Audiovox CA2051, APS25CH, SS9000, APS101, APS101N Owner's Manual
...
Model APS-57E
Owner’s Manual
3 Channel Remote Car Starter
FEATURES :
2 Three Button Programmable RF Transmitters
Three Channel Receiver (capable of accepting 4 transmitters)
External Superheterodyne Receiver Antenna w/PushButton Switch & LED
Keyless Entry Outputs
Trunk Release Output
On-Board Start Relay
On-Board Accessory Relay
On-Board Ignition 1 Relay
On-Board Ignition 2 Relay
Ignition 2 Relay Selectable On or Off During Cranking
On-Board Parking Light Relay
Ignition 3 / Shock By-Pass / GM VAT Output (relay required)
Tach Signal Learning Circuit
Two ( + ) and Two ( - ) Safety Shutdown Circuits
Alarm By-Pass Output
Accessory Outputs
Shut Down)
Selectable Steady or Flashing Parking Lights for Run Indication
Selectable 5, 10, 15, 20, 45, 60 Minute Run Time
Selectable Door Lock Output Pulse Timing
Car Finder Mode
(Pulse Before & After Start, During Crank & After
PATENTED: www.voxxintl.com/company/patents
PRESTIGE
128-9311
1 of 4
KEYLESS ENTRY
The Lock button on the transmitter is used to lock the vehicle's doors. The Unlock button
is used to unlock the vehicle's doors. To lock or unlock the doors simply press and release
the desired function button one time. As a keyless entry unit, for your convenience, the
parking lights will ash once when the doors are locked and twice when the doors are
unlocked.
REMOTE CAR FINDER
The Lock or Unlock buttons are also used to access the car nder mode. This feature
is particularly useful in a crowded parking lot where nding your car may be difcult. To
access the car nder mode, while within range of your car, simply press and hold either
the lock or unlock button of your transmitter for three seconds. The parking lights will
begin to ash, making your vehicle more visible. The lights will stop automatically after
30 seconds. If you wish to turn off the car nder mode prior to the expiration of the 30
second timer, press and release either the lock or unlock button of your transmitter one
time.
REMOTE TRUNK RELEASE
If you have electric trunk release in your vehicle and the remote trunk release option
was added to your vehicle, simply press and hold the Key/Trunk button of your keychain
transmitter for 4 seconds or until the electric trunk of your vehicle opens.
REMOTE STARTING THE VEHICLE
This unit will not start the vehicle if any one of the following situations exist:
The vehicle's hood lid is opened.
The gear shift selector is not in Park.
The brake pedal is depressed.
The safety control switch is in the Off position.
1. To start the vehicle, press and release the Key/Trunk button two times within
2 seconds. The vehicle will start and remain running for the pre-programmed 5, 10,
15, 20 minute run cycle. As a visual indication, the parking lights will ash or remain
on depending on the setting by your installation center.
2. When you arrive at the vehicle, turn the ignition key to the ON position (not the spring
loaded start position), then step on the brake pedal to disengage the remote starter.
The vehicle will continue to run, but now on its own power.
NOTE: The engine will stop running before the pre-programmed run cycle has expired if
PUSH-BUTTON LED RECEIVER VALET/OVERRIDE/SAFETY CONTROL SWITCH
The Push-Button LED switch located in the receiver allows you to temporarily disable the
remote starting function of the system. This is recommended whenever the vehicle is being
serviced.
you perform any one of the following functions:
Press and release Key/Trunk button on the keychain transmitter two times within
2 seconds.
Depress the brake pedal.
Open the vehicle's hood.
Place the unit in the safety control disabled mode.
128-9311
2 of 4
Loading...