Audiovox CP-250 User Manual

INSTALLATION GUIDE FOR:

CHRYSLER, PLYMOUTH,

& DODGE VEHICLES

MODEL CP-250

Printed in Korea Form No. 128-4729A

RADIO PREPARATION:

1. Select two of the five mounting tabs provided and match the radio mounting style of the vehicle accord-

ing to Figures 1 through 3 below.

NOTE: Tab number is stamped on bottom of tab.

2. Attach the mounting tabs to the radio chassis with the two M4 X 5 screws provided.

3. Attach the 14-pin connector harness provided to the radio.

FIG. 1

FIG. 2

M4 SCREW

TAB #1

M4 SCREW

TAB #3

TAB #2

M4 SCREW

TAB #2

M4 SCREW

FIG. 3

M4 SCREW

TAB #5

TAB #4

M4 SCREW

RADIO INSTALLATION:

1. Remove dash panel from vehicle to expose sub-dash.

2. Remove and discard radio dummy panel attached to sub-dash.
NOTE: Do not discard hardware for dummy panel.

3. Pre-wire radio including antenna wire. Attach ring lug on ground wire (black w/white stripe) from radio

harness side and the vehicle side grounding strap to the rear of the radio chassis using the M5 x 8 screw
provided. See Fig. 4 below.

4. Install radio into sub-dash of vehicle using the M6 x 18 self-tapping screws provided.

5. Conduct a brief performance test to verify proper operation.

6. Replace dash panel.

FIG. 4

ADAPTOR HARNESS
(supplied)

M5x8

SCREW

ANTENNA WIRE

GROUNDING STRAP

RADIO HARNESS

GROUND WIRE

(black w/white stripe)

M6x18
SCREWS