ATN OTS-30, OTS-60 Operator's Manual

ATN OTS-30

ATN OTS-60

THERMAL IMAGING SYSTEM

o p e r a t o r ’ s m a n u a l

Important Export Restrictions! Commodities, products,
technologies and ser vices contained in this manual are
subj e c t to one or more of the expor t control laws and
regulations of the U.S. Government and they fall under the
control jurisdiction of either the US Department of State
or the US BIS-Depar tment of Commerce. It is unlawful
and strictly prohibited to export, or attempt to export or
otherwise transfer or sell any hardware or technical data
or fur n ish any service to any foreign person, w hether
abroad or in the United States, for which a license or written
approval of the U.S. Government is required, without
first obtaining the required license or written approval
from the Depar t m ent of the U.S. Government h aving
jurisdiction. Diversion contrar y to U.S. law is prohibited.

Manual (OTS-30, OTS-60 ver. 2011) Revision 1 - 2011

The information in this manual furnished for information use only, is subject to
change without notice, is not to be construed as a commitment by ATN Corp.
ATN Corp. assumes no responsibility or liability for any errors or inaccura­cies that may appear in this book.

© 2011 ATN Corp. All right reserved.

SAFETY SUMMARY

STUDY CAREFULLY THIS MANUAL BEFORE TURNING ON
AND OPERATING THIS PRODUCT.

CAUTIONS

The ATN OTS-30 and ATN OTS-60 thermal imaging systems
are precision optical-electronic instruments and requires care­ful handling. To provide safe use of the systems the following
instructions should be observed:

• Do not dismantle the device.

• Keep the device clean; protect it from moisture, sharp tem­perature drops and shocks.

• Be careful not to touch the glass surfaces. If you put finger­prints on, or contaminate the glass surfaces, use only clean
and soft materials to clean it.

• Do not leave the device in on position during stops in opera­tion.

• Remove the battery from the device for the period of stor­age.

CAUT ION :

This producT conTains naTural rubber laTex which

may cause allergic reacTions

a

WARNING

Do not permanently attach the camera to dynamic-mount applica­tions that continuously transmit vibration (such as on vehicles or
heavy machinery).

WARNING

Do not point the camera directly at any high-intensity objects that
you must not view with your eyes (such as the sun or a welding
arc). If you do, you will damage the camera.

WARNING

Operating OTS outside of its specified operating temperature
range or voltage range can cause permanent damage and will
void the warranty.

WARNING

Use the power button to turn the camera off before you remove
power (remove batteries).

WARNING

OTS operates over a wide operating temperature range (-30°C
to +60°C). Not all AA batteries are specified over this same tem­perature span. Check the manufacturer’s specifications of your
selected battery to verify the valid temperature range.

WARNING

Do not use any battery other than a CR-123A lithium battery. DO
NOT use any battery(ies) providing a (combined) voltage greater
than 3.0 volts.

WARNING

Do not install batteries of different types (lithium with lithium-ion
rechargeable). All batteries must be of the same type.

WARNING

Always replace ALL 2 batteries. If you install new batteries with
used batteries, the result may be dangerous.

b

WARNING

Do not replace batteries in a possibly explosive environment,
such as a gas station (or any place where you must turn off your
vehicle engine). If you do, sparks can cause an explosion.

WARNING

Remove the batteries before you store the camera for extended
periods (2 weeks or more).

WARNING

Do not carry batteries in pockets containing metal objects such as
coins, keys, etc. Metal objects can cause the batteries to short cir­cuit and become very hot. In the case of lithium batteries, a short
circuit could cause them to explode.

WARNING

Observe battery manufacturer’s guidelines for safe handling and
proper disposal of batteries.

EQUIPMENT LIMITATIONS

• The OTS detector spectral band (7 to 14 mkm) provides a better
penetration through smoke, smog, dust, water vapor etc.

• Infrared radiation does not travel through glass and therefore the
scope does not sense objects if they are behind a glass window.

c

TABLE OF CONTENTS

pg.

SECTION I. INTRODUCTION 1-1

1.1 General Information 1-2

1.1.1. Scope 1-2

1.1.2. Reports 1-2

1.1.3. Storage 1-2

1.1.4. Warranty Information 1-3

1.2. Description and Data 1-5

1.2.1. Description 1-5

1.2.2. OTS Standard Components 1-6

1.2.3. OTS Optional Components 1-8

1.2.4. Specifications 1-8

1.2.5. Mechanical Functions 1-9

1.2.6. Optical Functions 1-10

1.2.7. Electrical Functions 1-10

SECTION II. ASSEMBLY AND PREPARATION 2-1

2.1. Preparation 2-2

2.1.1. Preparation for use 2-2

2.1.2. Examination for operation 2-3

2.2. Assembly 2-4

2.2.1. Video Output 2-4

2.2.2. 2X Afocal Lens 2-4

SECTION III. OPERATION 3-1

3.1. General Information 3-2

3.1.1. General 3-2

3.1.2. Controls 3-2

3.2. Operating procedure 3-3

3.2.1. Turning On 3-3

3.2.2. Focusing 3-3

3.2.3. Polarity and Color Modes 3-4

3.2.4. Brightness 3-4

3.2.5. E-Zoom 3-4

i

3.2.6. Recalibrate Switch 3-4

3.2.7. Shut Down Operations 3-4

SECTION IV. MAINTENANCE INSTRUCTIONS 4-1

4.1. Preventive Maintenance Checks
and Services (PMCS) 4-2

4.1.1. Purpose of PMCS 4-2

4.1.2. Frequency of Performing PMCS 4-2

4.2. Troubleshooting 4-4

4.2.1. General 4-4

4.2.2. Troubleshooting Procedures 4-4

4.3. Maintenance Procedures 4-6

4.3.1. Scope Maintenance 4-6

4.3.2. Cleaning Procedures 4-6

4.3.3. Preparing for Extended Storage 4-7

Appendix A. Spare Parts List A-1

ii

iii

SECTION I

INTRODUCTION

1-1

1.1 GENERAL INFORMATION

1.1.1. SCOPE

This manual contains instructions for use in operating and main­taining the ATN OTS-30 and ATN OTS-60 thermal imaging sys­tems. Throughout this manual, the ATN OTS-30 and ATN OTS-60
will be referred to as the scope or OTS.

1.1.2. REPORTS

Reports from the user on recommendations for improvements are
encouraged. Send reports to the address below.

American Technologies Network Corp.

1341 San Mateo Avenue

South San Francisco, CA 94080

[phone]
[phone]

[phone] fax

[e-mail]

www.atncorp.com

1.1.3. STORAGE

Storage of OTS should be done in the factory packing and after a
thorough PMCS as outlined in Section 4.1. of this manual. This will
ensure the scope remains in mission ready condition during stor­age. Battery should be stored separately from the scope.

The scope should not be placed on the floor, in any area exposed
to high temperatures or direct sunlight. Presence of acid and al­kaline vapor, as well as of other aggressive admixtures in the air
is unacceptable.

1-2

1.1.4. WARRANTY INFORMATION

ONE YEAR PRODUCT WARRANTY

This product is guaranteed to be free from manufacturing defects in material
and workmanship under normal use for a period of 1 (one) years from the date
of purchase. In the event a defect that is covered by the foregoing warranty
occurs during the applicable period stated above, ATN, at its option, will either
repair or replace the product, and such action on the part of ATN shall be the
full extent of ATN’s liability, and the Customer’s sole and exclusive remedy.
This warranty does not cover a product (a) used in other than its normal and
customary manner; (b) subjected to misuse; (c) subjected to alterations, modi­fications or repairs by the Customer of by any party other than ATN without
prior written consent of ATN; (d) special order or “close-out” merchandise or
merchandise sold “as-is” by either ATN or the ATN dealer; or (e) merchandise
that has been discontinued by the manufacturer and either parts or replace­ment units are not available due to reasons beyond the control of ATN. ATN
shall not be responsible for any defects or damage that in ATN’s opinion is
a result from the mishandling, abuse, misuse, improper storage or improper
operation, including use in conjunction with equipment which is electrically
or mechanically incompatible with or of inferior quality to the product, as well
as failure to maintain the environmental conditions specified by the manufac­turer. This warranty is extended only to the original purchaser. Any breach of
this warranty shall be waived unless the customer notifies ATN at the address
noted below within the applicable warranty period.

The customer understands and agrees that except for the foregoing warranty,
no other warranties written or oral, statutory, expressed or implied, including
any implied warranty of merchantability or fitness for a particular purpose,
shall apply to the product. All such implied warranties are hereby and express-

ly disclaimed.

LIMITATION OF LIABILITY

ATN will not be liable for any claims, actions, suits, proceedings, costs,
expenses, damages or liabilities arising out of the use of this product. Op­eration and use of the product are the sole responsibility of the Customer.
ATN’s sole undertaking is limited to providing the products and services
outlined herein in accordance with the terms and conditions of this Agree­ment. The provision of products sold and services performed by ATN to
the Customer shall not be interpreted, construed, or regarded, either ex­pressly or implied, as being for the benefit of or creating any obligation
toward any third party of legal entity outside ATN and the Customer; ATN’s
obligations under this Agreement extend solely to the Customer. ATN’s li-

ability hereunder for damages, regardless of the form or action, shall

1-3