Audiovox 1286601 User Manual
Model AS 9075a
Owner’s Manual
Remote Start
Upgrade Module
FEA TURES :
w Remote Start Safety Control Switch
w Selectable Automatic Timed Start Mode (2 Or 4 Hours Selectable intervals)
w On-Board Start Relay
w On-Board Accessory Relay
w On-Board Ignition 1 Relay
w On-Board Ignition 2 Relay
w Ignition 2 Relay Selectable On or Off During Cranking
w On-Board Parking Light Relay
w Ignition 3 / Shock By-Pass / GM VAT Output (relay required)
w Tach Signal Learning Circuitry
w Two ( + ) and T wo ( - ) Safety Shutdown Circuits
w
Alarm By-Pass Outputs
w
Selectable Steady or Flashing Parking Lights for Run Indication
w Selectable 10 or 15 Minute Run Time
w Factory Keyless Upgrade Inputs (Allows Starting From Factory Keyless Entry Unit)
w 4 Auxiliary Outputs To Allow Control Of A Factory Alarm
w Diesel Glow Plug Preheat Mode select
CAUTION!
Be certain that the vehicle is outdoors before using this or any remote vehicle starting device. A running engine produces dangerous
carbon monoxide fumes which can be harmful or fatal if prolonged
exposure occurs. DO NOT remote start the vehicle if the car is
garaged.
Page 1
128-6601
1 of 4
This Remote Start Upgrade unit is designed to be added to an existing remote
control keyless entry system, or remote alarm system.
Because it is an upgrade unit it can be wired to operate from any unused button(s)
from your keychain transmitter. Please check with your installing dealer for which
transmitter button is connected to your remote start unit and, if you require a
single, double, or sequential press of the button(s) to operate your system.
SAFETY (Red Handled ) CONTROL SWITCH
The control switch allows you to temporarily disable the remote starting function
of your Remote Start System. To disable the unit, move the red handled control
switch to the off position.
The control switch also allows you to select between automatic 2 hour start up
or 4 hour start up when using the automatic start up timer mode. The factory
preset start up time for this mode is every 4 hours. To select between 2 or 4 hour
start up timer:
1.Begin with the control switch in the on position
2.Turn the ignition switch on then off
3.Within 10 seconds, move the control switch off, on, off, on (2 switch cycles) to
select a 2 ho ur start timer. After 10 seconds expire, the parking lights will
flash 2 times confirming that the two hour start cycle is set. Or, within 10
seconds move the control switch off, on, off, on, off, on, off, on (4 switch cycles)
to select a 4 hour start timer. The parking lights will flash 4 times confirming that
the 4 hour start timer is set.
REMOTE ST ARTING THE VEHICLE
The System WILL NOT start the vehicle if any one of the following conditions
exists:
1.The Vehicle Hood Is Opened.
2.The Gear Selector Is In Any Gear Other Then Park.
3. The Brake Is Depressed.
4.The Safety Control Switch Is In The Off Position.
CAUTION! Be certain that the vehicle is outdoors before using this or any remote
vehicle starting device. A running engine produces dangerous carbon monoxide fumes which can be harmful or fatal if prolonged exposure occurs. DO NOT
remote start the vehicle if the car is garaged.
Page 2
128-6601
2 of 4
Loading...