Page 1
INSTALLATION MANUAL
TECHNOLOGY
ABW-AUTO 1 / ABW-AUTO 3
AUTOMATIC IN-WALL SPEAKER SWITCH
INSTRUCTIONS;
1. Please connect all of thc speaker wires before attaching the power supply.
2. Connect the internal wires from the master system and the output wires first. Pay
close attention to thc label!
3. Next connect the front speaker wires to the spring connectors. On the ABW-3
connect your video source to the trigger input (phono jack).
4. On the PC board you will notice potentiometer VR2, set it for a hold-in time delay
setting from 0.1 to 85 seconds.
5. Next connect the power supply and set thc VR1 sensitivity adjustment to your desired
trip level.
6. Finally disconnect the power supply and mount the switch in the wall. Reconnect
the power supply.
7. Installation complete.
Specifications: Sensitivity .1 to 2Vpp Hold-in delay 0 to 85 seconds. Power rating 500w music power.
WARRANTY
The AUDIOPLEX TECHNOLOGY ABW-AUTO 1 and ABW-AUTO 3 are covered by a Lifetime
warranty against any defects in workmanship and materials. Any defects will be remedied without
charge for labor or parts.
Damage incurred by shipping or accident is not considered to be a defect, and not covered by this
warranty. AUDIOPLEX TECHNOLOGY, is not responsible for defective operation caused by abuse or
by modification or service by any unauthorized person or agency.
The unit must be properly installed and operated according to instructions for the warranty to apply.
Any necessary servicing must be done by AUDIOPLEX TECHNOLOGY. The product must be
returned expenses prepaid, with written authorization from the company. The unit must be shipped
with the proof of purchase and in the original carton and packing material to avoid damage.
This warranty gives you specific legal rights. You may have other rights which vary from state to state.
1-800-257-2077 IN N.H. 1-603-544-8601
2000 - 6/22/00
AUDIOPLEX TECHNOLOGY
404 GWH, P.O. BOX 440
MELVIN VILLAGE, N.H. 03850
FAX: 1-603-544-8901
E-mail: sales@audioplex .com
Page 2
TYPICAL WIRING DIAGRAM FOR ABW-AUTO 1
AMPLIFIER 2
L- L+
R+ R-
From output on back
of the ABW-AUTO 3
A input to back
of ABW-AUTO1
L- L+
R+ R-
R+
R-
L+
L-
AMPLIFIER 1
TYPICAL WIRING DIAGRAM FOR ABW-AUTO 3
BEDROOM AUDIO,
VIDEO SYSTEM
ABW-AUTO
VIDEO OUT TO
RECEIVER
TO BACK OF ABW
WALL PLUG
POWER SUPPLY
VIDEO TRIGGERED
A INPUT TO BACK
OF ABW-AUTO
TO BACK OF ABW
LIVING ROOM AUDIO SYSTEM
2000 - 6/22/00
Loading...