Audiovox 128-7183 User Manual
Model AS-9055T
Owner’s Manual
3 Channel Remote
Car Starter
FEATURES :
! 2 Programmable RF Transmitters
! Three Channel Receiver (capable of accepting 4 transmitters)
! On-Board Start Relay
! On-Board Accessory Relay
! On-Board Ignition 1 Relay
! On-Board Ignition 2 Relay
! Ignition 2 Relay Selectable On or Off During Cranking
! On-Board Parking Light Relay
! Ignition 3 / Shock By-Pass / GM VAT Output (relay required)
! Tach Signal Learning Circuit
! Two ( + ) and Two ( - ) Safety Shutdown Circuits
! Alarm By-Pass Output
! Accessory Outputs
! Selectable Steady or Flashing Parking Lights for Run Indication
! Selectable 5, 10, 15, 20 Minute Run Time
(Pulse Before & After Start, During Crank & After Shut Down)
Released: 6-28-04
128-7183
1 of 2
REMOTE STARTING THE VEHICLE
SAFETY CONTROL SWITCH
The red handle control switch allows you to temporarily disable the remote starting function
of the system and moving this switch to the Off position is recommended whenever the
vehicle is being serviced. When the system is disabled, the remote door locks and optional
accessories will remain operational.
TELEMATIC UPGRADE:
This system has the ability to have a telematic upgrade module connected to it. This is an
upgrade that can give you control of certain functions of your vehicle from a Telephone, or
in some cases a computer interface. Please check with your installation center for most
recent Telematic Upgrades. If you had a Telematic Upgrade installed, the manual supplied
with the upgrade unit will provide a operators manual advising of the features of the system
and means available to control these features of your vehicle.
Run Time 5 Min " 10 Min " 15 Min " 20 Min "
Door Lock Timer 1 Sec/1 Sec " 3.5 " 1 Sec/Dbl 1 Sec "
Lights Pulse " Steady "
This will not start the vehicle if any one of the following situations exists;
The vehicle's hood lid is opened.
The gear shift selector is not in Park.
The brake pedal is depressed.
The safety control switch is in the Off position.
1. To start the vehicle, press and release the transmitter button two times
within 2 seconds. The vehicle will start and remain running for the preprogrammed 5,10,15,20 minute run cycle. As a visual indication, the
parking lights will flash or remain on depending on the setting by your
installation center.
2. When you arrive at the vehicle, turn the ignition key to the ON position
(not the spring loaded start position), then step on the brake pedal to disengage the remote starter. The vehicle will continue to run, but now on it's own
power.
NOTE: The engine will stop running before the pre-programmed run cycle
has expired if you perform any one of the following functions;
-Press and the button on the keychain transmitter two times within 2 seconds.
-Depress the brake pedal.
-Open the vehicle's hood
-Move the safety control switch to the Off position.
FUNCTION SETTING CHART
To be completed by installer
© 2004 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, NY 11788 128-7183
128-7183
2 of 2
Loading...