Audiovox APS-25KB User Manual

Model APS-25KB

Owner's Manual

2 Button Remote Security System With Shock Sensor

Congratulations! Your purchase of this state-of-the-art security system

expresses a deep concern for the security of your vehicle, its contents,
and passengers. To fully appreciate the many functions and safeguards
incorporated in this system, please spend a few minutes reading this
manual. You may find unexpected features that could mean the
difference between “protected” and “fully protected”.

FEA TURES :

w 2 Two Button Programmable RF Transmitters
w Two Channel Receiver ( capable of accepting 4 transmitters )
w Anti-scan Technology
w Remote Panic in all modes
w Protected Valet
w 7 Function LED - Arm / Disarm / Zones 1, 2, & 3 / Valet / Arming
w Intrusion Alert with Memory
w Audible Arm / Disarm / Defective Zone / Tamper Confirmation
w Instant Siren Activation
w Starter Disable
w True Last Door Arming ( hardwire only )
w Defective Zone By - Pass
w Hardwire or Voltage Sense Selectable
w Active or Passive Arming Selectable
w User Programmable Permanent Chirp Delete
w 6 Tone Multi-Tone Siren
w Additional Negative Trigger Input
w RF Inhibit with Ignition On
w Parking Light Flasher
w Plug In Dual Stage Shock Sensor

OPTIONS :

w Remote Trunk Release
w Remote Keyless Entry
w Multiple Vehicle Capable
w Remote Starter
w Remote Power Window Roll Up
w Remote Garage Door Interface

ARMING THE SYSTEM (CHANNEL 1) : ACTIVE

1. Turn off the engine, exit the vehicle, and close and lock all doors, hood, and trunk.

2. Press and release the ARMING button on the keychain transmitter. The siren will "chirp"
once, the vehicle's parking lights will flash once, the doors will lock (optional), and the dash
mounted LED will begin to slowly flash.

WARNING! Excessive pressure on the transmitter buttons will damage the internal

NOTE: If the siren "chirped" three times when ARMING, then one of the entry points (hood, trunk,

ARMING THE SYSTEM (CHANNEL 1) : PASSIVE

1. Turn off the engine, exit the vehicle, close and lock all doors, hood, and trunk.

2. The dash mounted LED will begin to flash rapidly, indicating that the system is
automatically (passive) arming. As an added convenience, the automatic passive arming
will not begin until all doors and trunk lid are closed, allowing passengers to exit the vehicle
at their convenience.

3. In 30 seconds, you will hear a single short "chirp" from the siren, and the vehicle's parking
lamps will flash one time, indicating the system is ARMED. At this time, the dash mounted
LED will begin to flash slowly, providing a visual indication that the system is fully ARMED.

OPTION NOTE: If the optional (not included) power door lock interface has been
installed, the alarm control module can be programmed to...

4. If you wish to arm the system immediately, simply press and release the ARMING button
on the keychain transmitter. The siren will "chirp" once, the vehicle's parking lamps will
flash once, the doors will lock (optional), and the dash mounted LED will begin to
slowly flash.

PROTECTION WHILE THE SYSTEM IS ARMED:

1. Opening any door, hood or trunk will cause the alarm to immediately sound. The siren
will continue to sound for 30 seconds, then stop and automatically re-arm the vehicle.
If the potential thief left a door opened, the siren will sound for six 30 second cycles, then
re-arm and ignore the opened door.

2. Any strong impact to the vehicle’s glass will cause the alarm to trigger for the full 30 second
alarm cycle, with "Dual Stage", Any mild impact to the vehicle's glass will cause the alarm
to sound a short series of warning tones.

3. Whenever the system is armed, the Red dash mounted LED indicator will slowly flash.
This serves as a visual deterrent to the potential thief. The LED is a very low current
bulb, and will not cause the vehicle's battery to drain, even when left unattended for
extended periods.

4. Whenever the system is triggered, the vehicle's parking lights will flash for the 30 second
alarm cycle, attracting added visual attention to the vehicle.

5. Whenever the system is armed, the vehicle's starter will be bypassed. If a thief should
choose to ignore the siren, the vehicle can not be started.

components on the circuit board. All that is required is a light push to the button.

doors) has been left opened. Closing the hood, trunk, or doors will correct the problem
and you do not need to disarm the system to make the correction.

a. Automatically lock the doors during step 3 above, or
b. Only lock the doors when step 4 below is executed.

Page 2