Audiocontrol LC2I User Manual
AudioControl
Active,
High Voltage
OEM Line Converter
If you like the LC2i, you’ll love the
EQX Equalizer/Crossover
Now that you have a great sounding preamp
signal, and you have restored the bass from the
factory roll-off, the next step toward sonic
perfection is to match the entire system to
your car. The EQX equalizer/crossover has 13
bands of equalization and a 24-dB Linkwitzriley crossover to fine tune your system for
that true sonic nirvana.
®
Patent Pending
GTO™ Great Turn On: No need to look
for a trigger wire.
The LC2i turns on all by itself. Just
hook up the speaker level inputs
and as soon as you turn on the
factory audio system the LC2i
will power up as well. After
the LC2i turns itself on, it
provides a 12 volt trigger
output to turn on your
amplifier.
A Jumper
which you
can reach from the end panel allows you to set this
feature on/off for specialized installations. The factory
default setting for the GTO™ circuit is always ON.
Setting the AccuBASS™ Bass Compensation:
Factory speaker systems have trouble reproducing loud
clean bass. Some companies systems limit the
bass at higher volumes so as not to damage
speakers. The AccuBASS™ circuit puts that
bass back.
Here’s how you set it up. After the
LC2i /Amps/ and speakers are installed and ready go:
Turn the system on and play
1.
some music with a good bass
track.
Turn the volume up while
2.
listening for the bass.
AccuBASS™ Threshold control
GTO™ Selector
AccuBASS™ Level control
®
If you hear a spot where the bass just drops right out…
3.
stop. Leave the volume there and go to your LC2i.
Set the AccuBASS™ Level control on the top of
4.
LC2i to the center detent.
Now, use a small screwdriver to turn the Threshold
5.
control clockwise slowly until you hear the bass pop
back in.
Re- adjust the AccuBASS™ Level control on the top of
6.
the unit to get the proper amount of bass compensation, and you’re ready for some ground pounding bass.
OK, what if your bass doesn’t roll off, but you still want
more?
No problem! Turn the AccuBASS™ Level control fully
down, rotate the threshold control fully clockwise to
lock in the bass equalization. Now you can turn up the
AccuBASS™ Level control for the amount of bass you
want.
Placement And Mounting of Optional
Dash Remote: (Purchased Separately) The dash
control may be mounted under the dash
using its own bracket or through
a custom hole in the dash.
It should be within
reach of the driver and
in a spot where the
LED is plainly
visible.
Loading...