Atlas Metal VGG5F-2T User Manual

5.35.7.3

locations shell be 2 inches

5.35.7.10

lower than the overall height of the foodshield.

5.35.9.1

VGG5F-2T

Protected by US Patent #D610,374

Self-Service Protector

2-Tier

FINISH:

Clear Anodized Aluminum

Powder Coat:

Black Silver

GLASS (Clear Tempered):

3/8" Top - Std

1/2" Top

Frosted

RAL#

LENGTHS:

-2 = 35-1/4" O.A. - 1 Section

-3 = 49" O.A. - 1 Section

-4 = 62-3/4" O.A. - 1 Section**

-5 = 76-1/2" O.A. - 2 Sections

-6 = 90-1/4" O.A. - 2 Sections Custom = ___________ O.A.

NSF/ANSI 2 - 2010 Standards Requirements:

This language is copied with permission of NSF International

5.35.7

Self service food shields

Maximum vertical distance between counter top and bottom leading edge of shield shall be 13 inches

5.35.7.1

Minimum horizontal distance between the front inside edge of food and bottom leading edge of shield shall

5.35.7.2

be 3/4 of the Max. vertical distance of 5.35.7.1 (.75 x 13” = 9.75”) The sum of a shield’s projected vertical plane (Y) and projected horizontal plane (X) shall be greater than or equal to 20 inches. Either (X) or (Y) may equal 0 Maximum horizontal distance between vertical, horizontal, and angled panels at post and framing member

5.35.7.5

Food shields for use on mobile buffet counters shall conform to 5.35.7

A vertical barrier (end shield) shall be provided at each end of a foodshield. The vertical barrier shall be

5.35.6

a minimum of 18 inches deep (front to back) beginning at the bottom leading edge of the foodshield. The minimum height of the vertical barrier shall be equal to the overall height of the foodshield. The maximum distance from the bottom edge of the vertical barrier and counter top shall be 1.5 inches. A foodshield intended to be installed a maximum of 3" (76mm) from a building wall perpendicular to the

5.35.6.1

foodshield is exempt from the requirements of 5.35.6 provided that the height of the building wall is not

5.35.9

Multiple tier food shields

A self service foodshield over the bottom tier shall conform to 5.35.7 All tiers above the bottom tier shall have a permanent attached label restricting use to wrapped or packaged

5.35.9.2

serving portions.

(*) Not all options available on all models. Contact Factory for specific information. For Mounting Options, see Mounting Specification Sheet

NOTE:

VGG5F-2T - FL6.5-A IS ONLY

MOUNTING FLANGE AVAILABLE

(2) End Panels per unit unless otherwise specified. End panels are 1/4" clear tempered glass unless otherwise specified.

- Centerline Dimensions L / L1 - 60" Max (3/8" Glass)

- 66" Max (1/2" Glass) T1 - 96" Max in Single Section

21 3/8

L1*

6 7/16 10 9/16

21 3/4

13 3/8

( * - Middle support is centered unless L1 dimension is specified )

/31

/2013