Atlas Metal VGG7-2T User Manual
Self service food shields
be 3/4 of the Max. vertical distance of 5.35.7.1 (.75 x 13” = 9.75”)
5.35.7.3
locations shell be 2 inches
5.35.7.10
The minimum height of the vertical barrier shall be equal to the overall height of the foodshield.
lower than the overall height of the foodshield.
Multiple tier food shields
5.35.9.1
VGG7-2T
Protected by US Patent #D610,376
Self-Service Protector
2-Tier
FINISH:
Clear Anodized Aluminum
Powder Coat:
Black Silver
RAL#
GLASS (Clear Tempered):
3/8" Front - Std 1/2" Front
3/8" Top - Std
1/2" Top
Frosted
LENGTHS:
-2 = 35-1/4" O.A. - 1 Section
-3 = 49" O.A. - 1 Section
-4 = 62-3/4" O.A. - 1 Section**
-5 = 76-1/2" O.A. - 2 Sections
-6 = 90-1/4" O.A. - 2 Sections
Custom = ___________ O.A.
NSF/ANSI 2 - 2010 Standards Requirements:
This language is copied with permission of NSF International
5.35.7
Maximum vertical distance between counter top and bottom leading edge of shield shall be 13 inches
5.35.7.1
Minimum horizontal distance between the front inside edge of food and bottom leading edge of shield shall
5.35.7.2
The sum of a shield’s projected vertical plane (Y) and projected horizontal plane (X) shall be greater than or
equal to 20 inches. Either (X) or (Y) may equal 0
Maximum horizontal distance between vertical, horizontal, and angled panels at post and framing member
5.35.7.5
Food shields for use on mobile buffet counters shall conform to 5.35.7
A vertical barrier (end shield) shall be provided at each end of a foodshield. The vertical barrier shall be
5.35.6
a minimum of 18 inches deep (front to back) beginning at the bottom leading edge of the foodshield.
The maximum distance from the bottom edge of the vertical barrier and counter top shall be 1.5 inches.
A foodshield intended to be installed a maximum of 3" (76mm) from a building wall perpendicular to the
5.35.6.1
foodshield is exempt from the requirements of 5.35.6 provided that the height of the building wall is not
5.35.9
A self service foodshield over the bottom tier shall conform to 5.35.7
All tiers above the bottom tier shall have a permanent attached label restricting use to wrapped or packaged
5.35.9.2
serving portions.
(*) Not all options available on all models.
Contact Factory for specific information.
For Mounting Options, see Mounting
Specification Sheet
PROTECTORS WITH LIGHTS AND/OR
WARMERS REQUIRE (2) END PANELS
(2) End Panels per unit unless
otherwise specified. End panels
are 1/4" clear tempered glass
unless otherwise specified.
T1
L
L1*
L2
( * - Middle support is centered unless L1 dimension is specified )
( ** - 1/2" Clear Tempered Glass Top Panel )
- Centerline Dimensions L / L1 - 60" Max (3/8" Glass)
- 66" Max (1/2" Glass)
T1 - 96" Max in Single Section
03/11/2011
21 3/8
9 1/4
19 15/16
13 1/2
8 3/16
25 1/4
13 1/8
13 7/16
Loading...