Audiovox 50-0244x-018, 50-0244x-001, 50-0244x-019 User Manual
INSTALLATION INSTRUCTIONS
the U.S.A
FOR
50-0244x-001 SERIES 1181275
50-0244x-018 SERIES 1181276
50-0244x-019 SERIES 1181277
CHEVROLET S-10 BLAZER
OVERHEAD CONSOLE for use with FLIPDOWN VIDEO SYSTEM
These instructions are intended for use only by experienced professionals in the automotive
customizing business. Special tools and equipment, as well as specialized handling and care
of product during installation, may be required. Before beginning this installation, carefully read
through the following instructions. Use extreme care when cutting headliner material.
Check for wiring or other componentry above headliner material. Cut only where indicated.
Materials/ Tools required for this installation:
1. #2 Phillips screwdriver 2. Powered screwdriver or drill with adapter
3. T-15 TORX bit driver 4. Razor knife or similar
5. Awl or similar tool 6. 1/4” hex socket bit
7. Band saw or similar 8. Audiovox Series 640/650 Video Module
INSTALLATION INSTRUCTION # 44-0025C
Printed in
June 3, 1999
MATERIALS PROVIDED FOR INSTALLATION:
ITEM Description QTY
1
SCREW, # 8 X 3/4" HWH 6
1
2
SCREW, # 8 X 3/4" PWH 4
3
SCREW, 6-32 x 3/4" PPH 4
2
4
5
6
7
8
WASHER, # 6 4
MOUNTING BRACKET 1
CONSOLE 1
FELT TAPE 3/4" X 8" 2
JUMPER HARNESS 1
3
4
INSTALLATION INSTRUCTION # 44-0025C
2
June 3, 1999
Printed in the U.S.A.
I. PREPARATION OF VEHICLE INTERIOR
O.E.M. screws previously installed.
FIGURE 1
2. Lower console and disconnect wiring at (2) two
locations. Lay console on workbench for
modification later.
See Figure 2.
1. Remove the O.E.M. console mounted to inner
roof of vehicle. Remove and discard dome light
cover to gain access to (2) two #8 x 3/4"
screws. Retain screws. Remove and retain (1)
one #8 x 1 1/2" screw located in front of
console near rear view mirror. See Figure 1.
3
FIGURE 3
FIGURE 2
3. Using rear edge of opening in headliner, carefully
trim headliner as shown and install mounting
bracket (item 5 pg 2). Make sure the 8” cut is
centered in vehicle. Caution: Before cutting
headliner material, check for wiring or other
componentry above headliner. Cut only where
indicated. Secure front of bracket to roof brace
using (2) two O.E.M. screws, previously
removed, in original locations. Make sure that
bracket is centered in vehicle and secure rear of
bracket to roof brace using (4) four #8 x 3/4"
screws (item 1 pg 2). Install (2) two #8 x 3/4"
screws (item 1 pg 2) in remaining holes next to
See Figure 3.
Loading...