AT&T SB3014-WM Quick Start Manual

Quick start guide

SB3014-WM
DECT 6.0 expansion wireless mic
for use with AT&T model SB3014

Congratulations

on purchasing this AT&T product.

For customer support or product information, visit our
website at www.smbtelephones.att.com or call

1 [phone]. In Canada, dial 1 [phone].

NOTES:

Charge the battery for eight hours before use.
If the wireless mic unit becomes warm when the battery is

charging, it is normal.

•

•

Install battery to the wireless mic

Risk of explosion! Batteries should not be exposed to
excessive heat such as bright sunshine or fire.
Use only the supplied battery (model BT191665).

Risque d’explosion! Le bloc-piles ne doit pas être exposé à la
chaleur excessive telle que la lumière du soleil ou au feu.

N’utilisez que la pile incluse (modèle BT191665).

•

•

•

•

1. Place the battery with the label THIS SIDE UP facing

up onto the battery compartment.

2. Slide the battery door until it clicks into place.

3. Place the wireless mics on
the charging cradles until
they are flush.

Register the wireless mic

You should register your new wireless mic to the base unit
by following the instructions, as mentioned below.

To register the wireless mic

As part of this process, all existing, broken, or misplaced
wireless mics will be deregistered first. Then, the base unit
will re-register the four wireless mics that are placed on
the charging cradles.

Before registration, unplug the telephone line cord from
the wall jack to make sure there are no incoming calls
during registration.

Gather the new wireless mic together with the other
three wireless mics that are to be registered, then
place them on the charging cradles. Registration has
not yet started.

Enter 331734 on the base unit when it is not in
use, then press . The screen displays Please place
all wireless mics on cradle, then press ‘SELECT’.

Make sure all the four wireless mics are on the
charging cradles, and then press . The wireless mics
enter the deregistration mode, and the screen displays

Processing...

Registration starts after deregistration completed. The
screen displays Registering... 1 2 3 4. The number X
blinks while registering the X-th wireless mic. You hear a
confirmation tone when each wireless mic is registered.
When all the four wireless mic are registered, the base unit
displays Registration done.

1.

2.

3.