Audio Note CDT Three Owner's Information Manual

CDT Three

CD TRANSPORT

OWNER’S INFORMATION

1

! IMPORTANT SAFETY INFORMATION !

HUMIDITY: DO NOT STORE OR OPERATE THIS UNIT IN AREAS OF HIGH HUMIDITY, OR IN CLOSE
PROXIMITY TO WATER/DAMPINESS. DO NOT EXPOSE THE UNIT TO LIQUID.

EARTHING: THIS PRODUCT MUST BE EARTHED – ENSURE THAT THE MAINS SUPPLY CABLE IS
EARTHED.

SHOCK: INTERNAL OPERATING VOLTAGES ARE LETHAL! DO NOT REMOVE THE TOP COVER. DO
NOT ATTEMPT TO REPLACE THE FUSE WITHOUT DISCONNECTING THE UNIT FROM THE MAINS
SUPPLY.

SAFETY COMPONENTS: INTERNAL FUSES AND OTHER SAFETY COMPONENTS ARE LOCATED
INSIDE THIS UNIT IN ACCORDANCE WITH BS 60065 REQUIREMENTS.

IN THE EVENT OF SAFETY COMPONENT FAILURE, THEY MUST BE REPLACED WITH THE SAME
PART TYPES ONLY

. SUCH REPLACEMENT MUST BE CARRIED OUT BY A QUALIFIED SERVICE

TECHNICIAN.

PRECAUTION

Never touch the power cord with wet hands.
Always pull the power cord out by the plug, not by the cord.
Never expose the system to rain, moisture, excessive heat and magnetism.
Never let an inexperienced person repair or reassemble the unit.
Never put anything, especially metal, into the unit.
Never place excessive weight on the unit.

Always remove compact disc and CD clamp out of the unit before carrying or
transportation.

POWER REQUIREMENTS

Power requirements for electrical equipment differ from area to area. Please ensure
that your unit meets the power requirements in your area. The power requirement for your
transport is marked on the serial number plate on the rear panel.

If you are in doubt, please contact your dealer before plugging the unit into the mains
supply!

CE DECLARATION OF CONFORMITY

We declare under our sole responsibility that this product is in conformity with the following
standards or standardized documents:
BS EN 60065 in accordance with the regulations 73/23/EEC, 89/336/EEC (from 1

st

January 1997).

CE 94

Peter Qvortrup
Director
Audio Note (UK) Limited
25 Montefiore Road,
Hove,
East Sussex
BN3 1RD
United Kingdom
Tel: [phone]
Fax: [phone]

2

CLASS 1 LASER PRODUCT

This product contains a low power laser device. To ensure continued safety, do not
remove any covers or attempt to gain access to the inside of the product. Refer servicing to
qualified personnel.

Make Your Contribution to Protect the Environment
Used batteries with the ISO symbol for recycling, as well as small accumulators
(rechargeable batteries), mini-batteries (cells) and starter batteries should not be thrown into
the dustbin. Please leave them at an appropriate depot.
This equipment conforms to No. 62/499/EEC, 87/308/EEC standard.

TABLE OF CONTENTS

1 PRECAUTIONS
3 UNPACKING & INSTALLATION
4 OPERATIONS
6 PROGRAMMING
7 TROUBLESHOOTING GUIDE

SPECIFICATIONS