Audiovox 1285851 User Manual
Model AA-RS20CS
Owner's Manual
3 Button Remote Start Security System With
Plug-In Shock Sensor & Starter Disable
FEATURES:
2 Three Button Programmable RF Transmitters
Four Channel Code Learning Receiver
Anti Code Grabbing Technology
Remote Panic In All Modes
Protected Valet/Override
Remote Start Safety Control Switch
Safe Start RF Control (Double Push Of RF Transmitter)
Selectable Automatic Timed Start Mode
7 Function LED, Arming, Armed, Disarmed, Valet, Zones 1, 2, & 3
Intrusion Alert With Memory
Audible Arm, Disarm, Defect Zone, And Intrusion Indications
Instant Siren Activation All Entry Points
Starter Disable When Armed
True Last Door Arming
Defective Zone By-Pass
On Command RF Chirp Delete
6 Tone Multi-Tone Siren
Two Stage Shock Sensor
Selectable Run Time 10 or 15 Minutes
OPTIONS:
Remote Trunk Release
Remote Keyless Entry
Illuminated entry
Remote Power Window Control
Remote Garage Door Interface
Multiple Vehicle Capable
WARNING! Be certain that the vehicle is outdoors before using this or any remote
vehicle starting device. A running engine produces dangerous carbon
monoxide fumes which can be harmful or fatal if prolonged exposure
occurs. DO NOT remote start the vehicle if the car is garaged.
Your AA-RS20CS Remote Start Alarm System has many features and available options
some of which are selected at time of installation. For your reference, the list on the back
page of this manual show what features and options have been installed. Consult your
installing dealer for options that may have been installed and are not listed.
ARMING THE SYSTEM - ACTIVE:
1. Turn the engine off, exit the vehicle, and close all doors, hood and trunk.
1
2. Press and release transmitter button 1 one time.
2
The parking lights will flash once, the siren will chirp once, and the dash
3
mounted LED will begin to flash slowly confirming the system is armed.
If you have the optional door lock/unlock circuit installed, the doors will lock.
Note: If the siren chirped three times, then you have left a door, hood, or
trunk ajar. Simply closing that opening will provide full protection. If the
siren did not sound when arming, then the chirps have been turned off.
Refer to the section on "Eliminating the Arm/Disarm Chirps" shown later
in this manual.
SILENT ARMING - ACTIVE:
1. Turn the engine off, exit the vehicle, and close all doors, hood and trunk.
2. Press and hold transmitter button 1 for two seconds.
The parking lights will flash once, and the dash mounted LED will begin to flash slowly
confirming the system is armed. The siren will not chirp. If you have the optional door
lock/unlock circuit installed, the doors will lock.
Note: If the siren chirps three times, then you have left a door, hood, or trunk ajar . Simply
closing that opening will provide full protection.
ARMING THE SYSTEM - PASSIVE (AUTOMATIC)
If the passive arming feature has been selected:
1. Turn the engine off, exit the vehicle, and close all doors, hood and trunk.
The dash mounted LED will begin to flash rapidly indicating that the 30 second passive
arming timer has begun. If the LED does not begin to flash rapidly, then you have left a
door, hood, or trunk ajar . Closing this entry point will allow the arming cycle will begin. If
any entry point is opened during the 30 second arming cycle, arming will be suspended.
When all entry points are closed, the arming cycle will begin again.
At the end of the 30 seconds, The parking lights will flash once, the siren will chirp once,
and the dash mounted LED will begin to flash slowly confirming the system is armed. If
the siren did not sound when arming, then the chirps have been turned off. Refer to the
section on "Eliminating the Arm/Disarm Chirps" shown later in this manual. Passive door
locking is a selectable feature. If you have the optional door lock/unlock circuit installed,
the doors may or may not lock passively dependent upon the setup during installation.
PROTECTION WHILE THE SYSTEM IS ARMED:
Opening any protected entry point, hood, trunk, or doors will cause the alarm to trigger
immediately. The siren will sound and the parking lights will flash for 30 seconds, then
stop and continue to monitor all protected entry points. If the thief left the door opened,
the unit will sound for six 30 second cycles than shut down, isolate the triggered zone and
Page 2
continue to protect all other zones.
Whenever the system is armed, the dash mounted LED will slowly flash. This serves as
a visual deterrent to a potential thief. This LED is a very low current light emitting diode,
and will not cause the battery to drain even if left unattended for long periods of time.
Whenever the system is triggered, the vehicle parking lights will flash for the full siren
sounding period. Optional - whenever the system is triggered, the interior courtesy light
will flash for the full siren sounding period.
Whenever the system is armed, the vehicle starter circuit is disabled, even with the ignition key the vehicle will not start.
Whenever the system is armed, any strong impact to the vehicle will cause the shock
detector to trigger the alarm. Any lesser impact will cause the pre-detect stage of the
shock sensor to emit a few short series of warning tones from the siren.
DISARMING THE SYSTEM
As you approach the vehicle, press and release transmitter button 1 one time.
The parking lights will flash two times, the siren will chirp twice, and dash mounted LED
will turn off.
If you have the optional door lock/unlock circuit installed, the doors will unlock. If you
have the optional entry illumination circuit installed, the interior light will turn on for 30
seconds or until the ignition key is switched on.
Note: If the passive arming mode was selected at time of installation, the dash mounted
LED will start flashing rapidly indicating that the system is rearming. Opening any
door will suspend the automatic arming.
If the parking lights flashed three times, and the siren chirps four times, this indicates that
the alarm system had been triggered in your absence. Before turning on the ignition key,
examine the dash mounted LED's flash pattern. The number of flashes identifies the
triggered zone. For additional information, refer to INTRUSION WARNING SIGNALS
found later in this manual.
If the siren did not sound upon disarm, then the chirps have been turned off. Refer to the
section titled ELIMINATING THE ARM/DISARM CHIRPS.
SILENT DISARMING
1. As you approach the vehicle, press and hold transmitter button 1 for two seconds.
The parking lights will flash twice, and the dash mounted LED will turn off confirming that
the system is disarmed. The siren will not chirp. If you have the optional door lock/unlock
circuit installed, the doors will unlock. If you have the optional entry illumination circuit
installed, the interior light will turn on for 30 seconds or until the ignition key is switched on.
Note: If the passive arming mode was selected at time of installation, the dash mounted
LED will start flashing rapidly indicating that the system is rearming. Opening any
door will suspend the automatic arming.
If the parking lights flashed three times, and the siren chirps four times, this indicates that
the alarm system had been triggered in your absence. Before turning on the ignition key,
examine the dash mounted LED's flash pattern. The number of flashes identifies the
triggered zone. For additional information, refer to INTRUSION WARNING SIGNALS
found later in this manual.
Page 3
Loading...