Atlas Metal LTM-2736-ME User Manual
MISCELLANNEOUS PRODUCTS
AUTO-LIFT
TABLE
Mobile - 500 lb. capacity
Quantity Item No.
DESCRIPTION
The Auto-Lift Table is the perfect match of mobility and stability for holding heavy slicers, mixers,
grinders, or choppers. The table functions as a
mobile stand and when the legs are extended,
has the strength and stability of a regular fixed
work table. Save the expense of extra equipment
when one unit can be rolled to several locations.
Fully welded, all stainless steel construction, this
unit provides years of trouble free service. The
control handle is conveniently located on the
table apron and with a few turns, can easily lift up
to 500 pounds.
LTM-2736-ME
FEATURES
Rugged all stainless steel construction
Unique telescoping leg assembly
500 pound lift capacity
Economical - saves on the expense of extra equipment
LTM-2736-ME
a subsidiary of Mercury Aircraft
1135 NW 159 Dr., Miami, Florida 33169
Tel: (305) 625-2451 or (800) 762-7565 • Fax: (305) 623-0475
MP-5
AUTO-LIFT TABLE
30 1/2”
36”
PLAN VIEW
LTM-2736-ME
34 5/8”
FRONT ELEVATION
TOP: Constructed of 14 gauge, type 304
stainless steel with coved corners, fully
welded, ground and polished to a uniform
finish. Top is fabricated with a /8” raised
marine edge on al sides and is removable
for access to the lift mechanism.
CHASSIS: Constructed of structural steel
angle frames, welded to four stainless steel
legs to support the lift mechanism. A double, 7” high apron, constructed of 18 gauge
stainless steel shall surround the perimeter
immediately below the top to enclose and
protect the lift mechanism.
LEGS: Telescoping legs are constructed of
16 gauge stainless steel tubing - outer
sleeves to be 17/J diameter; inner legs to
be 1/6” diameter. Inner legs are provided
with adjustable bullet feet.
LIFT MECHANISM: The unit shall be
equipped with a mitre gear box (controlled
END VIEW
LEGS RETRACTED
SPECIFICATIONS:
by a composition plastic control wheel
mounted in the apron. The gear box is supported by a 6” x 11/2” x /,e” structural steel
channel, welded to the top frame and
securely fastened to the top by “X” shaped,
V2” thick structural steel cross bars for
even weight distribution. Maximum lift
capacity is 500 pounds.
BOTTOM SHELF: Constructed of 18 gauge,
type 304 stainless steel with structural steel
underbracing, fully welded to the table
legs.
CASTERS: N.S.F. approved, 5” diameter,
non-marking rubber tired wheels with
swivel plate.
Specifications subject to change without notice.
END VIEW
LEGS EXTRACTED
ACCESSORIES:
Locking brakes (set of 2)
Slides for 18 x 26 trays (4 sets - 4-1/8”
spacing) with stainless steel enclosure
on two sides
Utensil rack
3” high roll rim top with drain
36 1/2”
MP-6
a subsidiary of Mercury Aircraft
1135 NW 159 Dr., Miami, Florida 33169
Tel: (305) 625-2451 or (800) 762-7565 • Fax: (305) 623-0475
10/07-SC
Loading...