AT&T Spiriti Communications Owner’s Manual
®
SPIRIT
Communications System
ConnecT/R
Owner’s Manual
Table of Contents
Introduction
Installation
Step 1—Set the MODE switch
Step 2—Set the ADMIN switch
Step 3—Mount the ConnecT/R
Step 4—Connect the ConnecT/R
Step 5—Test the Equipment
Using the Telephone Device
Answering Calls
Placing Calls
Paging
Interactions with SPIRIT Features
Troubleshooting
Appendix A—Wiring Requirements
Appendix B—Warranty
While reasonable efforts were made to ensure that the information in this document was complete and
accurate at the time of printing, AT&T assumes no responsibility for any errors. Changes or corrections to
the information contained in this document may be incorporated into future re-issues.
1
4
5
8
9
10
13
14
14
14
15
16
19
25
26
Copyright © 1990 AT&T
All Rights Reserved
Printed in U.S.A.
IMPORTANT SAFETY INSTRUCTIONS
To reduce risk of injury from fire or electric
shock, always follow basic safety precautions
when using this product. The safety symbol
(exclamation point inside a triangle) on the
ConnecT/R alerts you to the important operating and maintenance instructions below.
1.
Read and understand all instructions
Owner's Manual.
Observe all warnings and instructions
2.
marked on the product.
Unplug this product from wall outlets and
3.
telephone jacks before cleaning.
exposed parts with a soft, damp cloth. Do
not use liquid or aerosol cleaners, and never
immerse in water.
Do not use the product near water or when
4.
you are wet.
wet basement or near a swimming pool,
bathtub, shower, sink, or laundry tub. If the
product comes in contact with any liquids,
unplug the power and line cords immediately. Do not plug the product back in until
it has been dried thoroughly.
For example, do not use it in a
in this
Clean
Install this product securely on a stable
5.
surface. Damage may result if the product
falls.
Install this product in a protected location
6.
where no one can step on or trip over power
and line cords. Do not place objects on the
cords that may cause damage or abrasion.
7.
Do not allow anything to rest on the power
cord. Do not locate this product where the
cord will be abused by persons walking on
it. Do not overload wall outlets, as this can
result in the risk of fire or electric shock.
Never push objects of any kind into this
8.
product through housing openings because
they may touch dangerous voltage points or
short out parts, resulting in possible fire or
electric shock.
If this product does not operate normally,
9.
see the Troubleshooting section of this
manual. If you cannot resolve the problem,
or if the product is damaged, Call the AT&T
Helpline at 1-800-628-2888. Do not open the
product. Opening the product may expose
you to dangerous voltages or other risks.
During thunderstorms, avoid using tele-
10.
phones except cordless models. There may
be a slight chance of electric shock from
lightning.
Do not use a telephone in the vicinity of a
11.
gas leak. If you suspect a gas leak, report it
immediately, but use a telephone away from
the area where gas is leaking.
This product should be operated only from
12.
the type of power source indicated on the
power transformer
you are not sure of the type of power supply
to your business or home, consult your local
power company.
(see Item 13, below). If
13.
Use only a UL Listed wall plug-in power
transformer that has Class 2 outputs and
the following characteristics:
Input rating:
Output rating:
The power transformer supplied with the
product has these characteristics.
99-127 V AC rms 60 Hz
150 mA maximum
27-35 V DC at 200 mA
14-18 V DC at 200 mA
SAVE THESE INSTRUCTIONS
Introduction
The following descriptions define important
terms used in this manual.
●
The
SPIRIT® Communications System
ConnecT/R
add telephone devices to your
System. It connects to the controller.
●
The
controller
through which all
company are processed.
●
The
SPIRIT Telephone
SPIRIT
within the
You do not need a
tached to the ConnecT/R.
●
The telephone device is a modem, answering machine, standard telephone, etc., you
can add to the
ConnecT/R. You can add up to two telephone devices to a single ConnecT/R, and
use them to place and receive calls. Interac-
tions with specific
are described later in this book.
provides you with the ability to
SPIRIT
is the central processor
SPIRIT
calls in your
(with the
AT&T
logo on it) is specialized to work
SPIRIT
Communications System.
SPIRIT
SPIRIT
SPIRIT
Telephone at-
System via the
System features
Figure 1. SPIRIT ConnecT/R
The ConnecT/R allows you to add telephone
devices to your SPIRIT System in a way that
gives you much more flexibility than before.
Although it has always been possible to connect
answering machines, facsimile machines, modems, or standard telephones via the "line
auxiliary jack" on the controller, that jack restricts their access to a single telephone line
within the SPIRIT System. But since the
ConnecT/R connects to ports designed for
SPIRIT
Telephones themselves (which can
access multiple lines), the telephone devices can
function on as many telephone lines as the port
was customized to handle.
1
* SPIRIT is a registered trademark of AT&T.
2
Although you can have a
connected to the
SPIRIT
SPIRIT
Telephone
ConnecT/R, it isn't
necessary. In fact, many business uses, such as
telephones in hotel lobbies or facsimile machines with built-in telephones, will not have a
SPIRIT
Telephone attached to the ConnecT/R.
Examples of the kinds of telephone devices you
can add to your
SPIRIT
Communications
System via the ConnecT/R are:
● Standard telephones
● Cordless telephones
● Answer/record machines
● Credit card readers
● Facsimile machines
● Auto-dialers
● Modems
The devices must be
one line for operation) and
single-line
stand-alone
(requiring only
(able to
process calls without being attached to a controller or other system device).
This Onwer's Manual will help you set up your
SPIRIT ConnecT/R for your particular business
needs.
SPIRIT Telephone
(6 or 24 buttons)
308 or 1224
Controller
ConnecT/R
Data Terminal
Facsimile
Machine
Standard
Telephone
Credit
Card
Reader
Cordless
Telephone
Answer/
Record
Machine
Modem
Autodialer
Computer
Figure 2. SPIRIT ConnecT/R Applications
3
4
Installation
A complete ConnecT/R has the components
shown in Figures 3 and 4. You could have two
telephone devices attached and you do not have
to have a
SPIRIT
Telephone attached.
INSTALLATION INSTRUCTIONS
1.
Never install telephone wiring during a
lightning storm.
2.
Never install telephone jacks in wet loca-
Controller
STATION
JACK
Directly connected by a cord from one unit to the
other, or connected via a wiring run.
ConnecT/R
4-Wire Cords
tions unless the jack is specifically designed
for wet locations.
Never touch uninsulated telephone wires or
3.
terminals unless the telephone line has been
disconnected at the network interface.
Use caution when installing or modifying
4.
telephone lines.
AC
Power
Outlet
Telephone Device: Fax, Modem, Answer/Record
Machine, Telephone, etc.
SPIRIT Telephone
Figure 3. SPIRIT ConnecT/R with Attached SPIRIT Telephone and Telephone Device
Controller
STATION
JACK
ConnectT/R
4-Wire Cords
Directly connected by a cord
from one unit to the other, or
connected via a wiring run.
AC
Power
Outlet
Telephone Device: Fax, Modem, Answer/Record
Machine, Telephone, etc.
Figure 4. SPIRIT ConnecT/R without Attached SPIRIT Telephone
Step 1
— If you attach a SPIRIT Telephone
and a telephone device, set MODE for call
access priority.
NOTES:
●
If you attach more than one telephone
device to the ConnecT/R, this setting
applies to them equally.
which will have priority in any given situation.
You do this by setting MODE on the back of the
●
If you don't have a
SPIRIT
Telephone
attached, the MODE setting has no
effect.
ConnecT/R. The examples in the table on the
next page and the descriptions that follow will
help you decide which setting is appropriate for
your needs. The table is not an exhaustive list;
With the ConnecT/R, a
SPIRIT
Telephone and a
telephone device share a single connection to
the controller. Therefore, you need to establish
5
your own business needs will determine how
you set the mode. You can change the MODE
setting any time your needs change.
6
Telephone Device
Business Requirement
MODE
Corded or cordless telephone
Corded or cordless telephone located
somewhere other than the
SPIRIT
Telephone
Answer/record machine
Facsimile machine
Modem
Telephone with autodialing capability or
stand-alone dialer
Credit card reader
Autodial modem
Have another phone that acts like an extension to the
attached
Ensure privacy between the
SPIRIT
Telephone.
SPIRIT
Telephone and the
1
2,3,4
other attached phone.
Record a conversation while talking on the attached
SPIRIT
Telephone*.
Disconnect the answer/record machine when someone
picks up the
SPIRIT
Telephone.
1
2
Prevent interruption of data transmission if someone 3,4
picks up the
Prevent interruption of data transmission if someone
picks up the
Provide more memory than available from
SPIRIT
SPIRIT
Telephone.
Telephone.
SPIRIT
3,4
1
System.
Prevent interruption of data transmission if someone
picks up the
SPIRIT
Telephone.
Prevent modem from interrupting call on attached
SPIRIT
Telephone, and Telephone from interrupting
3,4
4
ongoing data call.
*
The recording of calls is governed by federal, state, and local laws. It is your responsibility to comply with all applicable
laws and regulations.
Loading...