Audiovox APS-2K4 User Manual

Model APS-2K4

Transmitter Programming Guide

This transmitter makes use of icons (symbols) to identify the reaction
your security system/keyless entry/and or remote start system, where
applicable, will have when any icon (button) is pressed. These icons
are programmed at time of installation to meet the needs of the individual
and to complement the vehicle that the system is installed in. T o replace
a transmitter or add transmitters, please follow the programming
instructions listed on the pages of this manual.

BUTTON

RECEIVER

CHANNEL

1

SYSTEM FUNCTION

Lock And Arm Alarm, also initiate and
terminates *Panic

* Where So Equipped

2

1

3

3

4

5

Unlock And Disarm, also initiates and
terminates *Panic. Programmable to
unlock drivers door and or all doors.

Lock and arm/unlock and disarm. May be
programmed to unlock driver's door or all
doors. Also will initiate and terminate
*Panic.

Pulsed or switched output to control
Remote Trunk Release or optional device
connected to channel 3.

When pressed and release two times, will
provide pulsed output or activate the
Remote Start option when installed.

When so equipped, this button can be used
to operate an optional device connected
to channel 4.

When so equipped, this button can be used
to operate an optional device connected
to channel 5.

Some of the more popular options available for the unused Option
Buttons of your transmitter are:

Although the most common use of the transmitter buttons are shown on
the front page of this guide, any button or button combination can be
programmed into any receiver channel. Additionally , if all 4 buttons are
used and you require access to a 5th channel, you would program a
combination of buttons to control the 5th function. i.e... you have
programmed lock for arm, unlock for disarm, trunk for trunk release,
and OPT1 for garage door operation, and you've added a window up
module that you want independent control of, you would program unlock
and trunk buttons pressed simultaneously into the receiver to control this
function independently . Also, if you do not program a transmitter button
into channel 2 which is the separate unlock/disarm channel, then
whatever button is programmed into channel 1 will serve as both
lock/arm & unlock/disarm.

PROGRAMMING TRANSMITTERS:
NOTE: It is important to remember that during the programming mode,

Non alarm models will flash the parking lights only to confirm the
transmitter code has been learned and stored.

NOTE: Because the system may be capable of sounding a siren, the

TO PROGRAM ADDITIONAL TRANSMITTERS:

1) Enter the vehicle, and turn the ignition switch to the on position.

2) Press and release the valet push button switch three times.

3) The dash mounted LED will flash 1x, and the siren will chirp 1x,

4) Press and hold the lock or lock/unlock symbol button of the transmitter

AS 9554 Remote Garage Door Interface
AS 9075 Remote car starter
AS 9153 Remote window roll up
AS 9256 Remote trunk release relay

each individual step must be completed within 15 seconds of the
previous step. If the 15 second time limit expires between steps,
the unit will automatically exit the program mode. This is
indicated by a long chirp from the siren.

vehicle horn, or both, where the siren chirp is referenced below,
the siren may chirp, the horn may beep, or both devices may
sound.

indicating that the system is ready to accept programming of channel
#1 which is arm/lock, disarm/unlock/unlock 2, and panic functions.

you wish to program for 4 seconds or until a long chirp is heard from
the siren.

2