Audiovox D1805 User Manual
D1805
PORTABLE 8" LCD MONITOR AND DVD PLAYER
1
A. Introduction
Thank you for selecting the D1805 portable DVD player. The main
features include a 8" Wide Screen (16:9 Aspect Ratio) Liquid Crystal
Display (LCD) monitor and a DVD player. The unit applies the latest
state of the art electronics and is designed for use in hotels, offices,
vehicles or your home. The unit is constructed to provide years of
reliable, trouble-free service, and is compact so that you can take it
with you anywhere and is designed for quick and easy installation.
Please read the entire instruction manual supplied with this product
prior to operation. The documentation will assist you in installing the
system properly to obtain the best equipment performance. Please
treat this manual proplely for later use.
B. Cautions and Warnings
1. Placement
To prevent fire or electric shock, do not expose this appliance to
rain or moisture. Do not place the set on an unstable cart, stand,
tripod, bracket or table to prevent it from falling. Keep the unit away
from strong magnets, heat sources, direct sunlight, excessive dust.
If the unit is brought directly from a cold to a warm location, moisture may condense inside the unit. When you move it from a cold
to a warm location, wait for about one hour before operating the
unit, or remove the disc and leave the unit turned on until the moisture evaporates.
2. Installation
Ensure that the D1805 is installed in accordance with the instructions and illustrations provided in this manual.
3. Object and Liquid
Do not push objects of any kind into the unit through openings; do
not spill or spray liquid of any kind on or in the system (this may
result in a fire or electric shock). Do not place anything heavy on
the unit. To ensure proper ventilation and proper operation, never
cover or block the slots and openings with a cloth or other material.
2
4.Disassemble
Do not attempt to disassemble the cabinet. There is a risk of electric shock and/or exposure to Laser Radiation. Contact qualified
service personnel if your system is in need of repair.
5. Cleaning Unit
When cleaning, make sure the system is unplugged from the power
source. Do not use liquid cleaners or aerosol cleaners. Use a
cloth lightly dampened with water for cleaning the exterior of the
system only.
6. Disc
Do not use irregularly shaped discs such as heart or star-shaped
discs as they may cause the unit to malfunction. Do not stick paper, tape or glue on the disc. Do not expose the disc to direct sunlight or heat sources such as hot air ducts. Do not touch the surface of disc. Handle the disc by its edge. Clean the disc by wiping
the disc from the center out with a cleaning cloth. Remove the disc
from the unit and store it in its case after playing. Some playback
operations of discs may be intentionally fixed by software producers. Since this unit plays discs according to the disc contents the
software producers designed, some playback features may not be
available. Also refer to the instructions supplied with the discs.
C. Contents
1. 1 x 8’’ LCD Monitor & DVD Player Combo
2. 1 x AC to DC Adapter
3. 1 x Rechargeable Battery
4. 1 x Remote Control with battery
5. 1 x Instruction Manual
6. 1 x AV Cable
7. 1 x DC Power Adapter
3
D. Powering and installation
1. Powering the system indoors (Refer to Figure 1)
Plug one end of the AC to DC adapter into the DC 9V jack on the
left side of the main unit, then plug the other end into the 120V AC
power socket.
2. Powering the system in a car (refer to Figure 1)
Plug one end of the DC Power adapter into the DC 9V jack on the
unit, then plug the other end into the cigarette lighter socket.
1 2
Figure 1
4
E. Controls, Indicators, and Connectors
1. Unit View (Refer to Figure 2)
1) DC 9V Input Jack
2) Audio Jack (L+R)
3) Video Jack
4) AV Input /Output Switch
5) Brightness Control
6) MENU
7) Up button
8) Left Button
9) OK Button
10) Down Button
11) Right Button
12) Close disc cover point
13) Open Button
14) Previous Button
15) Stop Button
16) Next Button
17) Play Button
18) Pause Button
19) Screen Mode ( wide) Button
20) Power Saving Mode Switch
21) NTSC/PAL Switch
22) Coaxial Jack
23) Hi-Fi Headphone Jack
24) Volume Control
25) Power On/ Off Switch
26) Remote Control Sensor
27) Power LED
28) Battery Clips
29) Battery Connector
Figure 2
5
2. Remote Control View (Refer to Figure 3)
1) Display Button
2) Angle Button
3) Subtitle Button
4) Audio Button
5) Zoom Button
6) UP/DOWN/LEFT/RIGHT/
ENTER Buttons
7) Return Button
8) A-B Button
9) Forward Button
10) Reverse Button
11) Slow Button
12) Stop Button
13) Number Buttons
14) Setup Button
15) Menu Button
16) Repeat Button
17) SKIP-
18) SKIP+
19) Play Button
20) Pause Button Figure 3
F. Loading and Playing a Disc
a. After connecting power to the unit, Slide the power switch to the
“ON” position, the power indicor will illuminate red.
b. Open the disc tray by pressing OPEN , and place a disc into the
tray with the labal side facing up.
c. Close the tray with pressing “PRESS” button.The unit will load the
disc and start playing by pressing “PLAY”.
d. Rotate the BRIGHT and VOLUME Controls to adjust the LCD’s
brightness and the DVD player’s volume.
e. To stop playing a disc, press STOP.
6
G. SETUP
Press ‘SETUP’ to display the Main screen of the SETUP Menu on the
screen. Press ‘SETUP’ again to exit the SETUP Menu and the unit
will resume it’s last playback mode.
Figure 7. Main SETUP Menu Screen
1) Press “Setup”, the ‘GENERAL SETUP PAGE’ will display on screen.
Figure 8. SPDIF Output Screen
a).Select “SPDIF Output” using the DOWN button, Then, press
“Right” enter the Submenu, select SPDIF OFF, SPDIF/RAW,
SPDIF/PCM by press UP/DOWN and confirm the setting by
Enter. Press LEFT to return.
* SPDIF OFF: the digital signal Audio output is off.
* SPDIF/RAW: the signal output from“COAXIAL”.
* SPDIF/PCM: the signal output will be pulse code Modulation
b).Select TV DISPLAY using the DOWN button, and then press
RIGHT to enter the submenu. Select the TV display mode on the
screen using UP/DOWN, and press ENTER to confirm the set-
ting. Press LEFT to return.
7
* NORMAL/PS: When the player is connected to a normal TV,
and a wide picture is shown on the full screen.
* NORMAL/LB: When the player is connected to a normal TV,
and a wide picture is shown on the screen with a black strip
at both the top and bottom of the screen.
* WIDE: When the player is connected to a wide screen TV, a
wide picture is shown on the full screen.
Figure 9. TV DISPLAY Screen Display
c).Select ‘ANGLE MARK’ using the DOWN buttton, and then press
the RIGHT button to enter the submenu. Choose Angle Mark on
or off using the UP/DOWN buttons and then press ENTER to
confirm the setting. Press the LEFT button to return.
Figure 10. ANGLE MARK Screen Display
* ON: The screen will show the angle mark icon. (*If an angle
option is available).
* OFF: The screen will not display the Angle Mark
NOTE: Not all discs contain above features.
8
d). Select ‘SCREEN SAVER’ using the DOWN button.
Figure 11. SCREEN SAVER Display
*ON: enables screen saver
*OFF: disables screen saver (off)
*NOTE: The DVD player will enter the Screen Saver mode after
approximately five minutes if the same image remains on the
screen.
e). Select “ Last Memory” using the DOWN button.
Figure 12. LAST MEMORY Screen Display
*on: The unit will return to the last position on the disc.
*off: The unit will not return to the last position on the disc.
2) With no disc inside the player select “Video quality Setup”by using
the LEFT/RIGHT buttons, press “enter” to enter the video quality
set up page.
Figure 13. Main SETUP Menu VIDEO QUALITY
9
a).Select “Brightness by using the UP or DOWN buttons ,then press
“Enter”you can change the Brightness by pressing the LEFT or
RIGHT buttons. To exit “Brightness Setting”, press “Enter”again
to return to the main Menu.
Figure 14. BRIGHTNESS Screen Display
b).Select “Contrast” by using the UP or DOWN buttons,then press
“Enter” you can adjust the Contrast by pressing the LEFT or
RIGHT butttons.
Figure 15. CONTRAST Screen Display
To exit “Contrast” Setting, press “Enter”again to return to the main
Menu.
c).Select “Hue” by using the UP or DOWN buttons, then press
“Enter” you can adjust the Hue by pressing the LEFT or RIGHT
buttons.
Figure 16. HUE (Tint) Screen Display
To exit “Hue”Setting,press “Enter”again to return to the main Menu.
10
Loading...