Audiovox 1285400 User Manual

OPERATING INSTRUCTIONS

CD CHANGER SYSTEMS

USED WITH FORD RADIOS

OWNER'SOWNER'S

OWNER'S

OWNER'SOWNER'S
MANUALMANUAL

MANUAL

MANUALMANUAL

OPERATING INSTRUCTIONS

INTRODUCTION

The SPS/Audiovox CD Changer system installed in your vehicle
has beendesigned to operateusing the controls of the factory radio.
In general, the operation of the CD Changer will be as per the
instructions for the audio equipment included with your vehicle
Owner’s Manual. However, thereare afew differences asdescribed
herein, so please refer to this booklet for questions you may have
on the system operation.

Since the CD Changerwill operatethrough thesound systemof the
vehicle, adjustmentof theaudio functions (volume,tone, balance,
etc.) is made by using the controls on the car stereo.

The specific details on the handling of discs and the use of the CD
magazine (loading,removal, etc.) willbe found within the Owner’s
Manual of the compatiblechanger usedin thesystem. Please note
that the discs areloaded labelside up in some changer models and
label side down in other models. The correct method is shown in
the manualfor thechanger and is indicated onthe magazineitself.
Make sure to load the discs correctly asthe changerwill notoperate
if the discs are inserted up-side-down.

SETTING UP FOR OPERATION

Following the instructions in theOwner’s Manualof theCD Changer,
load the desired number of discs into the CD magazine and insert
the magazine into the changer.

With the car stereo operating, turn on the CD Changer by pressing
the “CD” button on the radio. Play of the changer will begin and the
disc number and track number will appearon theradio displaypanel.
Play will begin from the first disc if a new CD magazine has been
loaded intothe changer or will resumefrom the point at whichit had
previously playedif amagazine was already in the changer. Adjust
the volume,tone, andbalance toyour taste by using thecontrols on
the car stereo.

When the lasttrack on a disc hasplayed, the unit will automatically
advance to and begin play of the next disc in the magazine. When
the last track on the last disc in the magazine has been played, the
unit will automatically return to the first disc and continue playing.

To return to radio operation from CD play, press the radio band
button (“AM FM” or “AM” “FM” depending on radio type). To return
to tape operation fromCD play,simply inserta tapeinto thecassette
deck or, if a tape is already loading in the deck, press the “TAPE”
button. To return to CD Changer operation from radio or tape play,
press the “CD” button.

NOTE: Forvehicles equippedwith rearseat audio controls, this CD

Changer system will allow the rear seat passengers to
operate the CD Changer as well as the radio functions.

2