ATO Aerielle AudioBUG User Manual

Aerielle 'Bug' Transmitter

Manual

Introduction

Thank you for purchasing the AudioBUG™ from ATO. AudioBug™ is a
user-friendly portable wireless audio system that lets you enjoy your music
collection while on the go.

Audio BUG features Aerielle’s ™ patented wireless technology to send
high-fidelity stereo audio signals from any audio device to any radio or
stereo within range up to 15 feet. Simply plug the AudioBUG™ into any
audio output source, choose one of the four frequencies (88.1, 88.3, 88.5 or

88.7 MHz) that you wish to broadcast and tune your radio to that frequency.
AudioBUG™ gives you the freedom to enjoy your audio where you want,
with out the wires.

Before You Begin

Read these instructions thoroughly before setting up your AudioBUG™. If
you need any assistance, please contact customer service department at:
1-866-959-5999, or submit an email request to:

[e-mail]

Compatibility

One of the many unique features of AudioBUG™ is that it was designed to
work with any portable audio device. This means that no matter what brand
or size of audio player you may have, AudioBUG™ is compatible. Typical
uses for AudioBUG™ include:

Portable MP3 digital audio players
Portable CD players
Portable Mini-disc players
Portable DVD players
Laptop or Desk Top Computers

AudioBUG™ is not only compatible with every audio player, but it will
broadcast to any radio or stereo. Whether it is your surround sound stereo
system in your fa mily or living room or on your car stereo, AudioBUG™
just plugs and plays.

AudioBUG™ Features and Components

1. Power on

2. Frequency Selector

3. 3.5 mm stereo cable

4. Battery Compartment “CR2”

< Insert Photo of AudioBUG with markings and descriptive indications (i.e.
arrows etc. >

Auto-Off Functionality

The AudioBUG™ has an auto -off feature. If after more than 80 seconds
there is no detection of audio, the AudioBUG™ will turn off. This saves
useful battery life. When turning off your audio source, your AudioBUG™
turns off automatically.

Setup Procedure

Setting up your AudioBUG™ is an easy procedure. Simply:

1) Remove the battery cover from the top of unit by gently sliding the
battery door marked toward you.

2) Install 1 CR2 battery with the negative end facing the eyes of the

AudioBUG™.

3) Plug the 3.5mm stereo cable into the audio out connector or the

headphone jack of the audio source you wish to transmit. *

4) Select the frequency that you wish to transmit to with the selector on

the side of the AudioBUG™ (88.1, 88.3, 88.5, 88.7 MHz)

5) Press the POWER button eye (left EYE) on the front of the unit.