Audio Pole FORCE 700 User Manual

POWER AMPLIFIER

FORCE 700

USER’S MANUAL

POWER SUPPLY

Ensure that the insource voltage (AC outlet) matches the voltage rating of the product. Failure to do so could
result in damage to the product and possibly the user. Unplug the product before electrical storms occur and
when unused for long periods of time to reduce the risk of electric shock or fire.

2

EXTERNAL CONNECTION

Always use proper ready-made insulated mains cabling (power cord). Failure to do so could result in
shock/death or fire. If in doubt, seek advice from a registered electrician.

FUSE

To prevent fire and damage to the product, use only the recommended fuse type as indicated in this manual. Do
not short-circuit the fuse holder. Before replacing the fuse, make sure that the product is OFF and disconnected
from the ACD outlet.

PROTECTIVE GROUND

Before turning the unit on, make sure that it is connected to Ground. This is to prevent the risk of electric shock.
Never cut internal or external Ground wires. Like wise, never remove Ground wiring from the Protective Ground
Terminal.

OPERATING SAFETY INSTRUCTIONS

Read these instructions. Follow all instructions. Keep these instructions. Do not discard. Heed all warnings. Only
use attachments/accessories specified by the manufacturer.

This symbol indicates that the disposal of this product is submitted to local regulations. Please
contact your local dealer.

DISPOSAL

Important Safety Instructions

This symbol, wherever used, alerts you to the presence of un-insulated and dangerous voltages
within the product enclosure. These are voltages that may be sufficient to constitute the risk of
electric shock or death.

This symbol, wherever used, alerts you to important operating and maintenance instructions.

DO NOT REMOVE ANY COVERS

Within the product are areas where high voltages may present. To reduce the risk of electric shock do not
remove any covers unless the AC mains power cord is removed. Covers should be removed by qualified service
personnel only. No user serviceable parts inside.

POWER CORD AND PLUG

Do not tamper with the power cord or plug. These are designed for your safety. Do not remove Ground
connections! If the plug does not fit your AC outlet seek advice from a qualified electrician. Protect the power
cord and plug from any physical stress to avoid risk o electric shock. Do not place heavy objects on the power
cord. This could cause electric shock or fire?

SERVICING

Refer all servicing to qualified service personnel only. Do not perform any servicing then those instructions
contained within this User’s Manual

3

1. Introduction ……………………………………………………………………….. 4

2. Features …………………...……………………………………………………… 4

3. Controls and Settings ..………………………………….…………………….… 5

4. Operation Modes .……………………………………………………..……….… 7

5. Installations Tips…………………..…………………..….………………….…… 8

6. Connectors ………………….……………………………………………………. 9

7. Impedance Load …….…………………………………….………………….. … 9

8. Technical Specifications ….………………………….……………………..…… 10

9. Malfunctions ………………………………………….…………………..….. ..… 11

10. Warranty …………………………………………………………………………… 11

Index

Introduction

4

Thank you for purchasing Audiopole FORCE 700. This professional class-D amplifier can deliver 700 W and
weighs only 4.5 kg.
STEREO mode is a standard stereo amplifier that delivers 2 x 200 W / 8 Ohms or 2 x 350 W / 4 Ohms. The

BRIDGE mode allows you to get 700 W / 8 Ohms securely. Finally, the PARALLEL mode allows to amplify a
mono source using the resources of amplification of the 2 channels. The device features a choice of
connectors that adapt easily to most of uses. So the balanced XLR inputs are doubled by unbalanced RCA
jacks and the speaker outputs have secure SPEAKON terminals.

• 2 x 350 W / 4 Ohms, 2 x 200 W / 8 Ohms

• 700 W / 8 Ohms (BRIDGE mode)

• Class-D amplification

• Weight 4.5 kg

• 3 operation modes: STEREO - BRIDGE - PARALLEL

• Balanced XLR inputs, unbalanced RCA inputs

• SPEAKON and Output screw terminals

• 2U rack

1

Features

2