
High resolution SONY Super HAD CCD II camera with 700TVL
module.
480K(NTSC) pixels.
External adjust varifocal Lens.
Bracket
Camera Lens
IR LED
4
Main Body
1
Hex Tool
BSS7212 / BSS7550
IR Bullet Cameras
1.0
4
4
4

1). If cable is preferred to go through walls, loosen the bracket base
screws, take away the bracket plate, the cable through the center
hole of the bracket plate, and drill a hole on wall and make sure it is
big enough for the BNC connector and power jack to pass through.
*Ceiling
Installation
*Wall
Installation

2). If cable is does not need to go through walls, the cable can be fixed
directly to the wall surface.
3). Connect the BNC end of the camera to the extension cable and the
other end of the extension cable connect to your DVR.
Installer connects either 12VDC or 24VAC to the screw terminals.
(polarity is not important with either voltage).
Adaptor
Power
DVR
Video
extension cable
(not included)

4). Power up the camera and video should appear on screen.
5). You may now adjust the camera viewing angles by adjusting the
camera bracket position.
6).
Loosen the screws of the camera bracket,
adjust the Pan,Tilt and
rotate mechanism by hand, once the desired viewing position is
achieved, tighten up the
camera bracket
screws to fix the position
"as shown in below photos".
o
360
o
200
o
360
7). The camera is equipped with a Vari-Focal Lens for zoom in / out
feature. To Zoom, you must rotate the handle on the camera body
and adjust the focusing to get the best image.
ZOOM
FOCUS

8). The camera is equipped with a OSD menu, you must remove the
OSD button cover of the camera body, press the up, down, left and
right buttons and adjust the image effects to get the best image.
9). The camera is now all set up, close the camera OSD button cover.
UP
ZOOM
SET
OSD button cover
LEFT
DOWN
RIGHT
FOCUS
SETUP MENU
LENS AUTO
SHUTTER/AGC AUTO
←
←
WHITE BAL ATW
BACKLIGHT OFF
PICT ADJUST
←
D-WDR OFF
MOTION DET ON
NEXT
EXIT SAVE ALL
←
←
←
SETUP MENU
PRIVACY OFF
DAY/NIGHT EXT1
2DNR
←
←
←
CAMERA ID OFF
SYNC INT
LANGUAGE ENGLISH
CAMERA RESET
BACK
EXIT SAVE ALL
←
←

BSS7212 / BSS7550
Scanning System
2DNR
Backlight
D-WDR
Motion Detection
Privacy
1/3” Color SONY Super HAD CCD II
NTSC:976(H) × 494(V)
700
0.1Lux Color; 0.01Lux B/W (IR LED's On)
2:1 Interlace
2.8-12mm or 5-50mm Varifocal
Automatic Tracking
NR-MODE / Y Level / C Level
OFF / HLC / BLC
ON / OFF
ON / OFF
ON / OFF
Image Sensor
58
ss
Day / Night
Pict Adjust
OSD
IR LEDS
IR Range
IR
LED OFF
IR
LED ON
EXT1 / B&W / Color / Auto / EXT2
OSD Key control
OSD Key control
, BNC
42
More than 30m(100ft)
or AC 24V
140
650
80
97(W)x 81 (H) x 168(L)mm (Body only)
7