do not use the unit in
temperatures higher than 104 degrees Fahrenheit or 40 degrees
Celsius.
3
4. Disassembly
Do not attempt to disassemble the cabinet. There is a risk of
electric shock and/or exposure to Laser Radiation. Contact
qualified service personnel if your system is in need of repair.
5. Cleaning Unit
When cleaning, make sure the system is unplugged from the power
source. Do not use liquid cleaners or aerosol cleaners. Use a
cloth lightly dampened with water for cleaning the exterior of the
system only.
6. Disc
Do not use irregularly shaped discs such as heart or star-shaped
discs as they may cause the unit to malfunction. Do not stick paper, tape or glue on the disc. Do not expose the disc to direct sunlight or heat sources such as hot air ducts. Do not touch the surface of disc. Handle the disc by its edge. Clean the disc by wiping
the disc from the center out with a cleaning cloth. Remove the disc
from the unit and store it in its case after playing. Some playback
operations of discs may be intentionally fixed by software producers. Since this unit plays discs according to the disc contents the
software producers designed, some playback features may not be
available. Also refer to the instructions supplied with the discs.
7. Regional Coding
Both the DVD player and disc are coded by region. These
regional codes must match in order for the disc to play. If the
codes don’t match, the disc won’t play. This unit’s code is region
1. DVD’s with other regional codes cannot be played in this unit.
C. Contents
1. 1 x 8 ” LCD Monitor and DVD Player
2. 1 x AC to DC Adapter
3. 1 x Remote Control w/Battery (CR2025)
4. 1 x Instruction Manual
5. 1 x Audio/Video Cable
6. 1 x DC Power Adapter
4
D. Powering and installation
1. Powering the system indoors (Refer to Figure 1)
Plug one end of the AC to DC adapter into the DC 9-12V jack on
the right side of the main unit, then plug the other end into the 100240V AC power receptacle.
Figure 1
2. Powering the system in a car (Refer to Figure 1)
Plug one end of the DC power adapter into the DC jack on the unit,
then plug the other end into the vehicle‘s DC power socket.
3. Built-in Battery
Slide the Power On/Off Switch to Off position. Plug one end of the AC
to DC adapter into the DC jack on the side of the player, then plug the
other end into the 100~240V AC power outlet. The charge light will
flash for about 3 seconds, then it turns to red. Once fully charged, the
LED indicator will be green. Then remove the AC to DC adapter wall
plug.
NOTE: Your new battery must be charged a minimum of 8 hours before the first usage. Each full recharge takes approximately five hours
and one full charge can provide power to the player for approximately 2
hours.
5
E. Controls, Indicators, and Connectors
1. Unit View (Refer to Figure 2)
Figure 2
1) LCD Panel Shut Off Switch
2) Wide Button
3) Stop Button
4) Previous Button
5) Next Button
6) Play Button
7) Menu Button
8) Up Button
9) Right Button
10) OK Button
11) Down Button
*Using headphone jack 1 will disable the internal speakers
12) Left Button
13) Open Door Switch
14) IR Sensor
15) Power LED
16) Power on/off Switch
17) Volume Up/Down Control
18) Headphone 1*
19) Headphone 2
20) Charge Indicater
21) AV Out Jack
22) DC 9V Input Jack
6
2. Remote Control View (Refer to Figure 3)
1) Setup Button
2) Up Button
3) Previous Button
4) Enter Button
5) Reverse Scan /Left Button
6) Down Button
7) Numeric Keypad
8) Display Button
9) Zoom Button
10) Subtitle Button
1 1) Next Button
12) A-B Repeat Button
13) Forward Scan /Right Button
14) 1/All Repeat Button
15) Stop Button
16) Menu Button
17) Audio Button
18) Angle Button
19) Play/Pause Button
Figure 3
F. Loading and Playing a Disc
a. After connecting power to the unit, apply power to the DVD player
with the power switch. The power indicator will light.
b. Open the disc tray by pressing OPEN button and place a disc into
the tray with the label side facing up.
c. Close the tray by pressing the “PRESS” button. The unit will load
the disc and start playing.
d. Rotate the VOLUME control to adjust the DVD player’s
volume.
e. To stop playing a disc, press STOP.
f. To turn off the DVD player, slide the POWER ON/OFF switch to
OFF.
7
G. SETUP
Press ‘SETUP’ to display the Main screen of the SETUP Menu on the
screen. Press ‘SETUP’ again to exit the SETUP Menu.
1) Press SETUP, the ‘GENERAL SETUP PAGE’ will display on
screen.
General Video Password Preferen Exit
Angle Mar k
Off
Main Setup Menu Screen
a).Select ‘TV DISPLAY ’ using the DOWN button, and then press
‘ENTER’ to enter the submenu. Select the TV display mode on
the screen using UP/DOWN, and press ‘ENTER’ to confirm the
setting. Press LEFT to return.
* NORMAL/PS: When the player is connected to a normal TV,
and a wide picture is shown on the full screen.
* NORMAL/LB: When the player is connected to a normal TV,
and a wide picture is shown on the screen with a black strip
at both the top and bottom of the screen.
* WIDE: When the player is connected to a wide screen TV, a
wide picture is shown on the full screen.
Video Password
General
Angle Ma rk
Set TV Display Mode
Off
Preferen
Normal PS
Normal LB//
Wide
Exit
TV Display Screen Display
8
b).Select ‘ANGLE MARK’ using the DOWN button, and then press
the ‘ENTER’ button to enter the submenu. Choose Angle Mark
on or off using the UP/DOWN buttons and then press ‘ENTER’
to confirm the setting. Press the LEFT button to return.
General Video Password Preferen Exit
Angle Mar k
Set Angle Mark
Off
On
Off
Angle Mark Screen Display
* ON: The screen will show the angle mark icon. (*If an angle
option is available).
* OFF: The screen will not display the Angle Mark icon.
NOTE: Not all discs contain above features.
9
Loading...