AT&T PBH20 User Manual

Page 1
Bluetooth®/Wired Headphones
Bluetooth® Headphones
user’s manual
model #: PBH20
Page 2
Page 2
Thank you for purchasing the AT&T Bluetooth
®
/wired headphones
[PBH20].
Bluetooth® Headphones
Features
Bluetooth 2.1 technology with amazing sound
Built-in microphone with echo cancellation
Full controls for playback and calls
Portable folding design
3.5 mm auxiliary input jack
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc.
hello.
Page 3
What’s Included
Micro USB Cable Audio Cord
Unpack the Bluetooth® headphones and make sure all accessories are put aside so they will not be lost.
Bluetooth Headphones
Page 3
Contents
Page 4
Introduction
What’s Included
Safety Information
Getting Started
Location of Main Unit Controls
Operational Instructions
Charging
Power ON/OFF
Pairing
Making Phone Calls
Listening to Music
Troubleshooting
Compliance with FCC Regulations
Warranty Information
Specifications
2
3
5
6
7
7
7
8
9
10
12
13
14
Page 5
Contents
Safety Information
Important Safety Instructions
1. ATTACHMENTS - Do not use attachments not
recommended by the manufacturer.
2. WATER AND MOISTURE - The unit should not be used near
water. For example: near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement.
3. VENTILATION - The unit should be situated so that its
location or position does not interfere with its proper ventilation. For example, it should not be situated on a bed, sofa, rug or similar surface that may block ventilation openings. Also, it should not be placed in a built-in installation, such as a bookcase or cabinet, which may impede the flow of air through the ventilation openings.
4. OBJECTS AND LIQUID ENTRY - Care should be taken so that
external objects do not fall into and liquids are not spilled onto any openings or vents located on the product.
5. POWER SOURCE - The unit should be connected only
to a power supply of the type described in the operating instructions or as marked on the unit. If you are not sure, please consult the dealer or local power company.
6. HEAT - The unit should be situated away from heat sources
such as radiators, heat registers, stoves or other appliances (including amplifiers) that produce heat.
7. SERVICING - The user should not attempt to service the
unit beyond those methods described in the user’s manual. Opening or removing covers will expose you to dangerous voltage and other hazards. Service methods not covered in the user’s manual should be referred to qualified service personnel.
Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in this user’s manual and on the PBH20.
Page 4
Page 6
Getting Started
Location of Main Unit Controls
1. ON/OFF / Pairing / Play / Pause
2. Previous song / Volume-
3. Next song / Volume +
4. Answer / Disconnect / Redial
5. Microphone
6. AUX-In Jack
7. LED indicator light
8. Micro USB charging port
2
3
4
1
6
7
8
5
Page 7
Operational Instructions
Charging
Charge your PBH20 through any USB jack or wall charger. A red LED indicator will light up when charging. Before using for the first time, charge at least 4 hours. After the first charge, the headset will charge in 2 to 3 hours and the LED indicator will stop blinking when the charge is complete.
Note: When the battery is fully charged, the LED indicator will
turn off.
Power ON/OFF
Press and hold the ON/OFF button for 1 second to switch the headset on. The LED will flash white when powered on. Press and hold the ON/OFF button for 3 seconds to switch the headset off. When powering off, the white LED light will stop flashing and then turn off.
Pairing
While the headset is off, press and hold the ON/OFF – Bluetooth Pairing buttons for 5 seconds to start pairing mode. Once the headset is in the pairing mode (the LED will start flashing white), select ‘LHB15’ among discovered Bluetooth devices on the phone. If requested, enter the password ‘0000’ to pair the headset. When connected, you will hear a beep and your mobile device will show “Paired”.
Note: If the headset is not pair with any Bluetooth device in 3
minutes, it will turn itself off.
Page 5
Page 8
Operational Instructions
Making Phone Calls
Making a call
Once paired, use your mobile device to dial a number as usual. Once connected, the call will be heard on your PBH20 headset.
Last number redial Double press the Answer / Disconnect /Redial button to redial
last number.
Answer a call When receiving a call, press the Answer / Disconnect /Redial button to answer the call.
Ending a call While talking on the phone, press the Answer / Disconnect / Redial button to end the call.
Rejecting a call While receiving a call, press and hold the Answer / Disconnect / Redial button to refuse the call.
Volume control Use the Volume +/ Volume - buttons to adjust the volume level.
Page 9
Operational Instructions
Listening to Music
Play/Pause
Press the Play button to launch the phone’s music player and to start listening to music. While listening to music, press the Pause button to pause or to resume play.
Song Selection While music is playing, press the Next Song or Previous Song
buttons to select songs.
Answer a call while listening to music When receiving a call, press the Answer / Disconnect /Redial button to answer the call. Press the Answer / Disconnect /Redial
button while on the phone to end the call. When receiving a call, press and hold the Answer / Disconnect /Redial button to reject the call. (Music will resume playing when the call is rejected.)
Volume control Press and hold the Volume + and Volume - buttons to adjust the volume level.
Blinking white light
Status
Powering ON
Powering OFF
Low battery
Charging
Pairing mode
Connection complete
Incoming call & on the phone
Playing music
LED indicator
LED turns off
Blinking red & headset emits a beep
Solid red light
Blinking white light
White light blinks every 3 seconds
Solid white light
White light blinks every 3 seconds
LED Indicator Chart
Page 6
Page 10
Troubleshooting
Symptom
Music is not streaming over Bluetooth
PBH20 does not answer phone calls
Music does not resume after ending a call
Not able to control music from the PBH20
No power
Solution
Make sure the PBH20 is fully charged.
Check to make sure both devices are paired and connected over Bluetooth.
Restart the PBH20 to auto-connect with your Bluetooth device.
Check to make sure both devices are paired and connected over Bluetooth.
Restart the PBH20 to auto-connect with your Bluetooth device.
Press play to resume music.
Check and make sure your mobile device supports Bluetooth A2DP profile.
Page 11
Contents
Compliance with FCC Regulations
The equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate Radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to Radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to Radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from which the receiver is connected.
- Consult the dealer or an experienced Radio/television technician for
assistance.
This equipment complies with FCC’s RF radiation exposure limits set forth for an uncontrolled environment. The antenna(s) used for this transmitter must be installed and operated to provide a separation distance of at least 20 cm from all persons and must not be collocated or operating in conjunction with any other antenna or transmitter. Installers must ensure that 20 cm separation distance will be maintained between the device (excluding its handset) and users.
THE SPECIFICATION AND EXTERNAL APPEARANCE OF THE HEADPHONES ARE SUBJECT TO CHANGE WITHOUT PRIOR NOTICE.
The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
If at any time in the future you should need to dispose of this product, please note that waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your local authority or retailer for recycling advice.
Caution!
Page 7
Warranty Information
Page 12
Limited Warranty
The AT&T brands are used under license. Any repair, replacement, or warranty service, and all questions about this product should be directed to Concept 101 LLC at www.att.com/electronics or call 1 (888) 920-8680 from the USA or Canada.
Concept 101 LLC warrants to the original purchaser that the product will be free from defects in material, parts and workmanship for the period designated for this product. The warranty commences the day the product is purchased and covers up to a period of one (1) year. Concept 101 LLC agrees that it will, at its option, replace the defective product with either a new or remanufactured headset equivalent to your original purchase during the warranty period. Should the Parts warranty period exceed the Labor warranty period, Concept 101 LLC will supply at no charge for the remainder of the Parts warranty, any new or remanufactured replacement parts as required by the product. During this period all labor and service charges will become the responsibility of the customer.
Exclusions: This warranty does not apply to the appearance or exterior
of the product which may have been damaged or defaced, altered or modified in design or construction. This warranty does not apply if the serial number is altered or removed, or if there is any damage due to power line surge, user damage to the AC power cord, connection to improper voltage source, general misuse, accidents, or repair attempts by unauthorized service agents. Other exclusions include ear pads, rechargeable and non-rechargeable batteries.
REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE CUSTOMER; Concept 101 LLC SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF ANY EXPRESS OR IMPLIED WARRANTY ON THIS PRODUCT, EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW. ANY IMPLIED WARRANTY OF MERCHANTABILITY OF FITNESS FOR A PARTICULAR PURPOSE ON THIS PRODUCT IS LIMITED TO THE DURATION OF THE WARRANTY.
Some states do not allow the exclusion or limitations of incidental or consequential damages, or limitations on how long the warranty lasts. In these cases the above exclusions or limitations may not apply to you. This warranty gives you specific legal rights and you may also have other rights which vary from state to state.
Page 13
Warranty Information
Obtaining Service: To obtain service, product literature, supplies or
accessories please call 1 888-920-8680, or visit our website, www.att.com/electronics, to create a ticket for exchange/repair. Please make sure to provide the date of purchase, model number and a brief description of the problem. Our customer service representative will contact you or send detailed return instructions.
Concept 101 LLC does not warrant that the headset will work properly in all environmental conditions, and makes no warranty and representation, either implied or expressed, with respect to the quality, performance, merchantability, or fitness for a particular purpose other than the purpose identified within this user’s manual. Concept 101 LLC has made every effort to ensure that this user’s manual is accurate and disclaims liability for any inaccuracies or omissions that may have occurred. Information in this user’s manual is subject to change without notice and does not represent a commitment on the part of Concept 101 LLC. Concept 101 LLC reserves the right to make improvements to this user’s manual and/or to the products described in this user’s manual at any time without notice. If you find information in this manual that is incorrect, misleading, or incomplete, please contact us through our website.
Page 8
Page 14
Specifications
- Bluetooth 2.1
- Bluetooth compatibility: Bluetooth 2.0 or above device with
A2DP/AVRCP/HFP/HSP
- Working distance: Up to 30 ft.*
* Up to 30 ft. wireless range as determined by Bluetooth SIG.
Range may vary depending on the line of sight obstacles.
Page 15
Contents
Memo
purchase date:
place of purchase:
Page 9
© 2016 Concept 101 LLC. All Rights Reserved. AT&T and the AT&T logo are trademarks of AT&T Intellectual Property licensed to Concept 101 LLC, New York, New York 10018. Issue 4.0 AT&T 5/2016.
www.att.com/electronics
Loading...