Audioplex RC-LGI Install Manual

INSTALLATION MANUAL

TECHNOLOGY

RC-LGI Interface

The RC-LGI Interface allows easy integration of conventional infrared repeating systems with LG/Zenith flat panel
televisions.

INSTALLATION

With the power off to both the infrared connector block and the television, connect the RC-LGI interface following
the wiring diagram below. Once all connections are made. Power can be restored to all the units. The system
sensitivity can be adjusted via the trim pot on the input side of the RC-LGI.

WIRING DIAGRAM

TO IR INPUT ON BACK

OF TELEVISION

OUT

12VDC POWER SUPPLY

RC-LGI

IN

ADJUSTMENT POT

FOR SYSTEM FINE TUNING

2006 - 11/22/06

OUT TO IR TARGET(S)

12 VDC
POWER
SUPPLY

12VDC

+12V

GND

STATUS

IR IN

EMITTERS

TO EMITTER JACK ON

IR CONNECTING BLOCK

(IRB-4 shown not included)

EMITTERS

TECHNOLOGY

IRB-4

disc 5 2.53

tape b

DVD DOLBY DIGITAL

WARRANTY

Your AUDIOPLEX TECHNOLOGY RC-LGI Interface is covered by a Lifetime Warranty against defects in workmanship
and materials. Any defects will be remedied without charge for labor or parts.

Damage incurred by shipping or accident is not considered to be a defect, and not covered by this warranty. AUDIOPLEX
TECHNOLOGY is not responsible for defective operation caused by abuse or by modification or service by an unauthorized
person or agency.

The unit must be properly installed and operated according to instructions for the warranty to apply. Any necessary servicing
must be done by AUDIOPLEX TECHNOLOGY. The products must be returned expenses prepaid, with written authorization
from the company. The unit must be shipped with the proof of purchase and in original carton and packing material to avoid
damage.

404 GWH PO BOX 440 MELVIN VILLAGE, NH 03850 800-257-2077 FAX: [phone]

AUDIOPLEX TECHNOLOGY