Audiovox 1181292, 1181293, 1181291 User Manual
FOR USE IN VEHICLES WITH FACTORY INSTALLED
Printed in the U.S.A
INSTALLATION INSTRUCTIONS
FOR
50-0210F-002 SERIES 1181291
50-0210F-003 SERIES 1181292
50-0210F-004 SERIES 1181293
SUBURBAN
OVERHEAD CONSOLE for use with FLIPDOWN VIDEO SYSTEM
These instructions are intended for use only by experienced professionals in the automotive
customizing business. Special tools and equipment, as well as specialized handling and care
of product during installation, may be required. Before beginning this installation, carefully read
through the following instructions. Use extreme care when cutting headliner material.
Check for wiring or other componentry above headliner material. Cut only where indicated.
Materials/ Tools required for this installation:
1. #2 Phillips screwdriver 2. Powered screwdriver or drill with adapter
3. T-45 TORX bit driver 4. Razor knife or similar
5. Awl or similar tool 6. 1/4” hex socket bit
7. 7/64" drill bit 8. Small chisel
9. Audiovox Series 640/650 Video Module
INSTALLATION INSTRUCTION # 44-0019E
OVERHEAD CONSOLE ONLY.
July 7, 1999
MATERIALS PROVIDED FOR INSTALLATION:
REAR LIGHT TRIM
SCREW, # 6 X 1/2"
Printed in the U.S.A
ITEM Description
1
2
3
4
5
6
7
8
9
10
11
SCREW, # 8 X 3/4" HWH
,TEK,Z1
SCREW, # 8 X 2 1/2" PFH ,ZII 3
SCREW, # 8 X 1 1/4" PWH ,BZ 4
CONSOLE 1
MOUNTING BRACKET 1
REAR LIGHT 1
PLYWOOD, 3/8" X 6" X 14" 1
SCREW, 6-32 X 3/4" 6
WASHER, 3.5 mm 4
QTY
4
1
10
INSTALLATION INSTRUCTION # 44-0019E
2
July 7, 1999
I. PREPARATION OF VEHICLE INTERIOR
1. Remove the O.E.M. compartment console
currently mounted to inner roof of vehicle.
Remove (1) one # 8 X 1 3/4" screw from recess
in front of console near rear view mirror. Pull
front of O.E.M. console down to access wiring.
Disconnect all wiring from console. Pull console
forward to release rear retainers from inner roof
recess near center of vehicle. Remove console
and lay it in a safe place. See Figure 1.
FIGURE 1
2. Turn console over and place on a covered surface.
Remove plastic molded assembly from cloth covered
trim ring. Using a 7/64” drill bit, drill through the
center of the (10) ten plastic pins which secure
console together. See Figure 2. CAUTION:
Do not drill deeper than 1/2" or you may drill
through console in some areas. Using a small
chisel, carefully remove the head of the (10) ten
plastic pins. Unsnap the wiring connector secured to
clip on trim ring and separate console from trim ring.
See Fig. 2.
FIGURE 2
3
3. Discard trim ring. See Figure 3.
Using a razor knife, carefully trim the (10) ten
plastic pins flush with the shoulder.
See Figure 4.
FIGURE 3
FIGURE 4
4
Loading...