AT&T 5860 Quick Start Guide

Quick reference guide

Copyright © 2004 Advanced American Telephones. All Rights Reserved.

AT&T and the Globe Design are trademarks of AT&T Corp.,

licensed to Advanced American Telephones.

Answering system controls

ON/OFF ..................Press to turn answering system on or off.

DELETE ..................Press to delete message currently playing.

TIME SET................Press to set the answering system clock.

MENU......................Press to review or change answering system options.

CHANGE ................Press to change a menu option.

RECORD ................Press to record a memo or outgoing announcement.

Telephone function keys

SOFTKEYS ............Press to select menu item displayed just above the key.

CLEAR ....................Press to cancel an operation, back up to the

previous menu, or exit the menu display.

INTERCOM ............

Press to transfer a call or initiate an intercom conversation.

FLASH ....................During a call, press to receive an incoming call, if

Call Waiting is activated.

VOLUME ................Press to adjust speakerphone listening volume.

MUTE ......................Press to silence microphone; press again to resume.

SPEAKERPHONE....

Press to turn speakerphone on or off (answer or end a call).

Base/Speakerphone

Answering
system
controls

Telephone
function keys

Swivel antenna fully
upright for best results.

REDIAL MENU MEM

Press to play or stop playing messages.

Press to repeat message.
Press twice to hear
previous message.

Press to skip to next
message.

ATT-5860QSG-d3.qxd 1/18/2004 3:56 PM Page 1

Quick Start Guide

5.8 GHz Cordless
Telephone/Answering
System E5860

with Caller ID & Call Waiting

ATT-5860QSG-d3.qxd 1/18/2004 3:57 PM Page 2

Installation and setup

Connect the base and install batteries as shown below. After installation, place the
handset in the base and allow the battery to charge for 12 hours before use. You can
keep the battery charged by returning the handset to the base after each use.

Place handset in base to charge
for 12 hours before first use.

Rotate antenna to fully upright
position.

Press coin into slot on
base of handset to
release latch, then
remove battery cover.

Insert supplied
batteries.

Insert top
tab first.

To replace battery cover

Press down to
click in place.

Plug power cord
transformer into
electrical outlet.

Plug long telephone
line cord into
telephone jack.

Route cords through
slot in base.

Caution: Use only the supplied
NiMH battery (80-5461-00-00) or
AT&T model 2AA NiMH replace­ment battery (SKU 26820). Do not
use alkaline batteries.

ATT-5860QSG-d3.qxd 1/18/2004 3:57 PM Page 3

Quick reference guide

NavKey

Press center button to display menus.
Press NavKey buttons to navigate
through menus. Press center button to
select menu item highlighted.

Speaker

Press to activate handset speaker­phone. Press again to switch call back
to earpiece.

Softkeys

Press a softkey to select a menu item
displayed just above the key.

Off/Cancel

During a call, press to hang up.

While using menus, press to cancel an
operation, back up to the previous menu,
or exit the menu display.

Phone/Flash

Press to begin a call, then dial a number.

During a call, press to receive an incoming
call, if Call Waiting is activated.

Sound Select

Press to customize speaker sound for
clear speakerphone conversations.

Handset

Intercom

Vibrate Ringer Control Ringers

Low Batt Tone Keypad Tone Range Tone

Clock On/Off Set Time Contrast

Phone Setup Language Reset Settings

Directory Calls Log Pictures Sounds&Alerts Settings

Main menu

Sounds & Alerts menu Settings menu

Left Right

Select

Up

Down

ATT-5860QSG-d3.qxd 1/18/2004 3:57 PM Page 4