A-RXMON
Headphone Monitor for A10-RX
— User Guide —
A-RXMON User Guide
Copyright / Doc Rev History Info
Copyright © 2018 Audio Ltd. All rights reserved. | www.audioltd.com
7 Century Court, Tolpits Lane, Watford WD18 9RS, UK | info@audioltd.com
Revision Date Description
1A Dec 2018 Initial Publication
Table of Contents
Copyright / Doc Rev History Info . . . . . . . 2
Table of Contents . . . . . . . . . . . . . . . 2
Overview . . . . . . . . . . . . . . . . . . . . 3
Key Features . . . . . . . . . . . . . . . . 3
System Quickstart . . . . . . . . . . . . . . . 3
Connectors, Controls Description . . . . . . 4
Firmware Updates . . . . . . . . . . . . . . . 5
Certications . . . . . . . . . . . . . . . . . 6
Industry Canada Conformity . . . . . . . . 6
FCC Conformity . . . . . . . . . . . . . . . 6
Declaration of Conformity . . . . . . . . . . . 6
Minimize RF Exposure . . . . . . . . . . . 6
- 2 -
A-RXMON User Guide
Overview
The A-RXMON is a belt-worn A10 Receiver enclosure. The A-RXMON provides a simple,
portable solution for the user to easily monitor two A10-TX audio channels with headphones.
Key Features
• Accommodates the A10-RX receiver (sold separately)
• Uses standard Sony L-mount batteries (sold separately)
• Heavy-duty 3.5 mm headphone jack
• User-friendly headphone volume control/power switch
• Monitor channel 1, channel 2 or both channels simultaneously
• Combined with the User Groups feature for the A10-RX, the A-RXMON provides fast, easy
and intuitive switching by name between multiple A10-TX frequencies
• Rugged, spring steel belt clip
• Micro USB port for updating rmware and loading User Groups on the A-RXMON
System Quickstart
Installation:
1. Remove any A-SL or A-XLR connected to the A10-RX. Orient the A10-RX in the slot
according to the image below.
Figure 2: A-RXMON Front Panel
2. Carefully slide the A10-RX into the slot. Press until you feel the connector seat fully and the
receiver is ush to the face of the A-RXMON.
3. Using the included 4 M2.5x16 mm screws, attach the A10-RX to the A-RXMON via the
holes in the bottom of the unit.
Powering:
1. Insert a fully-charged Sony L-Mount compatible battery into the battery slot. The battery
retainer clip will spring into place to secure the battery.
2. If retracted, push the headphone volume/power control, and then turn it clockwise past the
detent to power on the receiver.
Operation:
1. On the A10-RX, navigate to Menu > Outputs > Mode, and set to Analogue.
2. Connect headphones. For optimal operation, navigate to Menu > Outputs > Max level and set
the output to +14 dBu.
3. Flip Channel Selector switch according to which channel(s) you want to monitor.
The system is now ready for use.
- 3 -
Loading...