ATM PM-BAND-20S Installation Guide

PoleStarTM PM-BAND-20S

Band Kit for 2” to 6” Dia. Poles and Columns
Installation Instructions

Thank you for choosing the PoleStar

banding strap is designed to attach the PoleStar

Important:
Mounting overhead system requires experienced professionals. Improperly installed
equipment can result in property damage, personal injury, death and/or liability to the
installing contractor. Do not install if in doubt about the integrity of the mounting structure.

Caution: Due to the wide variety of mounting structures, environments, materials and mounting
methods, these instructions assume that the installing contractor will exercise good judgment in
selecting the proper mounting area and hardware.

Follow these instructions for the most efficient and safest mounting results. Do not
exceed the working load limit of 150 lbs/68 kg.

Caution: Use care in uncoiling and applying strap.

Package Contents:
Qty Description

2 pcs PM-BAND-20S Housing
2 pcs PM-BAND-20S Racks
2 pcs PM-BAND-20S 20” long banding strap
1 pc Instruction Sheet

Step 1

Insert one end of the strap into the rectangular slot of the housing then fold
at least one inch long or longer (a longer fold creates a more effective lock
then flatten band using thumb to form a hook. The folded end should be on
the opposite side of the housing’s screw head (Figure 1).

Step 2

Insert the end of the rack into the housing and rotate screw head clockwise
using a screw driver until 3/4” of the rack comes out on the other end of the
housing (Figure 2). MAKE SURE THAT THE WORD “THIS SIDE UP”
WRITTEN ON THE RACK FACING OUT.

Step 3

Insert the other end of the band through the slots of the PM-MOUNT­6DOWN and out on the other side. Wrap the band snugly around the pole
until the end reaches rectangular slot of the rack (Figure 3).

Step 4

Measure, mark and cut the band at least one inch beyond the first
serration of the rack, then bend at least a one inch hook toward underside
of band (Figure 4 & 5).

Step 5

Insert the hook into the rectangular slot of the rack, if necessary loosen the
rack from the housing. Flatten band with thumb to form a clamp (Figure 5).

Step 6

TM

PM-Band-20S Kit. This all weather, stainless steel

TM

Pole Adapters to 2” dia. to 6” dia. poles.

)

Figure 1:

Figure 2:

© 2008 ATM FLY-WARE Signal Hill, CA 90755 USA [phone] 021408

Position the location of the PM-MOUNT-6DOWN on the pole and then tighten
screw using screw or wrench to desired tension and complete the banding
operation (Figure 6).

Step 7

Repeat steps 1 to 6 for the lower banding strap assembly (Figure 6).

Step 8 Recommendation

Always use a safety cable from the speaker to a structurally safe anchor point
(Refer to PM-SAFETY-6DOWN for Safety Cable Anchor Point System).

Note: Optional
To strengthen banding strap use two straps on each slot of the PM­MOUNT-6DOWN

Figure 3:

Figure 5:

Figure 4:

Figure 6:

© 2008 ATM FLY-WARE Signal Hill, CA 90755 USA [phone] 021408