Audiovox 1284863A User Manual

MODEL APS-35-CL
Owner's Manual Manuel D'Instructions  Manual Del Sistema
Active/Passive OperationFonctionnement Du Actif/PasifOperación Del Activa/Pasiva
DU SYSTÈME DE SÉCURITÉ AUTO À COMMANDE À DISTANCE
DE SEGURIDAD DE AUTOMÓVILES A CONTROL REMOTO
TABLE OF CONTENTS
Features&Options .............1
Operating the System
ArmingtheSystem(Active).....2
-Arming the System (Passive)
- Protection while the system is armed
DisarmingtheSystem .............3
-Intrusion Warning Signals
-Valet System Override Switch
Eliminating the Arm/Disarm
Chirps ...................................4
-Remote Panic Operation
-Trunk Release
-Additional Remote Functions
SystemFunctionsChart.......5
TABLE DES MATIERES
Fonctions et Options ...................6
Fonctionnement du Système
Armementdysystème(Actif)...........7
-Armement dy système (Passif)
- Protection lorsque le système est armé
Désarmementdusystème...............8
-Signauxd'avertissementd'effraction
-Interrupteur d'invalidation du système/valet
Elimination du bruit stridnet lors de
l'armement/dudesarmement...........9
-Fonctionnement panique à distance
-Déverrouillage du coffre
-Fonctions supplémentaires de
commande à distance
Fonctions du système ...............10
INDICE
CaracteristicasyOpciones........11
Operación del Sistema
Activación del sistema (Activa)....12
-Activación del sistema (Pasiva)
- Protección mientras el sistema está activado
Desactovacióndelsistema...........13
-Señalesdeadvertenciadeintrusión
-Interruptor derivante de sistema
Eliminación de los chirridos de
activación /desactivación.............14
-Operación remota de emergencia
-Liberador del baúl
-Funciones adicionales a control remoto
Funcionesdesistema.................15
Model APS-35-CL
Owner's Manual
Active / Passive Operation
CONGRATULATIONS! Your purchase of this state-of-the-art security system
expresses a deep concern for the security of your vehicle, its contents, and passengers. To fully appreciate the many functions and safeguards incorporated in this system, please spend a few minutes reading this manual. You may find unexpected features that could mean the difference between "protected" and "fully protected".
FEATURES AND AVAILABLE OPTIONS:
Two 2-Button Programmable Transmitters are included
Instant Arming and Disarming with a Remote Keychain Transmitter
Power Door Locks are remotely Locked and Unlocked when the system is armed and disarmed
The Vehicle's Starter is Disabled whenever the Alarm is Armed
A Concealed Valet/Emergency Disarm Switch will by-pass the Alarm in the event your Transmitter is lost, or if you wish to deactivate the Alarm for Service Work
Programmable Active/Passive Arming Capability
Programmable 6 Tone (Multi Tone) Siren included
Programmable Accessory Lock/Unlock Capability
Visual L.E.D. Arm/Disarm indicator with Audible "chirp" confirmation
The Vehicle's Parking Lights Flash when Arming, Disarming, and Alarm Sounding
6 Function Dash Mounted L.E.D. Alarm Status Indicator
Remote Keychain Panic allows Alarm Activation in Emergencies at distances up to 75 feet from the vehicle
Intrusion Alert with three Zone Monitoring lets you know When and How the Alarm was Activated in your Absence
Channel 2 from the keychain transmitter trips an on-board trunk release relay which is compatible with most factory installed electronic trunk release systems
An Additional Radio Frequency Channel is Built into the Keychain Transmitter to allow the use of the Following Optional Accessories;
Remote Starter - This device allows you to start the vehicle,
with the push of a button, from inside your home. A great feature on those cold winter mornings! (available for fuel injected, automatic transmission vehicles only)
Page 1
ARMING THE SYSTEM (CHANNEL 1) : ACTIVE
1. Turn off the engine, exit the vehicle, and close all doors, hood, and trunk.
2. Press and release the ARMING button on the keychain transmitter. The siren will "chirp" once, the vehicle's parking lights will flash once, the doors will lock, and the dash mounted L.E.D. will begin to slowly flash. WARNING! Excessive pressure on the transmitter buttons will damage the internal components on the circuit board. All that is required is a light push to the button. NOTE: If the siren "chirped" three times when ARMING, then one of the entry points (hood,trunk, doors) has been left opened. Closing the hood, trunk, or doors will correct the problem, and you do not need to disarm the system to make the correction.
ARMING THE SYSTEM (CHANNEL 1) : PASSIVE
1. Turn off the engine, exit the vehicle, and close all doors, hood, and trunk.
2. The dash mounted L.E.D. will begin to flash rapidly, indicating that the system
is automatically (passive) arming. As an added convenience, the automatic passive arming will not begin until all doors and trunk lid are closed, allowing passengers to exit the vehicle at their convenience.
3. In 30 seconds, you will hear a single short "chirp" from the siren, and the vehicle's
parking lamps will flash one time, indicating the system is ARMED. At this time, the dash mounted L.E.D. will begin to flash slowly, providing a visual indication that the system is fully ARMED.
OPTION NOTE: The alarm control module can be programmed to...
a) Automatically lock the doors during step 3 above or,
4. If you wish to arm the system immediately, simply press and release the ARMING
b) Only lock the doors when step 4 below is executed.
button on the keychain transmitter. The siren will "chirp" once, the vehicle's parking lamps will flash once, the doors will lock, and the dash mounted L.E.D. will begin to slowly flash.
PROTECTION WHILE THE SYSTEM IS ARMED:
1. Opening any door, hood or trunk will cause the alarm to immediately sound. The
siren will continue to sound for 30 seconds, then stop and automatically re-arm the vehicle. If the potential thief left a door opened, the siren will sound for six 30 second cycles, then re-arm and ignore the opened door.
2. Whenever the system is armed, the Red dash mounted L.E.D. indicator will
slowly flash. This serves as a visual deterrent to the potential thief. The L.E.D. is a very low current bulb, and will not cause the vehicle's battery to drain, even when left unattended for extended periods.
3. Whenever the system is triggered, the vehicle's parking lights will flash for the
30 second alarm cycle, attracting added visual attention to the vehicle.
4. Whenever the system is armed, the vehicle's starter will be bypassed. If a thief
should choose to ignore the siren, the vehicle can not be started.
Page 2
DISARMING THE SYSTEM (CHANNEL 1) :
1. As you approach the vehicle, press and release the ARMING button on the
keychain transmitter. WARNING! Excessive pressure on the transmitter buttons will damage the internal components on the circuit board. All that is required is a light push to the button.
2. The siren will "chirp" 2 times, the vehicle's parking lamps will flash two times
and the doors will unlock indicating the system is DISARMED.
3A. ACTIVE : The dash mounted L.E.D. will turn off, and remain off until the system
is re-armed.
3B. PASSIVE : Never attempt to disarm the system from a distance that prevents
you from opening a door within 30 seconds. Since the system is programmed for pasive arming, it will begin to re-arm until a door is opened. Opening the door will suspend the passive arming cycle.
INTRUSION WARNING SIGNALS:
The system will inform you if an intrusion attempt has occurred while you were away from the vehicle. If an intrusion attempt has occurred, the siren will "chirp" 4 times when disarming the system. The vehicle's parking lights will also flash 3 times to indicate an intrusion has occurred. Enter the vehicle and observe the dash mounted L.E.D. for further information.
1. If the L.E.D. is flashing two times...pause...two times...etc., then an intrusion
attempt was made to the hood, trunk, or an optional sensor.
2. If the L.E.D. is flashing three times...pause...three times...etc., then an intrusion
attempt was made through one of the vehicle's doors. These intrusion warning indicators are stored in the system's memory, and will only be erased from memory when the ignition key is turned on.
VALET / SYSTEM OVERRIDE SWITCH:
The "Valet" switch allows you to temporarily bypass all alarm functions, eliminating the need to hand your transmitter to parking attendants or garage mechanics. When the system is in valet mode, all alarm functions are bypassed, however, the remote panic feature and remote door locks will remain operational. To use the valet mode;
1. Enter the vehicle and turn the ignition key to the "on" position.
2. Move the valet toggle switch to the "on" position. The dash mounted L.E.D. will
turn on solid, and remain on as long as the system is in the valet mode.
3. To return to normal operation, move the valet switch to the "off" position any time
the ignition is on. In the event you lose your keychain transmitter, or if the transmitter fails to disarm the system, the valet switch can be used as a system override switch. Open the car door (the alarm will sound). Turn the ignition key on, and move the valet switch to the "on" position. The alarm will stop sounding, and the vehicle can now be started.
NOTE: Always remember to move the Valet Switch back to the "off" position. This will ensure that the vehicle remains protected at all times.
Page 3
ELIMINATING THE ARM / DISARM CHIRPS:
The normal arming and disarming confirmation "chirps" can easily be turned on
and off using the valet toggle switch. To do this...
1. The valet switch must be in "off" position.
2. Turn the ignition key on, and then off.
3. Within 10 seconds of turning the ignition key off, move the valet toggle switch to the on-off-on-off-on-then off.
4a. If, before proceeding with step 1, the chirps were on, then you will hear 2 chirps
to indicate that the chirps have been turned off.
4b. If, before proceeding with step 1, the chirps were off, then you will hear 1 chirp
to indicate that the chirps have been turned on.
5. Whenever power to the system is disconnected (for repair or service of the vehicle), the chirps will be active when power is re-connected. To turn the chirps off, simply execute 1-3 above.
Note: Whenever the chrips are by-passed, the 3 chirp defect and 4 chirp intrusion
indicator will always operate. This feature will always warn you if there is a defective sensor during the arming sequence or if the vehicle had been tampered with in your absence, even if the normal arming and disarming chirps have been turn off.
The arming button on your keychain transmitter also functions as a "panic" switch for instant activation of the alarm in emergency situations. To use the remote panic switch;
1. Press and hold the arming button on the keychain transmitter for 3 seconds or more. The alarm will immediately sound.
2. To stop the alarm, press and release the arming button on the keychain transmitter. If the button is not pressed, the alarm will automatically stop after 30 seconds.
WARNING! Excessive pressure on the transmitter buttons will damage the internal components on the circuit board. All that is required is a light push to the button.
REMOTE PANIC OPERATION (CHANNEL 1) :
TRUNK RELEASE (CHANNEL 2) :
This security system has an on-board trunk release relay, that will activate the existing factory installed electronic trunk release switch. To remotely open the trunk, press and hold button #2 on the keychain transmitter for 3 to 4 seconds.
NOTE: This feature will not operate when the vehicles ignition key is turned "ON".
ADDITIONAL REMOTE FUNCTION (CHANNEL 3) :
This security system has an additional feature that can be wired to a number of different optional accessories. Some of the more common uses for this "channel" are; * Remote Car Starter - available for most automatic transmission, fuel injected
vehicles.
* Remote Window Roll Up - available for most vehicles equipped with power
windows.
To activate the optional accessory;
1. Press and release both buttons on the keychain transmitter simultaneously.
2. The optional accessory that has been wired to CHANNEL 3 will now engage.
Page 4
APS-35-CL
SYSTEM FUNCTIONS AT A GLANCE
DASH L.E.D. INDICATORS
RAPID FLASHING ..............................
SLOW FLASHING .................................................
OFF ....................................................................
ON - SOLID .................................................
3 FLASH ... PAUSE ..........................
2 FLASH ... PAUSE ..........................
**1 FLASH ... PAUSE .......................
SIREN CHIRP INDICATORS
*1 CHIRP ...................................................................
*2 CHIRPS ...........................................................
3 CHIRPS ........................................
4 CHIRPS .....................................
PARKING LAMPS (Optional)
1 FLASH .....................................................................
2 FLASH ...............................................................
3 FLASH ........................................
** Where applicable. * These chirps are optional and may be disengaged.
PASSIVE ARMING
ARMED
DISARMED
VALET MODE INTRUSION ZONE 3 INTRUSION ZONE 2 INTRUSION ZONE 1
ARM
DISARM
ARM / DOOR OPEN
DISARM / INTRUSION
ARM
DISARM
DISARM / INTRUSION
Your System Has These Features Activated:
Starter Cut-out
Door Lock Interface
Shock Detector
Optional Channel 2 Device
Audiovox Corp., 150 Marcus Blvd. Hauppauge, N.Y. 11788 Form No. 128-4863A
Page 5
Motion Detector
Hardwire
Loading...
+ 14 hidden pages