Audio Technica AE3000 SPECIFICATIONS

AE3000

CARDIOID CONDENSER MICROPHONE

•Excels in high-SPL applications such as guitar cabinets, toms, snare, timpani and overheads

•Large-diaphragm capsule combines with the open architecture of the headcase to provide an extremely accurate and open sound

•Low-profile side-address design with tapered grille allows optimal positioning of element vis-à-vis sound source

•Robust design for enduring dependability on the road

•Integral 80 Hz HPF switch and 10 dB pad

•Cardioid polar pattern reduces pickup of sounds from the sides

and rear, improving isolation of desired sound source

AE3000 SPECIFICATIONS

†

ELEMENT Fixed-charge back plate

permanently polarized condenser

POLAR PATTERN Cardioid FREQUENCY RESPONSE 20-20,000 Hz LOW FREQUENCY ROLL-OFF 80 Hz, 12 dB/octave OPEN CIRCUIT SENSITIVITY –43 dB (7.0 mV) re 1V at 1 Pa* IMPEDANCE 100 ohms MAXIMUM INPUT SOUND LEVEL 148 dB SPL,1kHzat1%T.H.D.;

158 dB SPL, with 10 dB pad (nominal)

NOISE

11 dB SPL

DYNAMIC RANGE (typical) 137 dB, 1 kHz at Max SPL SIGNAL-TO-NOISE RATIO

83 dB, 1 kHz at 1 Pa*

PHANTOM POWER 11-52V DC, 3 mA typical REQUIREMENTS

SWITCHES High-pass filter;

10 dB pad (nominal)

WEIGHT(less accessories) 6.0 oz (170 g) DIMENSIONS 4.55" (115.5 mm) long, 1.89"

(48.0 mm) maximum diameter

OUTPUT CONNECTOR Integral 3-pin XLRM-type ACCESSORIES FURNISHED

AT8471 isolation clamp for

/8"-27 threaded stands;5/8"-27 to

/8"-16 threaded adapter;

soft protective pouch

†

In the interest of standards development, A.T.U.S.offers full details on its test methods to other industry professionals on request.

*1 Pascal = 10 dynes/cm

Typical, A-weighted, using Audio Precision System One.

Specifications are subject to change without notice.

= 10 microbars = 94 dB SPL

The AE3000 is intended for use in professional applications where remote power is available.It requires 11V to 52V DC phantom power, which may be provided by a mixer or console, or by a separate, in-line source such as the Audio-Technica AT8801 singlechannel or CP8506 four-channel phantom power supplies.

Output from the microphone’s XLRM-type connector is low impedance (Lo-Z) balanced.The signal appears across Pins 2 and 3;Pin 1 is ground (shield).Output phase is “Pin 2 hot”– positive acoustic pressure produces positive voltage at Pin 2.

To avoid phase cancellation and poor sound, all mic cables must be wired consistently:Pin 1-to-Pin 1, etc.

An integral 80 Hz hi-pass filter provides easy switching from a flat frequency response to a low-end roll-off.The roll-off position reduces the microphone’s sensitivity to popping in close vocal use.It also reduces the pickup of low-frequency ambient noise (such as traffic, air-handling systems, etc.), room reverberation and mechanically-coupled vibrations.

The AE3000 includes an AT8471 isolation clamp to provide secure mounting, versatile positioning, and effective dampening of unwanted mechanical noise.

Avoid leaving the microphone in the open sun or in areas where temperatures exceed 110°F (43°C) for extended periods. Extremely high humidity should also be avoided.

Polar Pattern

330

300

270

240

210

SCALE IS 5 DECIBELS PER DIVISION

LEGEND

200 Hz

1 kHz 5 kHz 8 kHz

Audio-Technica brand products purchased in the U.S.A.are warranted for one year from date of purchase by Audio-Technica U.S., Inc.(A.T.U.S.) to be free of defects in materials and workmanship.In event of such defect, product will be repaired promptly without charge or, at our option, replaced with a new product of equal or superior value if delivered to A.T.U.S.or an Authorized Service Center, prepaid, together with the sales slip or other proof of purchase date.Prior approval from A.T.U.S.is required for return.This warranty excludes defects due to normal wear, abuse, shipping damage, or failure to use product in accordance with instructions.This warranty is void in the event of unauthorized repair or modification, or removal or defacing of the product labeling.

For return approval and shipping information,contact the Service Department, Audio-Technica U.S., Inc., 1221 Commerce Drive, Stow, Ohio 44224.

Except to the extent precluded by applicable state law,A.T.U.S.will have no liability for

any consequential,incidental,or special damages;any warranty of merchantability or fitness for particular purpose expires when this warranty expires.

This warranty gives you specific legal rights, and you may have other rights which vary from state to state.

Outside the U.S.A., please contact your local dealer for warranty details.

120

150

180

LEGEND

One-Year Limited Warranty

100

12" or more on axis Roll-off

Frequency Response

500

200

Frequency in Hertz

10k

10 dB

Response in dB

20k

Audio-Technica U.S., Inc., 1221 Commerce Drive, Stow, Ohio 44224

Audio-Technica Limited,Old Lane, Leeds LS11 8AG England

www.audio-technica.com