ATN TIBNBX4381L, BinoX 4T 1.25-5x, BinoX 4T 2-8x, BinoX 4T 2.5-25x, BinoX 4T 1.5-15x User Manual
...
ATN BinoX 4T Series
THERMAL SMART HD BINOCULAR
WITH BUILTIN LASER RANGEFINDER
MANUAL
BINOX 4T USER’S GUIDE
AMERICAN
TECHNOLOGIES
NETWORK
CORP.
DIOPTER ADJUSTMENT
DOWN BUTTON
OK BUT TON
UP BUTTON
FOCUS ADJUSTMENT
TABLE OF CONTENTS
Features ............................................4
Application ..........................................4
Specifications .......................................5
Preparing the device ..................................6
Unpacking .......................................6
Charging the device ................................6
Micro SD and USB C ports ...........................6
Firmware update ...................................7
POWER BUTTON
ON/OFF .........................................8
Using your keypad .................................8
Focusing .........................................8
Mounting on a tripod ................................9
Compass calibration ................................9
Interface ...........................................10
Homescreen .....................................10
RIG HT ARROW BUT TON
LEFT A RROW BUT TON
Main operations ..................................11
Modes ..........................................12
Shortcut Carousel .................................12
Using System Settings .............................13
Functions ..........................................15
Photo Mode .....................................15
Video Recording ..................................15
Laser Rangefinder ................................15
LRF Preview .....................................16
BIX Technology ..................................16
How to perform a NUC .............................16
USB T YPE-C AND
MICR OSD PORT S COVER
Pixel Correction Procedure ..........................17
System settings .....................................18
Thermal ........................................18
Photo/Video .....................................18
Display .........................................18
Settings ........................................19
Warnings and cautions ...............................20
CAUTION!
THIS PRODUCT CONTAINS NATURAL RUBBER LATEX WHICH MAY CAUSE ALLERGIC RE ACTIONS
The information in this manual is furnished for informational use only, is subject to change without notice,
is not to be construed as a commitment by ATN Corp.
ATN Corp. assumes no responsibility or liability for any errors or inaccuracies that may appear in this book.
©2019 ATN Corp. All right reserved.
2 3
Mobile applications ..................................20
3 year product warranty ..............................21
FEATURES
SPECIFICATIONS
RECORD VIDEO BUILT-IN MICROPHONE
WIFI DUAL STREAMING
BLUETOOTH
OBSIDIAN USER
INTERFACE
SHARE ON SOCIAL MEDIA
THROUGH APP
SMOOTH ZOOM COLOR MODES
E-COMPASS
ULTRA LOW POWER
CONSUMPTION
3D GYROSCOPE DUAL CORE PROCESSOR
3D ACCELEROMETER
SIMPLE TOGGLE SWITCH
OPERATION
LASER RANGE FINDER
APPLICATION
ATN has created a new series of thermal binoculars that offers the user a
profound new technological experience! The new ATN BinoX 4T series delivers a superior value by providing ATN SMART HD features and an improved
thermal imaging sensor that exceeds expectations. Plus, the new integrated
laser rangefinder is the ace in the hole for your game recovery or search and
rescue efforts.
This thermal binocular gives you the convenience of thermal imager, allowing you to see what is behind every bush or tree, or in every field. With the
speed and efficiency that you want in a good pair of a quality binoculars, this
functional dual-purpose optic is perfectly paired with an angle compensated
laser rangefinder. Making this optic the must-have device of the season for
spotting or recovery. Elevating your hog hunts and stalking efforts and giving
you the adaptability in the field that you have been wanting!
The new internal battery provides up to 15+ hours of battery life, and the other included features will aid in your recovery efforts and keep you target ready!
The ATN BinoX 4T comes in both 384x288 and 640x480 configurations and is
equipped with the most advance thermal sensors, providing a sharp and clear
thermal image. Easily scan for heat signatures to detect even the smallest of
animals in deep cover or concealed by fog. Record video and take photos directly to your micro SD card to share with friends and family or on social media.
This classic tool is also ergonomically designed and includes a neck strap
for ease of use and comfort while in the field. No more guessing how far to your
target is for dope corrections, use the built in E-Compass and laser rangefinder to know the direction and distance you need to travel in the field. The control
keypad is simple to use and easily manipulated with a one hand, leaving your
other hand free and target ready.
The ATN BinoX 4T Smart Thermal Binoculars is the optic you wanted and
have waited for. Whether it is for search and rescue efforts, or for game recovery, these thermal vision binoculars come with more features than you will
know what to do with at first, but soon you won’t know how you’ve lived without
them. ATN is The Future of Optics!
4 5
Item #
Sensor
Magnification
Field of view
Display Resolution
Interpupillary
adjustment range
Eye relief
Focus Range
Laser Rangefinder
Video Record Resolution
IP rating
Charging
WiFi (Streaming, Gallery,
& Controls)
Bluetooth
3D Accelerometer
3D Gyroscope
3D Magnetometer
E-Barometer
Smart Rangefinder
E-Compass
Smooth Zoom
Microphone
Micro SD Card
Battery life (Li-ion)
Human Detection Range
Human Recognition
Range
Human Identification
Range
Dimensions
Weight
Warranty
* ATN reserves the right to change the above specifications at any time without notice.
BinoX 4T
1.25-5x
TIBNBX4381L TIBNBX4382L TIBNBX4384L TIBNBX4641L TIBNBX4642L TIBNBX4643L
1.25-5x 2-8x 4.5-18x 1-10x 1.5-15x 2.5-25x
16°
×
750 m 960 m 1800 m 830 m 1050 m 1950 m
335 m 480 m 720 m 350 m 530 m 800 m
205 m 300 m 430 m 225 m 330 m 475 m
BinoX 4T
2-8x
384x288 640x480
12.5° 12°×9.5° 6x4.7° 32°×25° 24°×19° 12.5°×9.7°
BinoX 4T
4.5 -18x
1280x960 @ 60 fps
Weather Resistant
9.4” x 5” x 2.6” / 240 x 128 x 67 mm
BinoX 4T
1-10x
1280x720x2
60-70 mm
10-30 mm
10 ft to infinity
Yes
USB, type C
iOS & Android
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
4 to 64 GB
15+ hrs
2.5 lb / 1.12 kg
3 years
BinoX 4T
1.5-15 x
BinoX 4T
2.5-25x
Do not force the microSD Card into the
PREPARING THE DEVICE
UNPACKING
The following steps must be performed before using the device.
1. Open packaging box, remove BinoX 4T.
2. Verify your box has the following: Optic, Optic Cover, Sunshade, Rubber
Eye Piece, Charging Cable.
3. Inspect the device for damage to optical surfaces, body, eyecups, operation buttons, etc.
4. Ensure that all optical surfaces are clean and ready for use.
NOTE
If any accessories are missing or broken contact ATN’s Customer Ser-
vice at 1.800.910.2862.
CHARGING THE DEVICE
The device is equipped with a USB (type C) port. You will find it under the
rubber cap on the right side of the device (caps are marked with appropriate
icon).
We have included a USB (type C) charging cable with your binocular. Plug
the cable into a USB wall charger that has an output of 2 amps (Wall Charger
not included).
Charge your binocular for 6 hrs using a 2A USB wall charger. Note using a
wall charger with lower amperage will take longer to charge your binocular.
1. Recommended charger is 2A USB charger.
2. Battery charging time (from 0 to 100%) is 6 hours with 2 A USB charger.
3. Battery run time is 15+ hours on a single charge.
MICRO SD AND USB C PORTS
The device is equipped with a microSD Card and USB (type C) ports. You
can find them under the rubber caps on the right side of the device (we marked
the caps with appropriate icons).
USB,type C
MicroSD
6 7
To open the rubber port cover, gently lift
the rubber cover and move it out of the way.
NOTE
Make sure that the device is turned off
before inserting the formatted microSD
Card into its assigned port.
1. Always format a new microSD card be-
fore using.
2. Insert microSD card as shown.
3. Use a thin object (small coin, paper clip)
to lock the microSD card in place after inserting it into the slot.
4. Return the cover to its original position.
NOTE
There is only one correct direction to
insert the microSD Card.
port doing so may cause damage to both
the binocular and the card itself.
To remove the microSD Card from the
port, push the card slightly in using the
same thin object you did before. When the
card pops up a few millimeters, pull the card
out with your fingers or tweezers.
NOTE
If you are going to record video, the microSD Card should be a Class 10 (10 Mb/
sec) or faster and have capacity from 4 to 64
Gb that is an HC type SD card.
FIRMWARE UPDATE
Before operating your device, update the firmware to the latest version. All
firmware updates can be found on at https://www.atncorp.com/firmware.
To receive a notification concerning new firmware updates, please register
your device on our website. An email notification will be sent when a new firmware update becomes available.
To update the firmware you will need a microSD Card and fully charged internal battery.
NOTE
In the event of a power failure during an update, the device may crash.
This will corrupt the system files and the device will need to be sent back
to the ATN factory for service.
To ensure your zero coordinates are not lost, write down your zero coordinates before continuing to update the firmware.
Update the new firmware as follows:
1. Download the ***.bin file and copy
to your microSD Card — root directory.
2. Insert the card into the binocular.
3. Turn ON the binocular.
4. In the “Firmware Update” dialog box
select “Yes” to start the update.
5. When the update counter reaches
“100%” the device will automatically restart.
6. Once the device is powered up it will enter self configuration mode.
7. After completing it will automatically restart.
8. Motion Sensing platform will be configured when first turned on.
9. Once the Firmware update completes, please do a factory reset before
using the product.
10. Please delete the Firmware file off of the microSD card after the process
is complete. Or the system will try to update the Firmware every time you
turn the binocular on.
NOTE
If the device does not restart within 30 seconds, press and hold the
power button for 15 seconds and the binocular will turn off.
Loading...