ATM SB-24 Data Sheet

S T E E R A B L E S U S P E N S I O N S Y S T E M

SwivelBeam

Suspension and Aiming for Single Cabinets

STEERABLES

The SwivelBeam is an easy to

use load-rated and off the shelf

loudspeaker rigging and aiming system

from single loudspeakers to full line arrays.

It is ideal for aiming sound in left and right

of house configurations and provides side

and backfills where speakers cannot be

wall mounted.

The upper cross arm of the SwivelBeam rigs from two overhead suspension points. The lower cross arm supports the loudspeaker and rotates relative to the upper section, horizontally, up to 360°.

S P E C I F I C A T I O N S :

Material:

Finish:

Color:

Working load limit:

Design factor:

Pack count:

D I M E N S I O N S :

Alloy structural steel tube

Powder coat paint

Black

250 lbs.

5:1 ratio

1/carton

This gives the installer precise horizontal aiming of sound.

For precise vertical aiming, a self-contained pull back point is offered to tilt & secure the

cabinet located behind the lower cross arm.

Typical venues include theatres, churches,

school auditoriums, gymnasiums,

sport arenas, meeting halls and theme

park attractions.

O P T I O N A L A C C E S S O R I E S :

1. Wire Rope Supplies

Eyebolts, Shackles, Turnbuckles

Beam Clamps, Swivel Rings, Truss Clamps

A division of:

ADAPTIVE TECHNOLOGIES GROUP

1637 E. Burnett Street Signal Hill, CA 90755 USA PH: 562.424.2200 FX: 562.424.1127

Front View

O N E - W A Y - A R R A Y D I M E N S I O N T A B L E

Part Number A B C D E

SB-10 10.0” 13.0” 6.0” 8.5” 4.86”

SB-14 14.0” 17.0” 6.0” 8.5” 4.86”

SB-18 18.0” 21.0” 6.0” 8.5” 4.86”

SB-24

SB-30

SB-38

24.0” 27.0” 6.0” 8.5” 4.86”

30.0” 33.0” 6.0” 8.5” 4.86”

38.0” 41.0” 6.0” 8.5” 4.86”

w w w. a

y w a r e . c o m

Standard Pull-Back

Conﬁguration

S U S P E N S I O N S O L U T I O N S

ALWAYS USE SAFETY CABLES.MADE IN THE USA

S T E E R A B L E S U S P E N S I O N S Y S T E M

SwivelBeam

Suspension and Aiming System

STEERABLES

10/14/06 Version 27

S W I V EL B E A M S W IVEL BE A M

W I T H S I N G LE T I L T K I T

The SwivelBeam offers permanent eye

fittings and a rear extended eye fitting for

use as a pull back. The tops of loudspeakers

are suspended under the lower eye

fittings with two wire rope assemblies

and a third wire rope is attached between

a back point of the loudspeaker and

the extended eye fitting, of the lower cross

arm tilting the loudspeaker downward.

A division of:

W I T H DUAL TI L T K I T

Lorem ipsum dolor sit amet, consectetur

adipiscing elit. Nunc euismod suscipit tellus,

sit amet posuere sapien fringilla ac. Morbi

metus risus, molestie a sagittis et, tincidunt

adipiscing purus. Lorem ipsum dolor sit

amet, consectetur adipiscing elit. Nunc

euismod suscipit tellus, sit amet posuere

sapien fringilla ac. Morbi metus risus,

molestie a sagittis et, tincidunt adipiscing

purus.