Audiovox AX-510 Owner's Manual

Model AX-510

Owner’s Manual

4 Button Remote Security System

IMPORTANT ! In order to provide the highest possible level of security to your vehicle, this
system is equipped with selectable manual override circuitry. It is possible that you will need
to manually override your security system if the transmitter becomes lost, or inoperative due
to battery failure. Reading the sections on "MANUALLY OVERRIDING YOUR SYSTEM" is
necessary to fully understand the procedure required to enable your vehicle in such
situations. In addition, the chart on the last page of this manual has a section for the particular
features and options installed in your vehicle as well as the override method selected.
Valet Switch manual override is pre-selected from the factory, however, the system
can be configured for "Custom Code" operation. Confirm the override mode selected on the
last page of this manual, and familiarize yourself with the selection on it's operation.

FEATURES :

 2 Five Button Programmable RF Transmitters
 Five Channel Receiver
 Code Hopping Technology
 Selectable Manual Override Mode
 Remote Panic in all modes
 Protected Valet
 User Programmable Manual Override Code
 7 Function LED (Light Emitting Diode) - Arm / Disarm / Zone 1, 2, 3 / Valet / Arming
 Intrusion Alert with Memory
 Audible Arm / Disarm / Defective Zone / Tamper Confirmation
 Instant Siren Activation
 Starter Disable
 Additional Engine Immobilizer Output (optional relay required)
 True Last Door Arming (hardwire only)
 Defective Zone By-Pass
 Hardwire or Voltage Sense Selectable
 Active or Passive Arming Selectable
 Programmable Auto Lock On / Off
 Programmable Auto Unlock On / Off
 Programmable Door Lock Pulse Duration 1 Second / 3.5 Seconds/1 Sec L/ Dbl. U/L
 Programmable Active or Passive Door Locks
 User Programmable Permanent Chirp Delete
 On Command RF Chirp Delete from Transmitter
 6 Tone Multi Tone Siren
 RF Inhibit with ignition on
 Parking Light Flash
 Plug In Dual Stage Shock Sensor

OPTIONS:

 Remote Trunk Release
 Remote Keyless Entry
 Multiple Vehicle Capable
 Remote Starter
 Remote Power Window Roll Up
 Remote Garage Door Interface
 Two Step Unlock Configurable
 Headlight Illumination During Arming, Disarming, Or Both
 Interior Illumination Upon Disarm

with Dual Stage Shock Sensor

(capable of accepting 4 transmitters)

128-7000

1 OF 10

YOUR “ Code Hopping “ TRANSMITTERS

The transmitters included with your new security system use the most advanced
and secure form of radio frequency transmission available on any current
automotive security system. Some of today’s sophisticated auto thieves use a
device known as a code grabber, which will receive and store the signal from your
transmitter, and retransmit at a later time to disarm your system.
Your anti code hopping transmitters will change their signal every time the button
is pressed, so when a thief grabs then retransmits your signal, the alarm system
will not respond.
If your transmitter button is pressed more than fifty times while it is out of range of
the vehicle ( children playing with your keys ), the transmitter will not operate when
you return to the vehicle and will need to be realigned to the receiver. To do this,
simply press the lock button two times within a one second time period. The
system will now respond to that transmitter each time a button is pressed.
NOTE: Your system has the option of using a siren, the vehicle horn, or both for

ARMING THE SYSTEM - ACTIVE

1. Turn off the engine, exit the vehicle and close all doors, hood lid and trunk lid.

2. Press and release the Lock button on the keychain transmitter.

the sounding device. Where the siren is referenced below, the horn or
both may in fact chirp, or beep. If ARM/ DISARM chirps have been elimi­nated the system will ARM/DISARM silently.

; Dash mounted LED begins to flash slowly.
; Parking Lights flash one time.
; Siren sounds one chirp.

If the siren/horn sounds 3 chirps refer to the SYSTEM FUNCTIONS
chart in this manual. If the siren/horn did not sound when arming, then
the chirps have been turned off or the system is in VALET mode.

 Doors Lock - Optional
 Headlight Illumination - Optional

SILENT ARMING - ACTIVE

1. Turn off the engine, exit the vehicle, and close all doors, hood, and trunk.

2. Press and hold the Lock button on the transmitter for 2 seconds.

; Dash mounted LED begins to flash slowly.
; Parking Lights flash one time.
; Siren will not sound.

Page 2

128-7000

2 OF 10

ARMING THE SYSTEM - PASSIVE ( AUTOMATIC )

1. Turn off the engine, exit the vehicle, and close and lock all doors, hood and trunk.

; Dash mounted LED begins to flash rapidly, indicating 30 second

passive arming has begun.

2. Opening any protected entry point during the 30 second passive arming cycle
will immediately suspend automatic arming and the 30 second passive
arming cycle will restart when all doors are closed. At the end of the passive
arming cycle;

; Dash mounted LED begins to flash slowly.
; Parking Lights flash one time.
; Siren sounds one chirp

 Doors Lock - Optional

PROTECTION WHILE THE SYSTEM IS ARMED

; Opening any protected door, hood, or trunk will cause the alarm to

; Whenever the system is armed, the dash mounted LED indicator will

; Whenever the system is triggered, the vehicle’s parking lights will flash

; Optional - Whenever the system is armed, the vehicle’s starting circuit

; Mild impact to the vehicle will cause the alarm to sound a short series

; Strong impact to the vehicle will cause the alarm to trigger for the full 30

If the siren did not sound when arming, then the chirps have
been turned off or the unit is in VALET mode.

Door locking during passive arming is a selectable feature.
The alarm can be programmed to allow the doors to lock only
when arming using the transmitter and they will not
automatically lock during passive arming.

immediately sound. The alarm will continue to sound for 30 seconds,
then stop and continue to monitor all protected entry points. If the thief
left a door opened, the alarm will sound for six 30 second cycles,
remain armed and ignore that triggered zone.

slowly flash. This serves as a visual deterrent to the potential thief.
The LED is very low current and will not cause the vehicle’s battery to
drain, even when left unattended for extended periods.

for the full 30 second alarm cycle, attracting visual attention to the
vehicle.

will be bypassed. If the thief should choose to ignore the siren, the
vehicle can not be started.

of warning tones.

second alarm cycle.

Page 3

128-7000

3 OF 10