P1L – P2L – P3L - LOADED ENCLOSURES
SVC - SINGLE VOICE COIL SUBWOOFERS DVC - DUAL VOICE COIL SUBWOOFERS
P1L 10" 12"
Single P1L-1X10 P1L-1X12
Dual P1L-2X10 P1L-2X12
P2L 10" 12"
Single P2L-1X10 P2L-1X12
Dual P2L-2X10 P2L-2X12
P3L 10" 12"
Single P3L-1X10 P3L-1X12
Dual P3L-2X10 P3L-2X12
Installation & Operation
Serial Number: Date of Purchase:
INSTALLATION – ENGLISH
Strip 5/8"
(16mm)
From
Amplifier
CAUTION: Before installation, disconnect the battery negative (-) terminal to prevent damage to the unit, fire and/or possible injury.
Run the speaker cable from the amp. When routing the speaker cable from the amplifier, avoid running it close to any sources of high current
(wiring harnesses).
black terminal.
INSTALLATION – FRANÇAIS
MISE EN GARDE : a
Branchement du câble du haut-parleur de l’amplificateur. En plaçnt le câble du haut-parleur de l’ampli, éviter de l’approcher d’une source
de courant important. La sortie positive de l’ampli se branche sur le terminal rouge du caisson, et le négatif se branche sur le terminal noir.
INSTALACIÓN – ESPAÑOL
PRECAUCIÓN: Antes de la instalación, desconecte el terminal negativo de la batería (-) para prevenir daño a la unidad, incendio
Recorrido del Cable de Altavoz Desde el Amplificador. Al llevar el cable de altavoz desde el amplificador, evite que pase cerca de cualquier
fuente de alto corriente (cables de alimentacion). El terminal positive (+) de las salida de rojo, y el terminal negativo (-) al terminal negro.
EINBAU – DEUTSCH
VORSICHT: Entfernen Sie vor dem Einbau den negative Batteriepol, um Schäden am Gerät, Feuer bzw. mögliche Verletzungen zu
Anschluß des Lautsprecherkabels. Beim Anschluß des Lautsprecherkables sollten Sie darauf achten, daß das Kabel keine Fahrzeugstromkabel
kreuzt, um Einsteuungen zu verhindern. Die Plus-Leitung des Lautsprecherkabels kommt in die rote Klemme des Terminals, die Negativ-Leitung in die
schwarze Klemme des Terminals.
The positive (+) speaker output from the amp connects to the red terminal of the enclosure, and the negative (-) connects to the
vant d'entamer l'installation, déconnectez la broche négative (-) de la batterie pour éviter tout risque de
blessures, d’incendie ou de dommages à l'appareil.
y/o posibles lesiones.
vermeiden.
INSTALLAZIONE – ITALIANO
ATTENZIONE: Prima dell’installazione, scollegate il terminale negativo (-) della batteria per evitare danni all’unità,
pericoli d’incendio e/o potenziali lesioni personali.
Far correre il cavo dell’altoparlante all’amplificatore. Quando fate correre il cavo dell’altoparlante all’amplificatore non
fatelo passare vicino a qualsiasi cavo dell’impianto elettrico di serie dell’auto. Il segnale positivo dell’altoparlante (+) in uscita dall’amplificatore á collegato al terminale rosso del diffusore, e il negativo (-) al terminale nero.
Amplifier 4Ω Mono
Amplificador 4Ω Mono
Amplificateur de 4Ω Mono
Amplifier 4Ω Mono
Amplificatore 4Ω Mono
Black
o
Negr
Noir
Schwarz
o
Ner
16 AWG
-toWG
A
12
Red
Rojo
Rouge
Rot
Rosso
FEATURES
Vented Enclosure Features
• Proprietary High-Flow, Low-Noise Ports
• High Current Binding Posts
• Constructed with 5/8" MDF
ed with High Density Carpet
er
v
Co
•
•
ed Exclusiv
Wir
ely with Rockford Accessories
FEATURES
SPECIFICATIONS
Speaker Features - P1L - SVC (Single Voice Coil)
• High modulus closed conical polypropylene cone.
• Tear & fatigue resistant poly-cotton spider.
• High density compressed half-roll sealed poly-foam surround.
• High temp voice coil with spun-laced Nomex™ insulating
e-inforcment collar.
r
• Optimized motor magnetics with extended pole and bumped backplate.
• Sturdy 16 guage compound bend frame geometry.
• Proprietary spider venting/cooling technique.
Speaker Features - P2L & P3L - DVC (Dual Voice Coil)
• Venturi-effect center pole dispersion venting/cooling system.
• High modulus closed conical polypropylene cone and ABS/Acrylic dustcap
assembly geometry.
• Tear & fatigue resistant poly-cotton spider.
• High density compressed half-roll sealed poly-foam surround.
• High temp voice coil with spun-laced Nomex™ insulating
re-inforcment collar.
• Optimized motor magnetics with extended pole and bumped backplate.
• Double stack ferrite magnet structure.
• P2 – Sturdy 16 guage compound bend frame geometry.
• P3 – Rigid die-cast aluminium frame.
• Proprietary spider venting/cooling technique.
• Diamond cut cast aluminum motor cover for improved heat dissipation.
P1L-1X10
Single 10" SVC
Nominal Impedance (Ohms) 4 Ω
Replacement Model P1S410
ower Handling (Watts) 150 RMS / 300 Max
P
Overall Dimensions (HxWxD) 13.125” x 17.0” x 15.75”
(33.3cm x 43.2cm x 40.0cm)
P1L-2X10 Dual 10" SVC
Nominal Impedance (Ohms) 4 Ω
Replacement Model P1S810 (wired internally)
Power Handling (Watts) 300 RMS / 600 Max
Overall Dimensions (HxWxD) 13.125” x 31.125” x 15.75”
(33.3cm x 79.1cm x 40.0cm)
P1L-1X12 Single 12" SVC
Nominal Impedance (Ohms) 4 Ω
Replacement Model P1S412
Power Handling (Watts) 150 RMS / 300 Max
Overall Dimensions (HxWxD) 15.125” x 19.125” x 16.375”
(38.4cm x 48.6cm x 41.6cm)
P1L-2X12 Dual 12" SVC
Nominal Impedance (Ohms) 4 Ω
Replacement Model P1S812 (wired internally)
Power Handling (Watts) 300 RMS / 600 Max
Overall Dimensions (HxWxD) 15.125” x 33.875” x 16.375”
(38.4cm x 86.0cm x 41.6cm)
P2L-1X10 Single 10" DVC
Nominal Impedance (Ohms) 4Ω
Replacement Woofer P2D210 (wired internally)
Power Handling (Watts) 250 RMS / 500 Max
Overall Dimensions (HxWxD) 13.125” x 17.0” x 15.75”
(33.3cm x 43.2cm x 40.0cm)
P2L-2X10 Dual 10" DVC
Nominal Impedance (Ohms) 4 Ω
Replacement
W
oof
er
P2D410 (wir
ed internall
y)
Power Handling (Watts) 500 RMS / 1000 Max
erall Dimensions (HxWxD)
Ov
13.125” x 31.125” x 15.75”
(33.3cm x 79.1cm x 40.0cm)
P2L-1X12 Single 12" DVC
Nominal Impedance (Ohms) 4 Ω
Replacement Model P2D212 (wired internally)
er Handling (W
w
o
P
atts) 250 RMS / 500 Max
Overall Dimensions (HxWxD) 15.125” x 19.125” x 16.375”
(38.4cm x 48.6cm x 41.6cm)
P2L-2X12 Dual 12" DVC
Nominal Impedance (Ohms)
4Ω
Replacement Model P2D412 (wired internally)
Power Handling (Watts) 500 RMS / 1000 Max
Overall Dimensions (HxWxD) 15.125” x 33.875” x 16.375”
(38.4cm x 86.0cm x 41.6cm)
P3L-1X10 Single 10" DVC
Nominal Impedance (Ohms) 4 Ω
Replacement Model P3D210 (wired internally)
Power Handling (Watts) 400 RMS / 800 Max
Overall Dimensions (HxWxD) 13.125” x 17.0” x 15.75”
(33.3cm x 43.2cm x 40.0cm)
P3L-2X10 Dual 10" DVC
Nominal Impedance (Ohms) 4 Ω
Replacement Model P3D410 (wired internally)
Power Handling (Watts) 800 RMS / 1600 Max
erall Dimensions (HxWxD)
Ov
13.125” x 31.125” x 15.75”
(33.3cm x 79.1cm x 40.0cm)
P3L-1X12 Single 12" DVC
Nominal Impedance (Ohms) 4 Ω
Replacement Model
er Handling (W
w
o
P
atts) 500 RMS / 1000 Max
P3D212 (wired internally)
Overall Dimensions (HxWxD) 15.125” x 19.125” x 16.375”
(38.4cm x 48.6cm x 41.6cm)
P3L-2X12 Dual 12" DVC
Nominal Impedance (Ohms)
4Ω
Replacement Model P3D412 (wired internally)
Power Handling (Watts) 1000 RMS / 2000 Max
erall Dimensions (HxWxD) 15.125” x 33.875” x 16.375”
Ov
(38.4cm x 86.0cm x 41.6cm)
Specifications subjct to change without notice
LIMITED WARRANTY INFORMATION
Rockf
ord Corporation offers a limited warranty on Rockford Fosgate products on the following terms:
Length of Warranty
Speakers – 1 Year. Any Factory Refurbished Product – 90 days (receipt required)
What is Covered
This warranty applies only to Rockford Fosgate products sold to consumers by Authorized Rockford Fosgate Dealers in the
United States of America or its possessions. Product purchased by consumers from an Authorized Rockford Fosgate Dealer in
another country are covered only by that country’s Distributor and not by Rockford Corporation.
Who is Covered
This warranty covers only the original purchaser of Rockford product purchased from an Authorized Rockford Fosgate Dealer
in the United States. In order to receive service, the purchaser must provide Rockford with a copy of the receipt stating the
customer name, dealer name, product purchased and date of purchase.
oducts found to be defective during the warranty period will be repaired or replaced (with a product deemed to be
Pr
equivalent) at Rockford's discretion.
What is Not Covered
1. Damage caused by accident, abuse, improper operations, water, theft, shipping
2.Any cost or expense related to the removal or reinstallation of product
3. Service performed by anyone other than Rockford or an Authorized Rockford Fosgate Service Center
4.Any product which has had the serial number defaced, altered, or removed
5. Subsequent damage to other components
6.Any product purchased outside the U.S.
7.Any product not purchased from an Authorized Rockford Fosgate Dealer
Limit on Implied Warranties
Any implied warranties including warranties of fitness for use and merchantability are limited in duration to the period of the
express warranty set forth above. Some states do not allow limitations on the length of an implied warranty, so this limitation
may not apply. No person is authorized to assume for Rockford Fosgate any other liability in connection with the sale of the
product.
How to Obtain Service
Contact the
If you need further assistance, call 1-800-669-9899 for Rockford Customer Service.You must obtain an RA# (Return
Authorization number) to return any product to Rockford Fosgate.You are responsible for shipment of product to Rockford.
Authorized Rockford Fosgate Dealer you purchased this product from.
EU Warranty
ent EU warranty requirements, see your Authorized dealer for details.
oduct meets the cur
This pr
r
Rockford Fosgate
Rockford Corporation
600 South Rockford Drive
Tempe, Arizona 85281 U.S.A.
In U.S.A., (480) 967-3565 - Customer Service 1-800-669-9899
www.rockfordfosgate.com
12/2008 B.M.
12/2008 E.R.
1230-55461-01
ed.
v
d Corporation.
Rockford Fosgate, the Rockford Fosgate logo, and the PUNCH logo are either
2009 Rockf
registered trademarks or trademarks of Rockford Corporation.
or
All rights r
eser
Printed in China
Loading...