Atlas Metal PTR-88 Parts List

Subsidiary of Mercury Aircraft, Inc.
1135 N.W. 159th DR., MIAMI, FL 33169
PHONE (305) 625-2451, (800) 762-7565, FAX (305) 623-0475, E-mail: sales@atlasfoodserv.com
PARTS LIST-PIZZA PREPARATION TABLE
PTR SERIES
1
2
16
14
15
ITEM
NUMBER
1
2 90-9900 Lid Cover Bracket 3 S83440-0 Insert Side 4 S83442-0 End Dividers
5
6 6053-8 Hinge & Cover 7 S81452-0 Door Assembly 8 6055-1 Slam Action Latch
9 S81407 Plastic Door Back 10 97-104 Door Gasket 11 113-5 Thermometer 12 1069-1 Front Switch
13
14 S84053-0 End Grill (PTR-68 & PTR-88) 15 6012-11 Casters with Brakes 16 6012-10 Casters without Brakes
17 S84052-0
18 S81454-0 Tray Rack Assembly (Not Shown) 19 69-973 Wire Shelf (Not Shown) (PTR-68 & 88) 20 22-1406 Thermostat for Base (Not Shown) 21 22-1397 Thermostat for Rail (Not Shown)
PART
NUMBER
DESCRIPTION
S83562-0 Lid Assembly (PTR-68 & PTR-88)
S21951-0 Lid Assembly (PTR-88)
9017-0 Thermoplastic Cutting Board (PTR-68) 9018-0 Thermoplastic Cutting Board (PTR-88)
S84051-0 Front Grill (PTR-68) S84050-0 Front Grill (PTR-88)
Back Grill (PT-68 & PT-88)
(Not Shown)
3
4
5
6
7
8
10
11
12
13
ITEM NUMBER
PTR-68 SHOWN
PART
NUMBER
DESCRIPTION
22 2060-1 Cond. Water Evaporator (Not Shown)
23
24
25
26
1149-0 Wire Hamess (Double) (PTR-88) (Not Shown) 1150-0 Wire Hamess (Single) (PTR-68) (Not Shown)
2029-3
2002-4
2029-6
1/4 H.P. Compressor (PTR-68 Base)
(Not Shown)
1/3 H.P. Compressor (PTR-88 Base)
(Not Shown)
1/3 H.P. Compressor
(PTR-68 & PTR-88 Top Rail) (Not Shown)
100-1004 Power Cord (PT-68) (Not shown)
1006-2 Power Cord (PT-88) (Not Shown)
2025-0 Drier (Base)
2024-0 Drier (Top Rail) 27 2026-0 .042 Cap. Tube (Base) 28 494-54 1/4 Expansion Valve (Not Shown) 29 2013-0 Fan Motor (Not Shown)
30
S81441-0 Fan Guard (Not Shown) (PT-68)
S51529-0 Fan Guard (Not Shown) (PT-88) 31 2014-5 Fan Blade (Not Shown) 32 S81419-0 Fan Bracket (Not Shown)
33
2119-0 Evap. Coil (PTR-68 Base) (Not Shown)
2020-1 Evap. Coil (PTR-88 Base) (Not Shown) 34 6151-6 Pilaster (Not Shown) 35 6151-1 Snap-In Shelf Support (Not Shown)
PIZZA PREPARATION TABLE WITH RECESSED TOP
PTR SERIES
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------
OPERATION
Location of the unit is important. There must be adequate ventilation for the compressors. A minimum clearance of 6 inches must be provided at the vent locations on the side and front of the unit. The supply cord is accessible through the end grill, which pulls out. Extend the cord completely, snap grill back into place and plug into a proper outlet (see chart below).
These units are equipped with two (2) compressors and two (2) thermostats. The thermostat controlling the top cold rail is located in the compressor compartment and the thermostat that controls the bottom rail is located on the blower housing inside the refrigerator compartment. The thermostats have an off position and numbers from 1 through 7 (number 7 is the coldest). The top condiment rail should be defrosted at least once a week by turning the thermostat to the off position.
DO NOT STORE ANY FOODS IN CONDIMENT RAIL WHILE DEFROSTING.
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------
MODEL NUMBER AMPS
PTR-68 12.6 5-20P
PTR-88 15.5 5-20P
NEMA PLUG
MAINTENANCE
NEVER CLEAN THE UNIT WITH A CHLORIDE BASED PRODUCT. CHLORIDES OR IMPROPER CLEANING COULD SCARE, MARK AND/OR CORRODE METAL. DO NOT ABRASIVE PRODUCTS. TO CLEAN USE SOAPY WARM WATER, RINSE RESIDUE THOROUGHLY.
FAILURE TO MEET THESE CONDITIONS WILL VOID WARRANTY. CLEAN CONDENSER COIL REGULARLY.
USE STEEL WOOL OR
Loading...