Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Service
Workshop Manual
Audi A1 2011 ➤ , Audi A2 2001 ➤ ,
Audi A3 1997 ➤ , Audi A3 2004 ➤ ,
Audi A3 Cabriolet 2008 ➤ ,
Audi A4 1995 ➤ , Audi A4 2001 ➤ ,
Audi A4 2008 ➤ ,
Audi A4 Cabriolet 2003 ➤ ,
Audi A5 Cabriolet 2009 ➤ ,
Audi A5 Coupé 2008 ➤ , Audi A6 1998 ➤ ,
Audi A6 2005 ➤ ,
Audi A7 Sportback 2011 ➤ ,
Audi A8 1994 ➤ , Audi A8 2003 ➤ ,
Audi A8 2010 ➤ , Audi Q5 2008 ➤ ,
Audi Q7 2007 ➤ , Audi R8 2007 ➤ ,
Audi TT 1999 ➤ , Audi TT 2007 ➤
Fitting instructions: radio communication systems
Edition 10.2010
Service Department. Technical Information
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Service
List of Workshop Manual Repair GroupsList of Workshop Manual
Repair GroupsList of Workshop Manual Repair Groups
Re pa ir G ro up
91 - Radio, telephone, navigation
Technical information should always be available to the foremen and mechanics, because their
careful and constant adherence to the instructions is essential to ensure vehicle road-worthiness and
safety. In addition, the normal basic safety precautions for working on motor vehicles must, as a
matter of course, be observed.
All rights reserved.
No reproduction without prior agreement from publisher.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi A1 2011 ➤ , Audi A2 2001 ➤ , Audi A3 1997 ➤ , Audi A3 2004 ➤ , Au ...
Fitting instructions: radio communication systems - Edition 10.2010
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi A1 2011 ➤ , Audi A2 2001 ➤ , Audi A3 1997 ➤ , Audi A3 2004 ➤ , Au ...
Fitting instructions: radio communication systems - Edition 10.2010
ii Contents
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi A1 2011 ➤ , Audi A2 2001 ➤ , Audi A3 1997 ➤ , Audi A3 2004 ➤ , Au ...
Fitting instructions: radio communication systems - Edition 10.2010
91 –Radio, telephone, navigation
1Service installation of radio commu‐
nication systems
1.1General notes
Disconnect negative terminal of battery -A- before fitting radio
communication and telephone systems ⇒ Electrical system; Rep.
gr. 27 .
Use applicable current flow diagrams ⇒ Current flow diagrams,
Electrical fault finding and Fitting locations.
Use cable ties to secure wiring harnesses. Pad plug-in couplings
with foam sheaths.
Note operating and installation instructions issued by the manu‐
facturers of mobile telephones, radio communication systems
and aerials ⇒ Operating instructions .
♦ Disconnecting and connecting battery -A- ⇒ Electrical system;
Rep. gr. 27 .
♦ Current flow diagrams, fuse assignment and fitting locations
⇒ Current flow diagrams, Electrical fault finding and Fitting lo‐
cations.
♦ Removing and installing trim ⇒ General body repairs, interior;
Rep. gr. 70 .
♦ Removing and installing factory-fitted systems ⇒ Communi‐
1.2Transmission power and possible fitting
locations
Audi approves the installation and operation of radio communi‐
cation systems, provided that the transmission power levels at the
aerial base do not exceed the values listed in the table for the
relevant model. The specified aerial fitting locations and trans‐
mission power levels are given in the tables ⇒ page 4 .
It may be necessary to reduce transmission power to comply with
the maximum permitted values as per VDE 0848 Part 2 (maxi‐
mum permitted field strength with respect to personal safety).
1.3Voltage supply
The battery -A- is used for connection of the positive and negative
cables when performing service installation of radio communica‐
tion systems to the vehicle.
An additional wiring harness has to be made up accordingly:
♦ Positive cable: 2.5 mm thick, red cable
♦ Negative cable: 2.5 mm thick, brown cable
♦ Terminal 15 cable: 1.5 mm thick, black cable
The positive cable must be fitted with a fuse in the immediate
vicinity of the battery -A- . This requires attaching a fuse holder
(Part No. 441 937 501) next to the battery -A- . The positive and
negative cables must be covered with an insulating sheath. Ap‐
1. Service installation of radio communication systems 1
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi A1 2011 ➤ , Audi A2 2001 ➤ , Audi A3 1997 ➤ , Audi A3 2004 ➤ , Au ...
Fitting instructions: radio communication systems - Edition 10.2010
propriate terminals are to be fitted on the battery end. For the
device end, proceed according to the operating instructions for
radio communication systems ⇒ Operating instructions .
Additional wiring harness is to be routed separately from vehicle
wiring (distance > 10 cm ).
Note
Crossing of standard wiring is preferable to parallel routing.
1.4Aerial and aerial wire
Use a screened wire between the transmitter/receiver unit and
the aerial. The screen must be connected to the unit and aerial
end. At the same time ensure that there is a good and permanent
earth connection between aerial base wire and vehicle body.
The transmission system must be tuned to prevent sheath waves
on the aerial wire. This should be ensured by performing a power
measurement to check and tune the radio communication sys‐
tem.
„Onglass“ aerials can only be fitted on vehicles without insulating
glass.
1.5Other auxiliary equipment
Installation of other electronic equipment, such as a business
package (TV, FAX) or household package (electric refrigerator
box) is only permitted if such items bear a CE or e mark. Power
is also to be supplied by way of a separate wiring harness and
provided with fuse protection.
2 Rep. gr.91 - Radio, telephone, navigation
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi A1 2011 ➤ , Audi A2 2001 ➤ , Audi A3 1997 ➤ , Audi A3 2004 ➤ , Au ...
Fitting instructions: radio communication systems - Edition 10.2010
1.6Overview of battery -A- / transmitter and receiver unit / fuse / wiring harness
A - Battery -A-
❑ Installation position, dis‐
connecting ⇒ Electrical
system; Rep. gr. 27
B - Telephone transmitter and
receiver unit
❑ Installation position, re‐
moving and installing ⇒
Communication; Rep.
gr. 91
C - Wiring harness
❑ Has to be made up
❑ Positive cable (terminal
30) 2.5 ∅ (red)
❑ Earth cable (terminal
31) 2.5 ∅ (brown)
❑ Positive cable (terminal
15a) 1.5 ∅ (black)
D - Fuse holder
❑ In immediate vicinity of
battery -A-
E - Terminal 15a
❑ Always connected to
output of terminal 15a
❑ Wiring must be protec‐
ted by a fuse
❑ Fuse max. 15 A
F - To starter -B-
❑ Original wire
G - Body earth
❑ Immediately next to bat‐
tery -A-
H - Transmission/reception aerial
❑ Fitting locations ⇒ page 4
J - Aerial earth
❑ Good, firm connection/corrosion protection
K - Screened aerial wire
❑ Wire with coaxial connector
L - Positive connection
❑ Attach red cable with terminal A6-2.5 beneath nut
❑ Route wiring harness separately if possible
M - Negative cable
❑ Attach brown cable with terminal A6-2.5 beneath nut
❑ Route wiring harness separately if possible
1. Service installation of radio communication systems 3
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi A1 2011 ➤ , Audi A2 2001 ➤ , Audi A3 1997 ➤ , Audi A3 2004 ➤ , Au ...
Fitting instructions: radio communication systems - Edition 10.2010
1.7Transmission power levels and aerial fitting locations for A2 (from model
year 2001 onwards)
DesignationP
Short wave (< 54 MHz)100 (PEP)Rear bumper
4 m band20 (eff.)Rear left wing
2 m band50 (eff.)Rear left wing
70 cm band50 (eff.)Rear left wing
Telephone, 450 MHz GSM 25 (eff.)Rear left wing
Telephone, 900 MHz GSM 20 (PEP)Rear left wing
Telephone, 1800 MHz
GSM
eff. = effective transmission power
PEP = Peak Envelope Power
WARNING
(Watt)Specified aerial fitting locations
max
Rear of roof (12 cm from roof edge in centre of vehicle)
Rear left side windows „onglass“
Rear of roof (12 cm from roof edge in centre of vehicle)
Rear left side windows „onglass“
10 (PEP)Rear left wing
Rear of roof (12 cm from roof edge in centre of vehicle)
Rear left side windows „onglass“
If radio communication systems with higher output are instal‐
led, or if the aerial is not fitted at one of the locations specified
in the table, the operating permit for the vehicle may be void.
1.8Transmission power levels and aerial fitting locations for A3 (from model
year 1997 up to model year 2003)
DesignationP
Short wave (< 54 MHz)100 (PEP)Centre of roof (rear)
4 m band20 (eff.)Centre of roof (rear)
2 m band50 (eff.)Centre of roof (rear)
2 m band20 (eff.)Front of roof (15 cm from edge of windscreen in centre
70 cm band50 (eff.)Centre of roof, rear
Telephone, 450 MHz GSM25 (eff.)Centre of roof, rear (same as radio, telephone and nav‐
Telephone, 900 MHz GSM20 (PEP)Centre of roof, rear (same as radio, telephone and nav‐
Telephone, 1800 MHz GSM 10 (PEP)Centre of roof, rear (same as radio, telephone and nav‐
(Watt)Specified aerial fitting locations
max
Rear bumper
Rear right side panel
of vehicle)
Centre of roof (rear)
Rear left or right side panel
Rear right side panel
igation system aerial -R52- )
Rear left or right side windows „onglass“
igation system aerial -R52- )
Rear left or right side windows „onglass“
igation system aerial -R52- )
Rear left or right side windows „onglass“
eff. = effective transmission power
PEP = Peak Envelope Power
4 Rep. gr.91 - Radio, telephone, navigation
Loading...
+ 16 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.