Audio-Technica AC100, AC25, AC50 User Manual

AC25, AC50, AC100

RF Antenna Cables (25' RG8, 50' RG8, 100' RG8)

Features

• RG8-type exible coaxial cable

• 10 AWG stranded center conductor

• Bonded foil shield with tinned copper braid overlay

• Heavy-duty molded BNC connectors

• Ideal for portable or xed-installation applications

wireless microphones & system accessories

Specications

Cable type

Shield

Nominal capacitance

In the inter est of standards devel opment, A.T.U.S.

offers full details on its test me thods to other industr y

Specication s are subject to chang e without notice.

Impedance

Insertion loss

Connectors

Dielectric

Jacket

Nominal OD

* Within spe cied bandwidth

professional s on request.

RG8U 100% bonded aluminum foil with tinned copper braid overlay 50 ohms

24.5 pF/ft

2.6 dB (per 100' @ 400 MHz) Molded-on BNC Female Foam-polyethylene PVC

0.405"

Description

The AC25, AC50 and AC100 are pre-made antenna cables designed for remote antenna-to-receiver runs. The cables are constructed of a exible low loss RG8-type coaxial with molded BNC-type connectors.

Architect’s and Engineer’s Specications

The antenna cable shall consist of a pre-manufactured and tested (Note to specier: insert required length 25', 50', 100') length of RG8/U-type exible coaxial cable with molded heavy-duty BNC-type connectors at each end suitable for indoor and outdoor applications. It shall consist of 10 AWG stranded bare copper center conductors with 7x19 strands. The center conductors shall have foam-polyethylene insulation surrounded by a bonded aluminum foil-polyester tape and aluminum foil along with a +90% tinned copper braid shield. The exible outer jacket shall be constructed of PVC—Polyvinyl Chloride material with a nominal OD of .405". The cable shall have an impedance of 50 ohms and a nominal capacitance of 24.6 pF/ft. Insertion loss at 400 MHz shall not exceed

2.6 dB. At each end of the cable shall be tted a standard BNC-type locking connector. The connectors shall be integrally molded onto the cable and incorporate a built-in strain relief.

The antenna cable assembly shall be an Audio-Technica (Note to Specier: choose appropriate length), or equivalent. AC25—25' AC50—50' AC100 — 100'