AUDIOPIPE 20130813AP User Manual

Daimo Technology Co., Ltd.

Product Description:

The ISSC MYBM84SPK01 is a highly integrated Bluetooth

3.0+EDR stereo
short-range wireless communication in

module, designed for high data rate,

the 2.4 GHz ISM
band. With ISSC Bluetooth stack and profile, the ISSC
MY

BM84SPK01 provides a low power and ultra-low cost

Bluetooth 3.0+EDR

solution for wireless voice/audio

applications.

Features:

Main Chip: ISSC IS1684S
Bluetooth 3.0+EDR compliant
Typical +2dBm Class 2 output power
Receiver Sensitivity: GFSK typical -91dBm,

π/4-DQPSK typical -92dBm,
8-DPSK typical -84dBm

Piconet and Scatter net support
HCI UART interface
CVSD, A-law, -law CODEC algorithms for voice applications
SBC decode for Bluetooth audio streaming
Build-in High performance stereo audio codec
Cap-less/single end headphone driver
Audio DAC: 94dB SNR
A2DP, AVRCP profile support
DC 3.3V operating voltage
ROM version: 32Kb EEPROM
34 pins for DIP module, 35pins for SMT module (with additional

35th pin antenna port for external antenna option)

Size: 15mm x29mm
Build-in PCB Antenna
RoHS compliant

Daimo Technology Co., Ltd.

FCC Warning:

Any changes or modifications to this device not explicitly approved by manufacturer could

void your authority to operate this equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired

operation.

Label Instructions:

The modular transmitter must be equipped with either a permanently affixed label or must

be capable of electronically displaying its FCC identification number.

(A) If using a permanently affixed label, the modular transmitter must be labeled with its

own FCC identification number, and, if the FCC identification number is not visible when

the module is installed inside another device, then the outside of the device into which the

module is installed must also display a label referring to the enclosed module. This

exterior label can use wording such as the following: “Contains Transmitter Module FCC

ID: “2AATW-20130813AP” or “Contains FCC ID: “ 2AATW-20130813AP” Any similar

wording

that expresses the same meaning may be used. The Grantee may either provide such a

label, an example of which must be included in the application for equipment

authorization, or, must provide adequate instructions along with the module which explain

this requirement. In the latter case, a copy of these instructions must be included in the

application for equipment authorization.

(B) If the modular transmitter uses an electronic display of the FCC identification number,

the information must be readily accessible and visible on the modular transmitter or on the

device in which it is installed. If the module is installed inside another device, then the

outside of the device into which the module is installed must display a label referring to the

enclosed module. This exterior label can use wording such as the following:

“Contains FCC certified transmitter module(s).” Any similar wording that expresses the

same meaning may be used. The user manual must include instructions on how to access

the electronic display. A copy of these instructions must be included in the application for

equipment authorization.

Note:

The OEM integrator is still responsible for the FCC compliance requirement of the end

product, which integrates this module.

Appropriate measurements (e.g. 15 B compliance) and if applicable additional equipment

authorizations (e.g. Verification , Doc) of the host device to be addressed by the

integrator/manufacturer.