Attwood Battery Tray User Manual

CAUTION

Attwood Battery Hold-Down Trays are designed to be used with

standard batteries (24/24M and 27/27M series) including Gould

800 and Delco Voyager.

The adjustable-height crossbar holds the battery in place. Mounting

holes in the tray make it easy to secure and prevent battery movement.

The tray is made of noncorrosive, heavy-duty black plastic.

Meets ABYC Standard E-10 and U.S. Coast Guard requirements.

TOOLS AND MATERIALS REQUIRED FOR INSTALLATION

1. Drill and a suitable drill bit

2. Eight #10 stainless steel wood/sheet metal pan head screws

3. Eight #10 stainless steel flat washers

4. Screwdriver

MOUNTING INSTRUCTIONS

Battery must be located in a well ventilated area to prevent buildup

of explosive gasses. To prevent acid burns, locate in an area away

from casual contact.

1. Determine a suitable location for the battery tray making sure

there is enough room to work.

holes. It is recommended that you use the mounting holes closest

to the retaining bolt threads, if possible. You may wish to further

2. Using the battery tray as a template, mark the location of the screw

secure the tray with additional screws.

1016 N. Monroe Street, Lowell, MI 49331-0260 www.attwoodmarine.com

Battery Hold-Down Tray

9090, 9091

Installation Instructions

for quality replacement parts and marine accessories.

best-known boat manufacturers as original equipment. Look to Attwood

marine accessories are specified more than any other brand by America’s

Attwood marine hardware, navigational lighting, bilge pumps, and other

SAVE THESE INSTRUCTIONS

Form Number 69222 Rev. B 04-07

Battery

Figure 1

Bolt

Retaining Crossbar

Battery

Screws

Washers

Suitable Hull

Mounting Material

CAUTION

of the boat.

3. Drill eight pilot holes for the screws. Do not drill through the bottom

4. Fasten down the tray using the #10 screws and washers.

to prevent them from becoming lost when changing batteries. Install

the battery retainer and bolts (see Figure 1). Tighten moderately

5. Place the battery into the tray.

6. Thread a bolt into the crossbar on each side. The bolts fit tightly

until bolts and/or crossbar bend slightly.

Overtightening the bolts could damage the threads or damage

the crossbar.

requirements for correct installation. The positive terminal should

be insulated to prevent accidental shorting.

7. Connect the battery cables, following the battery manufacturer’s