Page 1
INSTALLATION MANUAL
TECHNOLOGY
PRO CAT
Remote Location Microphone Interface
SPECIFICATIONS
Front Connectors: Female XLR
Rear Connector: Screw Type
Power: 9 vac power supply included
The PRO CAT uses low noise amplification to send a signal from the base microphone to a remote sound system over Cat-5 wire.
Follow the wiring diagram below, noting the wire locations are different on the transmitter and receiver plates. The signal gain can be
adjusted via a trim pot on the back of the transmitter plate.
BROWN
BROWN/WHITE
AC 1
AC 2
GAIN ADJUSTMENT
+
-
CAT-5 WIRE
BROWN/W
BROW
AC 1
AC 2
N
TRANSMITTER PLATE
+
+
TRANSMITTER PLATE
CAT-5 WIREMICROPHONE IN
HITE
*IMPORTANT
Please note that the wire locations are different
on the transmitter and video receiver plates.
RECEIVER PLATE
+
+
OUT TO
AUDIO SYSTEM
RECEIVER PLATE
Your AUDIOPLEX TECHNOLOGY PRO CAT is covered by a LIFETIME warranty against defects in workmanship and
materials. Any defects will be remedied without charge for labor or parts.
Damage incurred by shipping or by accident is not considered to be a defect, and not covered by this warranty. AUDIOPLEX
TECHNOLOGY is not responsible for defective operation caused by abuse or by modification or service by any unauthorized
person or agency.
The product must be properly installed and operated according to instructions for this warranty to apply. Any necessary servicing
must be done by AUDIOPLEX TECHNOLOGY. The product must be returned expenses prepaid, with written authorization
from the company. The product must be shipped with the proof of purchase and in the original carton and packing material to
avoid damage.
This warranty gives you specific legal rights. You may have other rights which vary from state to state.
2006 - 11/20/06
404 GWH PO BOX 440 MELVIN VILLAGE NH 03850 800-257-2077 E-MAIL: sales@audioplex.com
WARRANTY
AUDIOPLEX TECHNOLOGY
Loading...