Attenti VST 800 Users manual

Personal Watcher

QUX VST 800 / VST 800-2

USER MANUAL

10 December 2002

HomeFree Systems Ltd

VST 800 User Manual

Table of Contents

1. Foreword....................................................................................2

2. Installing the Personal Watcher .................................................3

3. Setting Time...............................................................................4

4. Triggering an Alarm ..................................................................5

5. General Rules for the Client ......................................................6

6. Maintenance Instructions...........................................................7

6.1. Replacing Batteries ....................................................................7

6.2. Cleaning Instructions .................................................................9

6.3. Straps Replacement..................................................................10

7. FCC Notices.............................................................................11

1

HomeFree Systems Ltd

1. Foreword

The Personal Watcher (VST 800) is a wristwatch, which contains
an integral transmitter. The transmitter is transmitting
identification signals, which are used to either locate the client’s
location within an area covered by a local positioning system, or
monitor his/her location and movement status at home.

The Personal Watcher enables the user to send a distress alarm
signal with a simple press of a button.

The Personal Watcher (VST 800) is transmitting on an American
FCC tested and approved frequency, whereas the European
version (VST 800-2) is transmitting on an European tested and
approved frequency. From a user interface and function point of
view the two models are identical; therefore this user manual
serves both versions.

VST 800 User Manual

2

HomeFree Systems Ltd

VST 800 User Manual

2. Installing the Personal Watcher

Turn on the Personal Watcher by pressing the red ON button on
the electronic key.

Press the electronic key’s RED button down for one second - the
red light turns steadily ON for two (2) seconds.

If the startup command has been successfully received, the red
light on the Electronic Key will flash for two (2) seconds.

Note

that if the transmitter has failed to receive the startup
command the red light will turn off after the initial two (2)
seconds ON.

If the Electronic Key battery is low the red light will
immediately flash for two (2) seconds, once the red button is
pressed. (No command is sent to the transmitter).

Place the Personal Watcher on its side, on a non-metal surface,
for 30 seconds.

Wrap the Personal Watcher’s strap around the wrist, as done with
any wristwatch. Once the strap is closed, secure it by fastening
the metal clip. If required, slip the strap holder to hold the lose
edge of the strap.

Note:

An alarm signal is sent to the central monitoring computer
whenever the strap is open, cut, or the Personal Watcher is
removed from the wrist without opening or cutting the strap.

3